. The magnetic field of a cylindrical magnet that has a pole-face diameterof 3.3 cm can be varied sinusoidally between 29.6 T and 30.0 T at afrequency of 15 Hz. At a radial distance of 1.6 cm, what is the amplitude ofthe electric field induced by the variation?1.5 V/mO 0.15 kV/mO None of them0.30 V/m150 N/C15 N/CO 0.15 V/m

Answered: Image /qna-images/answer/d19028ea-776f-4b66-b99c-b7637d9fca4b.jpg

The magnetic field of a cylindrical magnet that has a pole-face diameter of 3.3 cm can be varied sinusoidally between 29.6 T and 30.O T at a frequency of 15 Hz. At a radial distance of 1.6 cm, what is the amplitude of the electric field induced by the variation? 1.5 V/m 0.15 kV/m O None of them 0.30 V/m O 150 N/C 15 N/C

The magnetic field of a cylindrical magnet that has a pole-face diameter of 3.3 cm can be varied sinusoidally between 29.6 T and 30.O T at a frequency of 15 Hz. At a radial distance of 1.6 cm, what is the amplitude of the electric field induced by the variation? 1.5 V/m 0.15 kV/m O None of them 0.30 V/m O 150 N/C 15 N/C

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 92CP: A time-dependent uniform magnetic field of magnitude B(t) is confined in a cylindrical region of...

See similar textbooks

Similar questions

The magnetic flux through a metal ring varies with time t according to (B = at3 bt2, where (B is in webers, a = 6.00 s3, b = 18.0 s2, and t is in seconds. The resistance of the ring is 3.00 . For the interval from t = 0 to t = 2.00 s, determine the maximum current induced in the ring.
A flat loop of wire consisting of a single turn of cross-sectional area 8.00 cm2 is perpendicular to a magnetic field that increases uniformly in magnitude from 0.500 T to 2.50 T in 1.00 s. What is the resulting induced current if the loop has a resistance of 2.00 ?
Suppose the parallel-plate capacitor shown below is accumulating charge at a rate of 0.010 C’s. What is the induced magnetic field at a distance of 10 cm from the capacitator?
A conducting single-turn circular loop with a total resistance of 5.00 is placed in a time-varying magnetic field that produces a magnetic flux through the loop given by B = a + bt2 ct3, where a = 4.00 Wb, b = 11.0 Wb/s2, and c = 6.00 Wb/s3. B is in webers, and t is in seconds. What is the maximum current induced in the loop during the time interval t = 0 to t = 3.50 s?
100-turn square coil of side 20.0 cm rotates about a vertical axis at 1.50 103 rev/min as indicated in Figure P31.42. The horizontal component of the Earths magnetic field at the coils location is equal to 2.00 105 T. (a) Calculate the maximum emf induced in the coil by this Held, (b) What is the orientation of the coil with respect to the magnetic field when the maximum emf occurs?
The cross-sectional dimensions of the copper strip shown are 2.0 cm by 2.0 mm. The strip carries a current of 100 A, and it is placed in a magnetic field of magnitude B = 1.5 T. What are the value and polarity of the Hall potential in the copper strip?
An automobile with a radio antenna 1.0 m long travels at 100.0 km/h in a location where theEarth’s horizontal magnetic field is 5.5105T . What is the maximum possible emf induced in the antenna due to this motion?
A helicopter (Fig. P30.11) has blades of length 3.00 m, extending out from a central hub and rotating at 2.00 rev/s. If the vertical component of the Earths magnetic field is 50.0 T, what is the emf induced between the blade tip and the center hub? Figure P30.11
Two frictionless conducting rails separated by l = 55.0 cm are connected through a 2.00- resistor, and the circuit is completed by a bar that is free to slide on the rails (Fig. P32.71). A uniform magnetic field of 5.00 T directed out of the page permeates the region, a. What is the magnitude of the force Fp that must be applied so that the bar moves with a constant speed of 1.25 m/s to the right? b. What is the rate at which energy is dissipated through the 2.00- resistor in the circuit?
A time-dependent uniform magnetic field of magnitude B(t) is confined in a cylindrical region of radius R. A conducting rod of length 2D is placed in the region, as shown below. Show that the emf between the ends of the rod is given by dBdtDR2D2 . ( Hint: To find the between the ends, we need to integrate the electric field from one end to the other. To find the electric field, use Faraday’s law as “Ampere’s law for E”.)
Figure P23.15 shows a top view of a bar that can slide on two frictionless rails. The resistor is R = 6.00 , and a 2.50-T magnetic field is directed perpendicularly downward, into the paper. Let = 1.20 m. (a) Calculate the applied force required to move the bar to the right at a constant speed of 2.00 m/s. (b) At what rate is energy delivered to the resistor? Figure P23.15 Problems 15 through 18.
The magnetic flux through a metal ring varies with m time t according to B = at3 bt2, where B is in webers, a = 6.00 s-3, b = 18.0 s-2, and t is in seconds. The resistance of the ring is 3.00 . For i lie interval from t=0 to = 2.00 s. determine the maximum current induced in the ring.