The following equality gives S₁ in terms of Z-Parameters for a 2-port network. • Show all steps in deriving the equality. When applicable, state any assumptions / conditions that are needed for the step of the derivation. . (Z₁1 − Zo) (Z22 + Zo) – Z₁2²21 = (Z₁1 + Zo) (Z22 + Zo) - Z₁2²21 S₁₁=

Q: Find the step response of the system whose impulse respose is given as h(t) = u(t+1)-u(t-1).

A:

Q: Two 6600/250-V transformers have the following short-circuit characteristics: Applied voltage 200 V,…

A:

Q: The bandwidth is the frequency band between half-power frequencies: B = W₂ W1

A: why the bandwidth is the frequency band between half power frequencis: B=w2-w1 So we have to Prove…

Q: For each of the transfer functions shown below, find the locations of the poles and zeros, plot them…

A: The location of pole and zero can be obtained by equating the numerator and denominator part to zero…

Q: 3.5 50 V 30 ΚΩ Obtain v. in the circuit of Fig. 3.54. using mesh analysis! + 120 ΚΩ www 120 V (+ 120…

A:

Q: Consider the RC circuit shown in figure. Find the following: (a) The governing differential equation…

A: Given circuit,

Q: 2.11 Given x(t) as drawn in the figure, sketch and label each of the following signals: ~ -1 (a)…

A: Note: As per the policy we can solve only 3 sub-parts, please re-upload the remaining part as a…

Q: 1. Which of these is incorrect for an operational amplifier?

A: The correct option along with the explanation is provided in the following section.

Q: A pulse code modulated system has 8 bits per sample. What is the number of levels present in the…

A: Given information: The number of bits transmitted per sample is 8.  The number of levels present in…

Q: In a balanced delta connected 3Ø circuit, the load in each branch consists of a 10 Ω resistance in…

A: Given data :  The load in each branch consists of a 10 Ω resistance in series with an inductance…

Q: What shunt resistance should be connected in parallel with an ammeter having a resistance of 0.040…

A: According to the given statement, An ammeter with resistance of 0.04 ohm is connected in parallel…

Q: 1. Which of the following is not an electronic device? a) A mobile b) A computer c) A magnifying…

A: The solution is provided in the following section.

Q: 2. Complete the timing diagram of Q and Q' of the following circuit for the given inputs. Neglect…

A: A logic gate is a component used to construct digital circuits. They carry out fundamentally…

Q: write the necessasity of estimation and costing

A: Necessity of estimation and costing: Administration Approval/Decision to Proceed in Principle: To…

Q: 12-17. Determine the frequencies for electromagnetic waves with the following wavelengths: 5 c 50…

A:

Q: the stator of 3 phase induction motor has 3 slots per pole per phase .if supply frequency is…

A: Given data, No. of phases (u)=3 Frequency f= 50 Hz Slots per pole per phase= 3

Q: 3. Simplify the block diagram below. Then, obtain the closed-loop transfer function C/R. R S+1 S S+2…

A:

Q: enumerate at least 3 uses of coils/inductors.

A: The objective is to determine the use of coil and inductor.

Q: Factor to obtain a product of sums: (c) AB+ A'B'C + B'C'D + BC'D' (d) A'C'D + AB'D' + A'CD' + BD (e)…

A: It is given that: c) AB+A'B'C+B'C'D+BC'D'd)A'C'D+AB'D'+A'CD'+BDe)WXY+WX'Y+WYZ+XYZ'

Q: se the best statement that explains why a constant magnetic field cannot do work on a mov O The…

A: The fact that magnetic force do no work is an elementary and direct consequence of the Lorentz force…

Q: Question 6 a) Obtain the transfer function for the block diagram shown, by using the signal flow…

A: Given The block diagram shown is,

Q: 1. Which of the following is not an electronic device?

A: The correct option along with the explanation is provided in the following section.

Q: Simplify the following Boolean expressions to a minimum number of literals: ( yz ′ + x ′ w ) ( xy ′…

A: It is given that: A=(yz'+x′w)(xy′+zw′)

Q: Prove that a two-input multiplexor is also universal by showing how to build the NAND (or NOR) gate…

A: The multiplexer can be called as universal gate and by using the mux we can design any logic gates.

