The LRT trolley system 10 miles ling is fed by two substations that generate 600 volts and 500 volts, respectively. The resistance of the trolley wire and the rail return is 0.3 ohm per mile. If the car is located 4 miles from the 600-volt station draws 200 A from the line. How much is the current supplied by each station?

The LRT trolley system 10 miles ling is fed by two substations that generate 600 volts and 500 volts, respectively. The resistance of the trolley wire and the rail return is 0.3 ohm per mile. If the car is located 4 miles from the 600-volt station draws 200 A from the line. How much is the current supplied by each station?

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter19: Special-purpose Outlets-water Pump, Water Heater

Section19.2: Water Heater Branch Circuit

Problem 17R: a. If both elements of the water heater in this residence are energized at the same time, how much...

See similar textbooks

Similar questions

The LRT trolley system 10 miles long is fed by two substations that generate 600 volts and 560 volts, respectively. the resistance of the trolley wire and rail return is 0.3 ohm per mile. if the car located 4 miles from the 600-volt station draws 200A from the line, how much is the current supplied by each station?
The LRT trolley system 10 miles long is fed by two substations that generate 600 volts and 560 volts, respectively. The resistance of the trolley wire and rail return is 0.3 ohm per mile. If the car is located 4 miles from the 600 volt station draws 200 A from the line. How much is the current supplied by each station?
The minimum number of outdoor receptacles for a residence is __________, NEC __________. State the location. __________
(c) Sketch a circuit diagram of a complete power conversion circuit that would be used to connect a solar PV array to the grid. Briefly describe its operation, including mention of the types of power electronic switches that might be used along with their voltage/current ratings. Please solve this with in 1 hour
Take a look at the wire supplying your house, another residential house, commercial and industrial buildings in your locality, count how many wires are connected to the building (from the electric meter to the weather head OR the service drop itself)? Are the wires different from each other? If so, why?
when calculating a dwelling lighting load on the "volt-ampere per ft2" basis, the receptacle load used for floor lamps, table lamps, and so fourth
Calculate the voltage drop of a 120/240-volt, three-wire underground residential service installed with 2 AWG aluminum URD cable if the load is 80 amps and the one-way length of the underground service conductors is100 feet.
Calculate the voltage drop of a 120/240 volts, three wire underground residential service installed with 2 AWG aluminum URD cable if the load is 80 amps and the one way length of the underground service conductor is 100 feet.
small appliance receptacles included in the 3 volt-ampere per square foot load calculation
How does the amount of leaking electricity consumption compare with the total amount of electricity used in your household? Can you think of ways to reduce the leaking (stand-by) electricity use?
Current shown in the circuit???
What is the smart grid?