The operation of a constant density plug flow reactor for the production of a substance is described by the equation Cout V K F Lkmax dC kmas Cin For a volume of 500 L reactor, with an inlet concentration of Cu = 0.5 M, an inlet flow rate (F) of 40 L/s, kmas = 5*10s', and K = 0.1 M, find the concentration of C at the outlet of the reactor, by using Modified Newton Raphson method? (Three Trail starting at Cour = 1M)

The operation of a constant density plug flow reactor for the production of a substance is described by the equation Cout V K F Lkmax dC kmas Cin For a volume of 500 L reactor, with an inlet concentration of Cu = 0.5 M, an inlet flow rate (F) of 40 L/s, kmas = 5*10s', and K = 0.1 M, find the concentration of C at the outlet of the reactor, by using Modified Newton Raphson method? (Three Trail starting at Cour = 1M)

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter6: Forced Convection Over Exterior Surfaces

Section: Chapter Questions

Problem 6.12P

See similar textbooks

Similar questions

We have seen in class that water spontaneously rises up when putin contact with a hydrophilic tube. A similar phenomenon occurs when water is put in contact with two parallel hydrophilic plates (Fig. 2). Given that the gap between the plates b = 100 µm, the width of the plates L = 20 cm, and the contact angle between the water and the plates is θ = 5 degrees, find the height of the capillary rise h.
In a reservoir system with a very large accumulation volume for the ideal fluid (water),a) Since the diameter of the ABCDEF outlet pipe is D = 20 cm, the flow rate through the pipe,b) Calculate the velocity, velocity height, relative pressure and pressure heights in the ABCDEF outlet pipe.c) Draw the relative energy and piezometer lines of the system.d) If the relative evaporation pressure of water is pv = -98.5 kPa, what can be z maximum?e) Determine how much the diameter of the outlet pipe can be reduced at most without causing cavitation, with the relative evaporation pressure of water pv = -98.5 Pa and h = 6 m.f) Calculate the critical velocity value for cavitation.
Calculate the specific volume of an air vapor mixture in cubic meter per kilogram of dry air when the following condition prevail: t=31.9 degree celsius, SH=0.15kg/kg, and Pt=92.5Kpa.
The diameter of a 12 ft length of pipe increases uniformly from 12 to 36 in (see Fig). Kerosene (y = 51,1 lb/ft³, p = 1,59 slugs/ft³) is flowing through the pipe with a velocity of 6 ft/s at the 12 in end of the pipe. Determine the (a) velocity at the midlength of the pipe, (b) velocity at the 36 in end of the pipe, (c) volume flow rate, (d) weight flow rate, and (e) mass flow rate.
Suppose in Fig. that h 3 cm, the fluid in the water at20°C, and the flow is turbulent so that the logarithmic lawis valid. If the shear stress in the fluid is 15 Pa, what is Vin m/s?
Hot water at a constant volumetric flow rate of Fh and temperature Th(t) is mixed with cold water at a constant volumetric flow rate of Fc and a constant temperature of Tc. Both streams flow into a bathtub, but because of carelessness, the water is overflowing and keeping the bathtub full of water. The bathtub volume is V, and the heat loss can be ignored. Assuming the water in the bathtub is perfectly mixed and constant density and heat capacity, derive the differential equation relating the temperature in the bathtub, T(t), to the temperature of the hot water, Th(t).
What is mass flow rate of a liquid flowing through a pipe? Derive Bernoulli’s equation.
Write down the formula of Clausius inequality, explain all parameters in it and comment when the equality sign “=“ would apply
Water enters at section 1 at 10 m/s with sp gr of 0.998 and alcohol enterssections 2 at 6 m/s with sp gr of 0.8. Pipes 1 and 2 are of diameter 4 cmand 3 cm. Compute the exit velocity and density of the mixture. Assumeideal mixing of incompressible fluids. CHOICES: A. 9.48 m/s, 914 kg/m3B. 8.71 m/s, 959 kg/m3C. 8.5 m/s, 942 kg/m3D. 9 m/s, 923 kg/m3
The volumetric flowrate of CCl4 (? = 0.659 g/cm3) in a pipe is 5.39 L/s. Find:a.the mass flow rate of the CCl4,b.the molar flow rate of the CCl4, andc.if it enters and exits to an irregular pipe with the inlet and outlet pipe diameters are 2.00 in and 8.00 in, respectively, the exit velocity.
A power plant in rough terrain has a 100-m stack with an inside radius of 1 m. The plant emits 300 g/s of SO2 from the stack with an exit velocity of 10 m/s at a temperature of 120oC. Ambient temperature is 6oC and the temperature increases at a rate of 2 K/km. At 10 m above ground, surface windspeed is 1.5 m/s on a mostly cloudy night. Find the concentration (mg/m3) of SO2 using the included equation: Directly downwind at a distance of 2 km. At a point located 2 km downwind and 0.1 km off the downwind axis. At the point downwind where it is a maximum. Approximately how far from the stack does this occur?
"Two types of gasoline are blended by passing the streams through a horizontal “wye.” The density of both gasolines are 680 kg/m3. Exit pressure at 3 is 145Kpa Find the reaction forces at the "wye"" We assume steady flow and density constant. I basically understand the solution (i think) However, can we ignore the change in height when applying the Bernolli equation? If so why? Please explain this.