The primary of a transformer has 200 turns and is excited by a 60Hz, 110v source. what is the maximum vale of the core flux

Q: Given, G(jw) = (-2+3jw). Therefore magnitude at w=1 is, O a. 3.6 Ob.2 Oc 22 Od. 4.5

A: The solution is given below

Q: antenna for television station is located at the top of a 1,500 ft transmission tower. Compute the…

A: We need to find out LOS distance

Q: If the Q-factor of a coil at resonant frequency of 1.5 MHz is 150 for a series resonant circuit,…

A:

Q: -1,5z X(2) for the sequence x(n) = 2" u(-n - 1)-)" u(-n- 1) is (z-2)(z-

A: We know that -anu-n-1↔11-az-1 Therefore, 2nu-n-1↔-11-2z-1 -12nu-n-1↔11-12z-1

Q: ensity is given by p. 750 sech 10°7x tanh TxC/m³. The dielect emiconductor material is 10 and the…

A: Solution- We know,dEdx =dρvkε0ordEdx = ρvxkε0E = electric field         ρv = 750 sech 106πx…

Q: 1. Calculate v, in the circuit using superposition.

A:

Q: 44. Find the average value of the periodic waveform in Fig. 97. 4i (mA) 20 ---- ,Circular 2m FIG. 97…

A:

Q: An iron-ring of mean length 30 cm is made of three pieces of cast iron, each has the same length but…

A: Current: Is the time rate of the change of the charges. The direction of the current is opposite to…

Q: W. Find the current I in the following network: V = 10/20° V ZR = 20 Z = j2N { ZR = 40 %3D

A:

Q: I. An LED (Light Emitting Diode) operates a. In the reverse- bias b. in the forward bias II. A Zener…

A:

Q: H.W. Find the current I in the following network: V = 10/20° v (+ ZR = Z, = j2N Zc=-j10 { ZR = 4 0 =…

A: The solution is given below

Q: 1. Calculate v, in the circuit using superposition.

A:

Q: • 1. Determine the equivalent impedance and the equivalent admittance. 2n -j4n Zea jon -jsn

A:

Q: A counter counts in the sequence 1-3-4-5-6-9-8, then repeats. What is the MOD of the counter?

A: Counters are known to be sequential logic circuits. They can be synchronous or asynchronous.

Q: the antenna current of an am transmitter is 11A when an modulated but increase to 14A when modulated…

A:

Q: Find IBQ, Ico, VCEQ VB, VE, Vc- ,Icq,VcEq, VB, VE,Vc- 20 V 470 2 ICQ 270 k2 oVc VB B= 125 VCEO 180…

A: In this question,   We need to determine the base current, collector current, and voltage VB  , VC…

Q: Given the image below, if it is from 0≤t≤10 ms, what is the sampling rate? choose one a.30 Hz b.25…

A: Sampling rate must be greater than twice the signal frequency to remove the problem of aliasing.

Q: An automatic pressure control system measured the output as 8 psi. If error signal is 5 psi, such…

A: The solution is given below

Q: A transmitter supplied by 100W power is used with an antenna having a gain of 5dBi. a) Calculate…

A:

Q: To realize the system function shown below using IIR direct form I, you will need to 5 delay, adder,…

A:

Q: Design a broadband microstrip transformer operating at the center frequency fo=1 GHz to match a load…

A: It is a special transformer which is fabricated for the micro-strip. The strip is consider as the…

Q: When two or more out of phase pulses interfere, they ____________. I. destroy each other   II.…

A: Pulse  is nothing but a disturbance or a deviation in voltage or current, interference is nothing…

Q: suoniu 1. For the sinusoidal waveform in Fig. 81: a. What is the peak value? b. What is the…

A:

Q: a 20mH inductor draws a current of i(t) = 100 sin(100t). Find the voltage equation

A:

Q: #6) For the BJT transistor circuit given below, determine: IB, lc, lE, VCE, and Vce Page | Re Vcc RB…

A: In this question,   We need to determine the all known currents and voltage.  We know  Forward bias…

Q: (a) A signal ranges from -20V to + 20 V needs to be acquired with a maximum error of 0.4 mV. In…

A:

Q: A professional center is supplied by a balanced three-phase source. The center has four plants, each…

A:

Q: Draw block diagram /circuit diagram of the ff. FM circuits and discuss the operation. 2. FM…

A:

Q: Can you draw a diagram of a separately excited motor. 1. Where the two coils are in series. 2.…

A: Separately Excited DC Motor: The main supply is delivered separately to the armature and field…

Q: list three (3) advantages and three (3) disadvantages of PLC (Programmable Logic Controller

A:

Q: 1. R1 1Ω V I 2 A E 24 V R2

A: We need to find out current and voltage for given circuit

Q: 3.11 i In cylindrical coordinates, let p, = 0 for p 1.5 mm. Find D everywhere. %3D

A:

Q: I need to kra-) convert the drawing of drawing by hand to print a line on your S.C computer please

A: I need to draw the image in the computer.

Q: Problem 48: Perform the following operations, and express your answer in rectangular form:…

A:

Q: The figure below shows an electronic PID controller constructed using OP-AMPS. Determine the values…

A:

Q: 17] How much Power is being dissipated by a 4.7K Ohm Resistor that is dropping 5.1 Volts? Express…

A: The power dissipated across the resistor can be calculated by using the ohms law and the beta of the…

Q: Calculate the cutoff frequency of the LPF section that can be constructed from a capacitor of 120 uF…

A:

Q: 1-(3coswo)z 1 1-(2coswo)z-1+9z-2 X(2) for the sequence x(n) =(3" coswon)u(n) is

A:

Q: X(2) Tor the sequence x(n) =(3" coswon)u(n) is 1-(3coswo)z 1 1-(2coswo)z-1+9z-2

A:

Q: Q3 ) A 220-V, 3-o, 4-pole, 50-Hz, Y-connected induction motor is rated 3.73 kW. The equivalent…

A:

Q: An inductance of 20mH is connected in parallel with a capacitance of 80 microfarads. what is the…

A: The solution is given below

Q: Precision grip dynamic measurements between the Index finger and the thumb have been performed using…

A:

Q: 2. Using mesh analysis, write the mesh equations for the following network and solve for the current…

A:

Q: The ROC for the sequence x(n) = 2" u(-n – 1)-)" u(-n- 1) is |2|< 2

A:

Q: 220Vrms, 3-Ph, Y-connected symmetrical positive sequence source is connected to 21+J24Q/Ph,…

A: In this question we need to find a average power absorbed by the load

Q: The z-transform does not exist for the sequence x(n) = 3" u(n) – u(-n – 1) %3D

A: The solution is given below

Q: Power in a three phase delta system

A:

Q: An automatic pressure control system measured the output as 8 psi. If error signal is 5 psi, such…

A:

Q: Discuss what happens at the microscopic level of the dielectric material when it is placed in an…

A: It is asked to discuss what happens at the microscopic level of the dielectric material when the…

Q: Consider a stable LTI system with input x(n) and output y(n). The zero-pole pattern of y(n) consists…

A: In this question we need to find system function and the system impulse response.

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.