The homogeneous cylinder of weight 150 N is placed on an inclined surface of negligible friction. The cylinder is prevented from moving by the vertical rod "BD", which is connected to the center of the cylinder by a rope. Assuming no sufficient friction between the bar and the cylinder. Determine the tensile force of the rope.

The homogeneous cylinder of weight 150 N is placed on an inclined surface of negligible friction. The cylinder is prevented from moving by the vertical rod "BD", which is connected to the center of the cylinder by a rope. Assuming no sufficient friction between the bar and the cylinder. Determine the tensile force of the rope.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.37P: The 40-kg homogeneous disk is resting on an inclined friction surface. (a) Compute the magnitude of...

See similar textbooks

Similar questions

The homogeneous plate of weight W is supported by a ball-and-socket joint at D and three wires. Draw the FBD of the plate and count the unknowns.
The device shown is an overload prevention mechanism. When the force acting on the smooth peg at D reaches 1.2 kN, the peg will be sheared, allowing the jaws at C to open and thereby releasing the eye-bolt. Determine the maximum value of the tension P that can be applied without causing the eyebolt to be released. Neglect friction.
The homogeneous 240-lb bar is supported by a rough horizontal surface at A, a smooth vertical surface at B, and the cable BC. Draw the FBD of the bar and count the unknowns.
The 40-lb spool is suspended from the hanger GA and rests against a vertical wall. The center of gravity of the spool is at G and the weight of the hanger is negligible. The wire wound around the hub of the spool is extracted by pulling its end with the force P. If the coefficient of static friction between the spool and the wall is 0.25, determine the smallest P that will extract the wire.
The homogeneous plate of weight W is suspended from two cables. Determine the force P that is necessary to keep the plate in the position shown.
The 40-kg homogeneous disk is resting on an inclined friction surface. (a) Compute the magnitude of the horizontal force P. (b) Could the disk be in equilibrium if the inclined surface were frictionless?
Determine the largest force P for which the 16-kg uniform bar remains in equilibrium.
Two identical chairs, each weighing 14 lb, are stacked as shown. The center of gravity of each chair is denoted by G. The coefficient of static friction is 0.2 at B (the contact point between the chairs) and 0.35 at A, C, and D. Determine the smallest force P that would cause sliding.
The spring attached to the homogenous bar of weight W is undeformed when =0. Determine the smallest spring stiffness k for which the =0 equilibrium position will be stable. Use W = 10 lb, a = 24 in., and b = 6 in. Assume that the spring remains horizontal, which is a valid approximation if is small.
Determine the horizontal force P that would keep the uniform 12-kg rectangular plate in the position shown.
the homogeneous cylinder of weight W=100 N rests in a frictionless right angled corner. determine the contact forces NA and NB angle is 30 degrees
Determine whether the block shown is in equilibrium and find the magnitude and direction of the friction force when θ=25° and P=750 N.