Answered: The power developed by the pump is…

The power developed by the pump is 30kw. What is the percent decrease in power if speed will decrease by 40%. ANSWER: 78.4%

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 10RQ: The seasonal energy efficiency ratio (SEER) includes the energy used in the _____and _____cycles.

See similar textbooks

Related questions

Q: The calculated shaft work needed to pump water at 20°C is W = -2,545 J/kg at a volumetric flow rate…

A: Given data shaft work (W) = -2545 J/kg volumetric flow rate (Q) = 0.48 m3/min pump efficiency (n) =…

Q: The available flow of water is 25 cu. m/ sec at 30 m elevation. If a hydro electric plant is to be…

Q: A turbine is used to extract energy from water at a discharge of 1.5 cfs. If turbine head is ℎ? = 9…

Q: In Fig.2 what is the power developed by the turbine assuming efficiency of 80%? 200 kN/m Turbine 0.3…

Q: Q5) A pump of 20 kW power is discharge oil to the over tank as shown in fig. (5). If the efficiency…

Q: trifugal pump lifts water from a sump to a m is suction lift. The suction and delivery on pipe is…

Q: Read the question carefully and give me right solution according to the question. A certain 15-Kw…

A: Given: The rated power of the pump, P = 15 kW The speed of the pump, N = 1600 RPM The diameter of…

Q: A water turbine of expected efficiency 85% operates under 36m at a flow rate of 10m³/s. The unit…

Q: In the Figure.Q3, The energy decline of the connections and the pipe before the pump is 3m.…

Q: What is the energy requirement of an 85% efficient pump that transports 40 L/s of wa the pressure…

A: Hello dear, According to our guidelines Iam able to solve only 1 question at a time as you have…

Q: The pump is used to increase the pressure of water from 100 kPa to 900 kPa at arate of 160 L/min. If…

Q: Aa hydraulic turbine receive water from a reservoir at elevated of 50 m above it. What is the…

Q: Three bladed type wind turbine with an area of 255 sq.m was installed in a windy cliff with 25 m/s…

Q: turbine agitator with six flat blades and a disk has a diameter of 0.303m. It is used in a ank with…

Q: Seawater is to be pumped into a large tank at a rate of 165 kg/min. The tank is opwn to atmostsphere…

Q: An air compressor has a suction volume of 0.35 cubic meter/sec at 28 deg. C and 101.325 Kpa and…

A: Given, P1=101.325 Kpa=14.7 psiP1=700 Kpa=101.526 psiV=0.35 m3/sec=635.664 ft3/mink=1.41 Power for…

Q: Water density = 1000 kg/m³ 3 %3D It is pumped from = 65 KPa to 2 MPa Isentropic efficiency = 0.80…

A: Givenρ=1000kg/m3P1=65kPaP2=2MPa=2000KPaη=0.8

Q: A pump is to deliver 80 GPM of water at a density of 61. 83lb/ft3 with a discharge pressure of 150…

Q: 1. A pump receives water from an open tank whose minimum water level is 1.5 m below the centerline…

A: Given, Minimum water level,hs=1.5mFriction loss in the pipe,hf=1.2mVelocity of water,V=1.02m/sTo…

Q: A pump having an efficiency of 90% lifts water to a height of 155m at the rate of 7.5 m³/s. The…

A: GIVEN DATA- Efficiency = 90% Head h=155m Flow rate=7.5m3/s We have to find Power

Q: Q3: Two tank are connected with piping system as shown. If the pump chara given by: hp- 31-120000…

Q: 19. A centrifugal pump delivering 0-04 cumec of water to a height of 20 metres through a 10 cm…

A: The power needed to drive the pump is to be calculated. The power needed to drive the pump is also…

Q: Pump efficiency = 86% Pump Speed = 2,342 rpm Pump discharge = 428 L/s of water to a height of 78 m.…

A: Givenη=86%N=2342rpmQ=428 L/s=0.428 m3/sH=78m

Q: Q4: Determine the maximum height increase provided by a 7.46 KW pump with a 6-cm-diameter inlet and…

A: Given data:- Power rating of pump, P=7.46 kW Diameter at inlet, d1=6 cm Velocity at inlet, V1=10…

Q: A turbine is located at an elevation 200 m below that of the surface of the water intake. The…

Q: A pump rated at 1800W is used to transfer water from an open tank to another tank. The surfaces of…

A: Given that: Electric power consumed by the pump = 1800 W Vertical distance between the two tanks =…

Q: A pump is working on these parameters 0.56 me/s with TDH of 63 meters. The pump efficiency is at…

Q: A 50 kw motor is used to drive a fan that has a total head of 130m. If fan efficiency is 75%, what…

Q: A pump with an overall efficiency of 60% is pumping an acid (p= 1800kg/m3) from an open tank…

Q: loss is avilabilitty due to this process

A: Given; Heat reservior at;T=900 KTo=300 KQ=3000kJ So, Acc. to question; ∆Suni=-QT+QTO

Q: Que 4.35. Areaction turbine is revolving at a speed of 200 rpm and develops 5886 kW SP when working…

A: Given data, Speed of reaction turbine, N1 = 200 rpm Shaft power, SP = 5886×103 W Overall efficiency…

Q: A centrifugal pump is used to raise the water from the river to the reservoir, find: 1) total…

Q: 1: Derive an expression for the max(mum blade efficiencyß)f rgacvi.n turbine.

Q: What is the energy requirement in kW for a pump that is 75% efficient if it increases the pressure…

A: Given data pump efficiency = 75 % flow rate m.= 10 kg/s Pwater=kgm3 Initial…

Q: what is the minimum water flow in (kg/sce)

A: Need to find minimum mass flow rate of water required (m).

