The magnetic flux through the loop shown in the accompanying figure varles with time according to m- 8.00e-2 sin(150nt), where , is in milliwebers. What are the magnitude and direction of the current (In A) through the 5.00a resistor at the following times? 5.0 N (a) t-Os magnitude direction ---Select- (b) t- 2.17 x 10-2s magnitude A direction -Select- (c) t- 0.5 s magnitude A direction Select-

The magnetic flux through the loop shown in the accompanying figure varles with time according to m- 8.00e-2 sin(150nt), where , is in milliwebers. What are the magnitude and direction of the current (In A) through the 5.00a resistor at the following times? 5.0 N (a) t-Os magnitude direction ---Select- (b) t- 2.17 x 10-2s magnitude A direction -Select- (c) t- 0.5 s magnitude A direction Select-

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter12: Sources Of Magnetic Fields

Section: Chapter Questions

Problem 64P: A solenoid with an iron core is 25 cm long and is wrapped with 100 turns of wire. When the current...

See similar textbooks

Similar questions

Is Ampere’s law valid for all closed paths? Why isn’t it normally useful for calculating a magnetic field?
A metal bar of mass 500 g slides outward at a constant speed of 1.5 cm/s over two parallel rails separated by a distance of 30 cm which are pail of a U-shaped conductor. There is a uniform magnetic field of magnitude 2 T pointing out of the page over the entire area. The railing and metal bar have an equivalent resistance of 150 . (a) Determine the induced current, both magnitude and direction, (b) Find the direction of tire induced current if the magnetic field is pointing into the page, (c) Find the direction of the induced current if the magnetic field is pointed into the page and the bar moves inwards.
A 10-H inductor carries a current of 20 A. How much ice at 0ºC could be melted by the energy stored in the magnetic field of the inductor? (Hint: Use the value Lf= 334 J/g for ice.)
Two long, parallel wires cy equal currents in opposite directions. The radius of each wire is a, and the distance between the centers of the wires is d, Show that if the magnetic flux within the wires themselves can be ignored, the self-inductance of a length 1 of such a pair of wires is L 0 l in d1 a (Hint Calculate the magnetic flux through a rectangle of length 1 between the wires and then use L=N/I
A bar magnet falls under the influence of gravity along the axis of a long copper tube. If air resistance is negligible, will there be a force to oppose the descent of the magnet? If so, will the magnet reach a terminal velocity?
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
Is the work required to accelerate a rod from rest to a speed v in a magnetic field greater than the final kinetic energy of the rod? Why?
The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm apart. The system is in a uniform magnetic field of strength 0.75 T, which is directed into the page. The resistances of the rod and the rails are negligible, but the section PQ has a resistance of 0.25 . (a) What is the emf (including its sense) induced in the rod when it is moving to tire right with a speed of 5.0 m/s? (b) What force is required to keep the rod moving at this speed? (c) What is the rate at which work is done by this force? (d) What is the power dissipated in the resistor?
The accompanying figure shows a conducting ring at various positions as It moves througli a magnetic field. What is the sense of the induced em! for each of those positions?
A solenoid is wound with 2000 turns pet meter. When the cuiient is 5.2 A, what is the magnetic field within the solenoid?
Suppose you wish to produce 1.2-T magnetic field in a toroid with an iron core for which =4.0103 . The toroid has a mean radius of 15 cm and is wound with 500 turns. What current is required?
Consider the system pictured in Figure P28.26. A 15.0-cm horizontal wire of mass 15.0 g is placed between two thin, vertical conductors, and a uniform magnetic field acts perpendicular to the page. The wire is free to move vertically without friction on the two vertical conductors. When a 5.00-A current is directed as shown in the figure, the horizontal wire moves upward at constant velocity in the presence of gravity. (a) What forces act on the horizontal wire, and (b) under what condition is the wire able to move upward at constant velocity? (c) Find the magnitude and direction of the minimum magnetic Field required to move the wire at constant speed. (d) What happens if the magnetic field exceeds this minimum value? Figure P28.26