The following are the impulse responses of discrete-time LTI systems. Determine whether each system is causal and/or stable. Justify your answer. Answers without justification will be assumed to be guesses and receive no credit. (a) hịn] = (1/5)"u[n] (b) hịn] = (0.8)" u[n + 2] %3D (c) h[n] = (1/2)"u[--n)

The following are the impulse responses of discrete-time LTI systems. Determine whether each system is causal and/or stable. Justify your answer. Answers without justification will be assumed to be guesses and receive no credit. (a) hịn] = (1/5)"u[n] (b) hịn] = (0.8)" u[n + 2] %3D (c) h[n] = (1/2)"u[--n)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The impulse response for a single input and single output linear system is given as ?(?, ?) = sin (2? - 3−2?) / 2? - 3−2?. So what is the output of the system for ? (?) = ? (?), ? (?) = ? (? - 1) and ? (?) = ? (? - 2)?
3. A causal discrete-time LTI system is described by y[x] -ln - 1] +ln – 2] = x[n] where x[n] and y[n] are the input and output of the system, respectively (a) Determine system transfer function H(2) (b) Find the impulse response h[n] of the system.
Given the impulse response h[n]=99.3n.cos(41.4π.n/25)u[n] Is the system Causal and/or Stable?
A DSP system is described by the following differential equation with zero initialcondition:y(n)+0.1y(n-1)-0.2y(n-2) =x(n)+x(n-1)a. Determine the impulse response y(n) due to the impulse sequence x(n) = (n).b. Determine system response y(n) due to the unit step function excitation, where u(n)= 1 for n  0.
Determine the impulse response h[n] for the system specified by the equation: y[n] - 6y[n-1] + 25y [n-2] = 2x[n] -4x[n-1]
Assuming that the LTI system shown in the figure below is non-causal: (i) Specify the ROC. (ii) Is this system stable? (iii) Determine the impulse response of the system.
the first order difference equation y[n]-ay[n-1]=x[n],0<a<1,describes a particular discrete-time system intially at rest. (a)verify that the impulse response h[n] for this system is h[n]=anu[n]. (b)is the system 1.memoryless? 2.casual? 3.stable? claearly state your reasoning (c)is the system stable if |a|>1?
Consider the causal, discrete-time LTI system described by the difference equation in the attached picture. (a.) Find the impulse response of the inverse system h−1 [n] that satisfies H(Ω)H−1 (Ω) = 1. Is the inverse system causal?
Determine the pole-zero plot of the impulse response of a single pole causal LTI system below.
A system is described as: w (n + 1) = 0.5 w(n) — x(n) y(n) = w (n) - x(n) Where x(n) and y(n) are input and output signals, respectively. 1. Draw a block diagram or signal flow graph representation for this system by using Direct form II 2. Find the system function H(z) and the impulse response h(n) of this system. 3. Is this system causal or not? Why? 4. Is this system stable or not? why? 5. If the input impulse Dirac 8 find the difference equation.
(Recall that the step response s[n ] of a system is its output when the unit step u[n] is applied as input.)If the step response of an LTI system is s[n] = delta[n ] + 2delta[n – 2],then it’s impulse response h[n] at times n ∈{0, 1, 2, 3} must be: h[0] =?h[1] =?h[2] =?h[3] = ?
It is observed that when x[n]=u[n] input is applied to a discrete-time LZD system, y[n]=2(1/3)nu[n] output is obtained. If an input signal x1[n]=(1/2)nu[n] is applied to this system, find the output signal y1[n] and the impulse response (h[n]) of the system.