The portable floor crane in the automotive shop is lifting a 530-lb engine. For the position shown compute the magnitude of the force supported by the pin at Cand the oil pressure p against the 3.36-in:diameter piston of the hydraulic-cylinder unit AB. Assume a- 5 in, b= 33 in, c=14 in, e- 54 in, and e = 36. Answers: Ib Ib/in.? p=

The portable floor crane in the automotive shop is lifting a 530-lb engine. For the position shown compute the magnitude of the force supported by the pin at Cand the oil pressure p against the 3.36-in:diameter piston of the hydraulic-cylinder unit AB. Assume a- 5 in, b= 33 in, c=14 in, e- 54 in, and e = 36. Answers: Ib Ib/in.? p=

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.37P: The 40-kg homogeneous disk is resting on an inclined friction surface. (a) Compute the magnitude of...

See similar textbooks

Similar questions

The center of gravity of the nonhomogeneous bar AB is located at G. Find the angle at which the bar will be in equilibrium if it is free to slide on the frictionless cylindrical surface.
The thin-walled cylindrical can with a spherical dimple weighs 0.2 lb. Determine the force P required to push the can into water to a depth of 8 in. Use =0.036lb/in.3 for water.
The homogeneous plate of weight W is suspended from two cables. Determine the force P that is necessary to keep the plate in the position shown.
Find the magnitude of the pin reaction at B caused by the weight W=80lb. Neglect the weights of the members.
Determine the horizontal force P that would keep the uniform 12-kg rectangular plate in the position shown.
The inside surface of each thin shell carries a uniform normal pressure of intensity p0. Compute R, the magnitude of the resultant force for each case.
Find the force P required to (a) push; and (b) pull the 80-lb homogeneous roller over the 3-in. curb.
The 40-kg homogeneous disk is resting on an inclined friction surface. (a) Compute the magnitude of the horizontal force P. (b) Could the disk be in equilibrium if the inclined surface were frictionless?
The high-pressure water cock is rigidly attached to the support at D. Neglecting the weights of the members, draw the FBD of the entire assembly and count the unknowns.
The center of gravity of the 3000-lb car is at G. The car is parked on an incline with the parking brake engaged, which locks the rear wheels. Find (a) the normal forces (perpendicular to the incline) acting under the front and rear pairs of wheels; and (b) the friction force (parallel to the incline) under the rear pair of wheels.
The weight of the cylindrical tank is negligible in comparison to the weight of water it contains (water weighs 62.4lb/ft3). The coefficient of static friction between the tank and the horizontal surface is s. (a) Assuming a full tank, find the smallest force P required to tip the tank, and the smallest s that would allow tipping to take place. (b) If the force P = 200 lb initiates tipping, determine the depth of water in the tank.
The uniform ladder of weight W is raised slowly by applying a vertical force P to the rope at A. Show that P is independent of the angle .