The mutual inductance coupling coefficient standard unit is ... * Ohm Henery Unit-less Mho

Q: What is Per Unit System? In the given picture, would there be any difference in calculation of the…

A: The per-unit value of any quantity is defined as the ratio of actual value in any unit to the base…

Q: Q/What is the effect of the length of the transmission line on the  Phasor measurement unit (PMU)…

A: - A phasor measurement unit (PMU) is a gadget used to gauge the greatness and stage point of an…

Q: What is load line and what is duty cycle?

A:

Q: Discuss basic character of smart grid

A: Smart grid is one type of the electrical grid that is used efficiently and able to integrate the…

Q: Describe the On-load and No-load in transformers

A: On-load in transformer Current flows through the secondary winding and out to the load when an…

Q: Derive the power angle equation for a power system network and draw the corresponding curve.

A: Power Angle Equation for a Power System Network: Suppose a synchronous machine is connected to an…

Q: Derive and analyse relation of capacitance for 3 core cables.

A: Three core cables are those cables in which all the three line conductors are arranged in the lines…

Q: PRELIMINARY QUESTIONS: 1) What is the phase angle between the phases in an ideal 3-phase system?

A: Bartleby has policy to solve only first question.  For rest questions re-upload them only.

Q: These transformers normally mounted on power poles or installed inside a large building near…

A: 1) Transformer is an electrical machine which step up step down the voltage without change in…

Q: explain the operating principle of single phase 2S-2P PMSM based on 3D design illustration.

A: According to the question, explain the operating principle of single-phase 2S-2P PMSM based on 3D…

Q: 2. When a large shunt capacitor is suddenly connected in parallel with the load bus in the…

A:

Q: The value of value of voltage measured in residential convenience outlet is average voltage. True…

A: Average value is the average of the signal over the period of time. Where as rms value of the signal…

Q: The value of symmetrical short circuit current is ___________________ at time t=0. Zero Minimum…

A: In this answer let us discuss the concept of short circuit current and try to find its value at t=0.

Q: Using Kirchhoff analysis, determine the initial current in each section along with its direction and…

A:

Q: Derive the equation of Capacitance per phase for the 3-phase double circuit line with hexagonal…

A: Let us assume that the p is very far from the system of conductor and at point P potential is almost…

Q: What are the advantages and disadvantages of Back To Back Test on Two Similar Single Phase…

A: When we require to test large transformer for determining their efficiency, temperature rise and…

Q: Mesh current method

A: Given circuit,

Q: The real and reactive powers scheduled at load buses are variable True False

A: We need to tell about real and reactive schedule power .

Q: Three conductors (bundles) each of GMR, - 6 mm are placed at the heads of an equilateral triangle…

A: In the question,  Individual GMR is given = 6mm Space between each group 10cm= 0.1m What is the…

Q: 6.6. In the power system network shown in Figure 6.5, bus 1 is a slack bus wi V = 1.020° per unit…

A: In this question we will use Gauss siedel method to determine voltage at bus 2 and S1 and power loss…

Q: The phase angle between magnetizing component current and core loss component current is 90° Select…

A:

Q: For minimum cost of power generation the generator limits are consider as inequality constraints…

A: for the economic power generation the value of the power generation by  the generator should be…

Q: Q2. Figure Q2 shows the single-line diagram. The scheduled loads at buses 2 and 3 are as marked on…

A: Note: We are authorized to answer three subparts at a time since you have not mentioned which part…

Q: 3. Find the capacitance per unit length of the single-phase line shown below. Conductors a, b, c are…

A: It is given that: ra=rb=rc=0.2cmrd=re=0.4cm

Q: In nominal-T method of medium transmission line what is the assumption about the capacitance

A: In a nominal T model of a medium transmission line, the series impedance is divided into two equal…

Q: -Derive and analyse relation of capacitance for 3- core cables [CLO-2,

A: Capacitance of 3 core cables: Let Cc be the capacitance between 2 cores and Ce between core and…

Q: Compare the effect of varying resistance, capacitance and inductance in parallel and series AC…

A: Note: circuit compenets are not specified. we assume following AC circuits RLC parallel circuit RLC…

Q: Each line of a 3-phase system given in figure is suspended by a string of 5 identical disks and the…

A:

Q: erives and analyse relation of capacitance for 3-core cables ? proper explanation in details

A: Capacitance of a 3 core cables Let Cc be the capacitance between 2 corea and Ce between core and…

Q: Draw the equivalent circuits of the lines by writing the impedance values in place as given in…

A: The equivalent circuit of a transmission line is nothing but the representation of a transmission…

Q: The power loss in an overhead transmission line would increases when the of the line is increases.…

A: The solution is given below

Q: Enlist the power quality issues for renewable energy integration

A: Renewable energy is also called green energy because it is generated from Energy resources which are…

Q: Define electronegative gases and Compare between SF6 and O2 Insulator? Explain the different schemes…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: Question - Compare the effect of varying resistance, capacitance and inductance in a pararllel and…

A: In this question   Compare the effect of varying resistance, capacitance and inductance in a…

Q: Why the Capacitance effect is neglected in Short Transmission

A: The explanation is as follows.

Q: define A. Microgrid B. Distributed generation C. Discuss the advantages and disadvantages of…

A: Given We need to define microgrid and distributed generation. We need to state advantages and…

Q: UDng a ITIe Core in high frequency transformers. c- Discuss, different applications of iron cores of…

A: C)For magnetizing or demagnetizing a iron material, some energy is expended. The energy expended…

Q: 2 - Derive in expression for the capacitance to neutral per phase per Km of a single phase overhead…

A: Since you posted the multiple questions so I am solving the 2nd questions for you

Q: 5/The phase angle between magnetizing component current and core loss component current is 180o…

A: The phase angle between magnetizing component current and core loss component current is 900.

Q: 8/ As a transformer core, silicon steel has lower hysteresis losses than air.  Select one: True…

A: The main problem with transformer core is, its hysteresis loss and eddy current loss in transformer.…

Q: Ql: Derive the porimitive flow table for the following asynchronous ciricut.

A: Flow table in asynchronous sequential circuits is same as that of state table in synchronous…

Q: To qualify system stability, we use: a. Routh criterion b. Phase margin c. Gain and phase margin d.…

A: We use Routh–Hurwitz stability criterion as a System Stability

Q: Find the equivalent winding resistance, reactance and impedance

A:

Q: 8- What do you understand from the load curve and what information are converged by a load curve.

A: The following are the information obtained from load curves. 1. Load duration curve determines the…

Q: _____________________ of transformers are neglected to draw the reactance diagram. -Series…

A: Fill the blank

Q: Q1: Perform load line analysis for the following circuit using the figure given below. Where E=20V.…

A: consider the given question;

Q: Describe the star-delta connection configuration types in three phase transformers and their…

A: In the star-delta connection configuration of a  three-phase transformer, the primary winding of the…

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.