The open tank in the Figure below contains water at 20°C. For incompressible flow, (a) derive an analytic expression for the water-level change dh/dt in terms of (Q1, Q2, Q3, and d) (b) If h is constant, determine V2 for the given data if V1 = 3 m/s and Q = 0.01 m3/s. D₁ = 5 cm Q₁=0.01 m³/s Water D₂ = 7 cm

The open tank in the Figure below contains water at 20°C. For incompressible flow, (a) derive an analytic expression for the water-level change dh/dt in terms of (Q1, Q2, Q3, and d) (b) If h is constant, determine V2 for the given data if V1 = 3 m/s and Q = 0.01 m3/s. D₁ = 5 cm Q₁=0.01 m³/s Water D₂ = 7 cm

Name: The open tank in the Figure below contains water at 20°C. For incompr
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: The open tank in the Figure below contains water at 20°C. For incompressible flow,(a) derive an analytic expression for the water-level change dh/dt in terms of (Q1, Q2, Q3, and d).(b) If h is constant, determine V2 for the given data if V1 = 3 m/s

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The open tank in Fig. contains water at 20 ° C and isbeing filled through section 1. Assume incompressibleflow. First derive an analytic expression for the water-levelchange dh / dt in terms of arbitrary volume flows ( Q 1 , Q 2 ,Q 3 ) and tank diameter d . Then, if the water level h is constant,determine the exit velocity V 2 for the given data V 1 =3 m/s and Q 3 = 0.01 m 3 /s.
Assume an inviscid, incompressible flow. Also, standard sea level density and pressure are 1.23 kg/m3 (0.002377 slug/ft3) and 1.01 × 105 N/m2 (2116 lb/ft2), respectively. Show that a source flow is a physically possible incompressible floweverywhere except at the origin. Also show that it is irrotationaleverywhere.
the open tank in the figure contains water and is being filled through section 1. Assume incompressible flow. If the water level h is constant, determine the exit velocity V2 for the given data V1 = 3 m/s and Q3 = 0.01 m3/s.
Define and briefly explain the_terms listed below, support your elaboration with mathematicalequations and illustrations where necessary:1. Viscous flow, inviscid flow, compressible and incompressible flow2. Laminar flow, tubulent flow, steady and unsteady tlow3. Reynolds number and Mach number4. VIScOSty, specific gravity, specitic densityBuoyancy., centre of gravity and center of pressure. Bemoulli's equation
Consider a two-dimensional flow which varies in time and is defined by the velocity field, u = 1 and v = 2yt. Given that the density of the fluid does not vary spatially and changes only with time, what differential equa9on for the density, ⍴(t), must be satisfied for this scenario to represent a physical, compressible flow field?
Using the data given in the schematic attached, find the difference of pressure PA and PB h1= 0.65m h2= 0.1m h3= 0.75m h4= 0.45m Density of fluid A is pA= 900kg/m3 Density of fluid B is pB= 1034kg/m3 Mercury density is pHg= 13600kg/m3 Oil density is poil= 700kg/m3 (In the given figure, the pipelines are parallel to each other and not necessarily at the same height.)
Consider the general form of the Reynolds transport theorem (RTT) given by dBsys / dt = d/dt ∫CV ρb dV +∫CS ρbV-› r·n-› dA where V-›r is the velocity of the fluid relative to the control surface. . Let Bsys be the linear momentum mV-› of a system of fluid particles. We know that for a system, Newton’s second law is ∑F-›= ma-›= m dV-› / dt = d /dt (mV-›)sysUse the RTT and Newton’s second law to derive the linear momentum equation for a control volume.
Figure shows the flow of water over a dam. Thevolume fl ow Q is known to depend only on crest width B ,acceleration of gravity g , and upstream water height Habove the dam crest. It is further known that Q is proportionalto B . What is the form of the only possible dimensionallyhomogeneous relation for this flow rate?
Water at 20◦C flows along the streamlines shown in Figure3.11. The (gauge) pressure, velocity, and elevation at Point1 are 15.0 kPa, 1.0 m/s, and 5.02 m, respectively, and thevelocity and elevation at Point 2 are 0.5 m/s and 5.21 m,respectively. Estimate the pressure at Point 2. The given answer was P2 = 13.5 kPa. Show detailed solution pls thank you.
Water flows through a two-dimensional narrowing wedgeat 9.96 gal/min per meter of width into the paper(Fig. P4.72). If this inward flow is purely radial, find anexpression, in SI units, for ( a ) the stream function and( b ) the velocity potential of the flow. Assume onedimensionalflow. The included angle of the wedge is 45 ° .
Figure 1) shows a tank of 20∘C water with a nozzle h = 27 cm below the surface. Bernoulli's equation applies to the flow between points 1 and 2 on the streamline, but not to the flow between points 2 and 3.What is the volume flow rate through the nozzle in L/min ? Assume that the water level in the tank is held constant.
Liquid flows out of a hole in the bottom of a tank as in FinConsider the case in which the hole is very small compared to the tank (d ≪ D). Experiments reveal that average jet velocity V is nearly independent of d, D, ? , or ? . In fact, for a wide range of these parameters, it turns out that V depends only on liquid surface height h and gravitational acceleration g. If the liquid surface height is doubled, all else being equal, by what factor will the average jet velocity increase?