The radius of a sphere increases at a rate of 4m/ sec. Find the rate at which the surface area increases when the radius is 9m. O 72m m² /sec O 144T m² /sec 367 m² /sec O 18™ m² /sec 288t m² / sec

The radius of a sphere increases at a rate of 4m/ sec. Find the rate at which the surface area increases when the radius is 9m. O 72m m² /sec O 144T m² /sec 367 m² /sec O 18™ m² /sec 288t m² / sec

Name: 6) The radius of a sphere increases at a rate of4m/sec. Find the rate
Uploaded: 2024-03-20T07:06:41.000Z
Channel: Bartleby
Description: 6) The radius of a sphere increases at a rate of4m/sec. Find the rate at which the surface areaincreases when the radius is 9m.O 72m m² /secO 1447 m² / sec36т т?/secO 18T m²/sec288T m² / sec

Algebra: Structure And Method, Book 1

(REV)00th Edition

ISBN:9780395977224

Author:Richard G. Brown, Mary P. Dolciani, Robert H. Sorgenfrey, William L. Cole

Publisher:Richard G. Brown, Mary P. Dolciani, Robert H. Sorgenfrey, William L. Cole

Chapter2: Working With Real Numbers

Section2.3: Rules For Addition

Problem 14P

See similar textbooks

Similar questions

The four holes in the figure are 0.8 cm in diameter and equally spaced around the bolt circle. Find the distances x and y rounded to 2 decimal places.
A combination of gage Nocks is selected to provide a total thickness of 0.4573 inch. One block 0.250 inch thick and one block 0.118 inch thick arc selected. What is the required thickness of the remaining blocks?
A machinist needs to lay out three holes in a plate. Find, to the nearest thousandth millimeter, the length of side b in the figure.
Suppose that r=12 cm and h=15 cm in the right circular cylinder. Find the exact and approximate a lateral area. b total area. c volume.
A goat is tethered to a barn by a 12-ft chain. If the chain is connected to the barn at a point 6 ft from one end of the barn, what is the area of the pasture that the goat is able to graze?
A piece of round stock is being turned to a 17.86-millimeter diameter. A machinist measures the diameter of the piece as 18.10 millimeters.What depth of cut should be made to turn the piece to the required diameter?