Q: Consider the following. (LetC₁ = 28.40 μF and C₂ = 22.40 μF.) 6.00 μF C₂ + 9.00 V C₁ (a) Find the…

A: Given a circuit with C1=28.40 micro Farad , C2=22.40 micro Farad

Q: Simplify the following Boolean expressions, using three variable K-maps: F(x,y,z)=x′y′+yz+x′yz′

A:

Q: A pulse code modulated system has 8 bits per sample. What is the number of levels present in the…

A: Given: The number of bits transmitted per sample 8

Q: If the power level of an amplifier reduces to half, the db gain will fall by (i) 0.5 db (ii) 2 db…

A: Given, Power level of an amplifier is reduces to half.

Q: What type is a suitable electrical vehicle based on power systems and machines for human…

A: It is asked which is most suitable electrical vehicle based on power systems and machines for human…

Q: 5. For the following circuit, complete the timing diagram for the output (Y). Neglect hold time and…

A: A D Flip Flop is a type of digital electrical circuit that delays the state change of its output…

Q: 10 μF 120 k 68 102 0.01 μF 12 V + 310 10 uF %10 Z 8-140, 7-30 k

A: In transistor configuration the dc collector feedback configuration is used to increase the…

Q: Question 6 a) Obtain the transfer function for the block diagram shown, by using the signal flow…

A: Given data, The block diagram is

Q: Determine the stability of system: S³+ S² + S +4 (a) Absolutely stable (b) Critically stable (c)…

A: Given the system characteristics equation, s3+s2+s+4=0

Q: Can you please describe the following: 1.) n-Channel JFET 2.) p-Channel JFET 3.) n-Channel…

A:

Q: Explain each option & Choose the correct option. 4) The _ calculated load is rarely placed on an…

A: Aim To solve the three mcqs along with the necessary reason::

Q: evaluate the size of conductor for overhead transmission lines

A: In the past, copper was frequently used as a conductor for transmission lines, but aluminum…

Q: Determine the characteristic impedance for an air-dielectric transmission line with a D/r ratio of…

A: For the given question, We have, Dr=6.8Zo=?

Q: 2) Write down the specification and types of insulators used in transmission line

A: The electrical insulator is a device that provides the required insulation between the line…

Q: -The output of the op amp is - O 0.1 V o - 0.1 V o 10 V 0-10 V 21 V 2.0 V 10 V -10 V Output

A: Given the opamp circuit, Inverting terminal voltage, v-=2 V Non-inverting terminal voltage, v+=2.1…

Q: 3.5 60 V Obtain v, in the circuit of Fig. 3.54. using mesh analysis! + 120 ΚΩ 120 V (+ 120 ΚΩ + vo

A: Given data, Circuit diagram is given as,

Q: differentiate between overhead service connection and under ground service connection with sketch

A: Overhead Service Connection:- Electric locomotives, trolleybuses, and trams receive their electrical…

Q: (II) (a) If the resistance of the resistor in Fig. 21–60 is slowly increased, what is the direction…

A: The given figure is shown below:

Q: circuit. Use the nodal analysis to find the branch current i₁, and node voltages, v₁, and v₂ in the…

A: The required parameters can be calculated by applying kirchhoff's current law to the circuit.

Q: R 1. Reduce the block diagram below into single transfer function. G₁ G₁ G₂ H₁ H₂ G₂ +

A:

Q: What would be the maximum cost of a CFL such that the total cost (investment plus operating) would…

A: Given data, The power P is 60W, The time 1000 hour, The cost of  incandescent bulb is 25 cents

Q: 15-19. Determine the directivity in decibels for an antenna that produces a power density P = 4…

A:

Q: xplain substation earthing with diagram

A: Substation earthing: Any substation's earthing system's primary function would be to dissipate short…

Q: DIRECTIONS: Draw the following sinusoidal waveforms: 1. e= 220sin(ωt -500) 2. i = -30 cos (ωt + π/4)…

A:

Q: 4. Which of the following is the correct relationship between temperature (T) and mobility (u) of…

A: The correct option along with the explanation is provided in the following section.

Q: Table 3: Summing Amplifier Measurements c component) ac component) (de component) Table 4: Summing…

A: The Superposition theorem states that, for any linear system, the voltage or current in any branch…

Current Division Method

The generalized current divider formula is given by the following relation below,