ball. How much force9. Your brother is working as a supervisor in a beverage bottling plant. One day, he letyou tour around the facility. You noticed that a beverage (mostly water) flows in apipe with a mass flow rate that would fill 220 cans every minute. Each can contain355-mL of the liquid. At point in the pipe, the gauge pressure is 152 kPa and the cross-sectional area is 8.00 m'. At point 2, 1.35 m above point 1, the cross-sectionalarea is 2.00 m². Calculate the (A) mass flow rate: (B) volume flow rate; (C) flowspeeds at the two points; (D) gauge pressure at point 2.Terran T-280 S CY

Given 220 cans filled in 1 minute and each bottle measures 355 mL At point 1 Gauge pressure P1=152…

Your brother is working as a supervisor in a beverage bottling plant. One day, he let you tour around the facility. You noticed that a beverage (mostly water) flows in a pipe with a mass flow rate that would fill 220 cans every minute. Each can contain 355-mL of the liquid. At point 1 in the pipe, the gauge pressure is 152 kPa and the

Your brother is working as a supervisor in a beverage bottling plant. One day, he let you tour around the facility. You noticed that a beverage (mostly water) flows in a pipe with a mass flow rate that would fill 220 cans every minute. Each can contain 355-mL of the liquid. At point 1 in the pipe, the gauge pressure is 152 kPa and the

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Chlorine gas is moving through a pipeline at a rate of 200 kilogram per hour while being pressured at 5 psig and operating at 800 F. If the pipe has a diameter of 5 inches, what is the flow velocity, expressed in meters/second?
Given: diameter of pipe in point 1 = 3.9indiameter of pipe in point 2 = 2.5inspecific gravity of the liquid = 0.79h(ft) = 0.60ftpressure at point 1 = 14.6 psiapressure at point 2 = 49 psiapump and motor efficiency = 66%diameter of pipe in point 4 = 4.5indiameter of pipe in point 5 = 2.3 inZ3 = 35ft With the schematic diagram of a pump, tanks, and piping determine the following:1) The velocity of the liquid at point 2 (ft/s)2) Pump work used by the liquid (Wpump U) (hp)3) Electric motor power in out (kW)4) In figure 3, the shaded (pink) in the U tube is mercury; determine y. specific gravity of mercury 13.75) Mass flow rate
A fan with 22-in-diameter blades moves 1800 cfm (cubic feet per minute) of air at 70°F at sea level. Determine the following: The force required to hold the fan. The minimum power input required for the fan Choose a control volume sufficiently large to contain the fan, with the inlet sufficiently far upstream so that the gage pressure at the inlet is nearly zero. Assume air approaches the fan through a large area with negligible velocity and air exits the fan with a uniform velocity at atmospheric pressure through an imaginary cylinder whose diameter is the fan blade diameter.
If 10 m^3 of atmospheric air at 1 degree centigrade temperature are compressed to a volume of 1m^3 at 100°C, what will be the pressure of air?
Should we take into consideration the fluid's weight inside a pressurized, closed tank filled with gas when solving for the pressure at a point inside the tank?
The tank of an air compressor has a volume of 2m3 and is filled with air at a temperature of 40 degrees C. If agauge pressure on the tank reads 7.5 bars,what is themass of the air in the tank?
AN AUTOMOBILE TIRE CONTAINS 3730 cu. in. OF AIR AT 32 psig AND 800f. (a) What mass of air is in the tire? (b) In operation, the air temperature increases to 1450F. If the tire is inflexible, what is the resulting percentage increase in gage pressure? ( c) What mass of the 1450F air must be bled off to reduce the pressure back to its original value?
Mercury has a volumetric flow rate of 30m³/s. What volume of mercury has flowed after 1 minute?
Early mountaineers boiled water to estimate their altitude.If they reach the top and fi nd that water boils at 84 ° C,approximately how high is the mountain?
Water flows through a 125 mm diameter pipe at a velocity of 7.5 m/sec. Find the mass flow rate in kg/sec. NOTE: Do not write any unit to your answer, put your answer in a numerical form only and use up to 3 decimal places. ASAP PLS
A cylindrical tank contains a certain liquid (SG = 1.36) to a depth of 0.5 m. A pressure of 59 kPa is acting at the surface of the liquid. If it is accelerated upwards at 4.99 m/s2, what is the resulting pressure (kPa) at the bottom of the tank?
3. An automobile tire contains 3730 cu.in. of air at 32 psig and 80°F. (a) What mass of air is in the tire? (b) In operation, the air temperature increases to 145°F. If the tire is inflexible, what is the resulting percentage increase in the gage pressure? (c) What mass of the 145°F air must be bled off to reduce the pressure back to its original value?