Q: (a) Show how to derive the following formula for the work required to pump all the water out of the…

A: Work done W = Force x distance A rectangular slice of water 'dy' m thick and lying y ft above…

Q: A pump is to deliver 240 US Quarts per minute of water with a discharge pressure of 150 psig Suction…

A: Given data:

Q: A hydroelectric plant gets water from a dam at the rate of 100 cubic meters per minute to generate…

Q: A large water pump takes water from a nearby lake at a rate of 35 f/Sec and rauses its pressure from…

A: Given that, Flow rate of water, Q=35 ft3/sec,Pressure at the inlet of pipe, Pin=17 psiaPressure at…

Q: A pump is to deliver 80 GPM of water at a density of 61. 83lb/ft3 with a discharge pressure of 150…

A: Given Data Q=80 GPM =80×013368460= 0.1782 ft3/s ω=60.38 lb/ft3 Vs=QA=0.1782π4512=1.304 ft/s…

Q: The available flow of water is 70 m^3 /s at 39 m elevation. If a hydroelectric plant is to be…

A: Given Data. Q=70 m3/s H=39 m turbine efficiency = 0.86 generator efficiency = 92%

Q: Derive the equation for turbine and nozzle with the help of steady energy equation by stating their…

A: Nozzle is a device that accelerates the fluids. Assumptions of Nozzle - Steady-state process-…

Q: Maria Cristina Hydroelectric Project, the available head is 150m, the head loss is 4.4% of the…

Q: How tall would the jet of water be from the top of the nozzle? PR 16.5 kPa Jet 1.8 m 0.2 m 0.2 m…

Q: 600 kg/min. Of feedwater is drawn by the pump at 0.016mpa and is delivered at 12mpa. What is the…

A: Given data: The efficiency of the pump is η = 0.8The density of the water is ρ = 1000 kg/m3The input…

Q: The calculated shaft work needed to pump water at 20°C is W;=-2,545 J/kg at a volumetric flow rate…

Q: A turbine of 9000 B.H.P. is working under a head of 25 m and runs at 100 R.P.M.- What will be the…

Q: A garden hose is connected to raise a narrower hose wherein the diameter of the bigger is twice the…

Q: Q1: Find the pump efficiency if the pressure difference across the pump is 230 kPa. If the outlet…

A: Given: P2 - P1 = 230 kPa D2 = 7 cm = 0.07 m D1 = 14 cm = 0.14 m m = 50 kg/s Efficiency of motor =…

Concept explainers

Forms of Energy

Energy is described as the capability to accomplish a task, like the ability to push a block by applying force on it. It is a quantitative property that is used to accomplish work on an object.

Question

The power developed by the pump is 30kw. What is the percent decrease in power if speed will decrease by 40%. ANSWER: 78.4%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Seawater is to be pumped into a large tank at a rate of 165 kg/min. The tank is opwn to atmostsphere and the water enters the tank from a 80 m height. The overall efficiency of the motor pump unit is 75 percent and the motor consumes electricity at a rate of 3.2 KW. If the irreversible headloss in the piping is 7 m, the velocity of the water (in m/s) at the tank inlet is Show FBD and choose th correct answer A. 7.12 B. 6.21 C. 5.05 D. 8.7
The theoretical pump power requirement to maintain a certain fluid flow is 1800 W. If the pump is working at 68% efficiency, how much power must the pump be able to supply at the minimum?
What is the energy requirement in kW for a pump that is 75% efficient if it increases the pressure of 10 kg/s of water from 10kPa to 6MPa?A. 60B. 70C. 80D. 90
A pump discharges 50 tons of water per hour to a height of 8 m, overall efficiency of the pumping system being 69%, what is the input and output power?
600 kg/min. Of feedwater is drawn by the pump at 0.016mpa and is delivered at 12mpa. What is the pumpwork in KW? If the pump motor efficiency is 80%. What is the power input to the motor?
Water flowing at 0.5 m3/min enters the turbine of a micro-hydroelectric generator and delivers a shaft work of W= 2,500 J/kg. What is the power delivered by the generator if it works at 95% efficiency, n = 0.95?
25. A wind turbine having an efficiency of 35% and rotor diameter of 33 m is exposed to air flowing at a speed of 6 m/s. Find the power developed by the turbine. Assume ρ = 1.2 kg/m3. [Ans.: 38.8 kW].
Aa hydraulic turbine receive water from a reservoir at elevated of 50 m above it. What is the minimum water flow in kg per second to produce a turbine output of 30 mw?
The available flow of water is 25 cu. m/ sec at 30 m elevation. If a hydro electric plant is to be installed with turbine efficiency of 85% and generator efficiency 90%, what maximum power that the plant could generate?
A 50 kw motor is used to drive a fan that has a total head of 130m. If fan efficiency is 75%, what is the maximum capacity(m3/s)of the motor needed if air is available at 100kpa and 26C. ANSWER: 25.23 m3/s
A turbine is discharging 10m3/s under a head of 22 m at 200 rpm. The efficiency is 90%. Determine the performance of turbine under a head of 44 m.
A pumped storage power plant with a head of 150 m, with a flow rate of 6 cms for power generation and pumping, and continuous operation for 8 hours each time. Try to find (1) the power output during power generation and the total daily power generation; (2) pumping water Hourly power and total daily power demand; (3) Pumped storage power plant efficiency; (4) Adjust the pool capacity? Assuming that the water loss is 8% of the total drop, the combined efficiency of the turbine and generator is 85%, and the efficiency of the pump is 65%.