The metal sphere of surface area A, radius R, and volume V is subject to pressure P such that the radius decreases by 0.001R. Another sphere made from the same metal is subject to the same pressure. If the sphere has surface area 2A, by how much will the volume of the sphere change? a. -0.002V b. -0.003V c. -0.001V d. -0.004V

The metal sphere of surface area A, radius R, and volume V is subject to pressure P such that the radius decreases by 0.001R. Another sphere made from the same metal is subject to the same pressure. If the sphere has surface area 2A, by how much will the volume of the sphere change? a. -0.002V b. -0.003V c. -0.001V d. -0.004V

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter12: Fluid Dynamics And Its Biological And Medical Applications

Section: Chapter Questions

Problem 33PE: A small artery has a length of 1.1103 m and a radius of 2.5105 m. If the pressure drop across the...

See similar textbooks

Similar questions

An airplane has a mass of 1.60 104 kg, and each wing has an area of 40.0 m2. During level flight, the pressure on the lower wing surface is 7.00 104 Pa. (a) Suppose the lift on the airplane were due to a pressure difference alone. Determine the pressure on the upper wing surface. (b) More realistically, a significant part of the lift is due to deflection of air downward by the wing. Does the inclusion of this force mean that the pressure in part (a) is higher or lower? Explain.
A tank with a flat bottom of area A and vertical sides is filled to a depth h with water. The pressure is P0 at the top surface. (a) What is the absolute pressure at the bottom of the tank? (b) Suppose an object of mass M and density less than the density of water is placed into the tank and floats. No water overflows. What is the resulting increase in pressure at the bottom of the tank?
A large weather balloon whose mass is 226 kg is filled with helium gas until its volume is 325 m3. Assume the density of air is 1.20 kg/m3 and the density of helium is 0.179 kg/m3. (a) Calculate the buoyant force acting on the balloon. (b) Find the net force on the balloon and determine whether the balloon will rise or fall after it is released. (c) What additional mass can the balloon support in equilibrium?
An ideal fluid flows through a horizontal pipe whose diameter varies along its length. Measurements would indicate that the sum of the kinetic energy per unit volume and pressure at different sections of the pipe would (a) decrease as the pipe diameter increases, (b) increase as the pipe diameter increases, (c) increase as the pipe diameter decreases, (d) decrease as the pipe diameter decreases, or (e) remain the same as the pipe diameter changes.
, Water flows straight down from an open faucet (Figure 4.55). The cross-sectional area of the faucet is 1.8 10-4 ma, and the speed of the water as it leaves me faucet is 0.85 m/s. Ignoring air resistance, find the cross-sectional area of the water stream at a point 0.10 m below the faucet opening.
Small spheres of diameter 1.00 mm fall through 20C water with a terminal speed of 1.10 cm/s. Calculate the density of the spheres.
When two soap bubbles touch, the larger is inflated by the smaller until they form a single bubble. (a) What is the gauge pressure inside a soap bubble with a 1.50-cm radius? (b) Inside a 4.00-cm-radius soap bubble? (c) Inside the single bubble they form if no air is lost when they touch?
What effect does capillary action have on the reading of a manometer with uniform diameter? Explain your answer.
What fluid is in the device shown in Figure 11.29 if the force is 3.16103 N and the length of the wire is 2.50 cm? Calculate the surface tension and find a likely match from Table 11.3. Figure 11.29 Sliding wire device used for measuring surface tension; the device exerts a force to reduce the film's surface area. The force needed to hold the wire in place is F=L=(2l) , since there are two liquid surfaces attached to the wire. This force remains nearly constant as the film is stretched, until the film approaches its breaking point.
(a) Convert normal blood pressure readings of 120 over 80 mm Hg to newtons per meter squared using the relationship for pressure due to the weight of a fluid (P=hg) rather than a conversion factor. (b) Discuss why blood pressures for an infant could be smaller than those for an adult. Specifically, consider the smaller height to which blood must be pumped.
Small spheres of diameter 1.00 mm fall through 20C water with a terminal speed of 1.10 cm/s. Calculate the density of the spheres.
A small artery has a length of 1.1103 m and a radius of 2.5105 m. If the pressure drop across the artery is 1.3 kPa, what is the flow rate through the artery? (Assume that the temperature is 37° C.)