The spool has a mass of 150 kg and a radius of gyration of Kç = 240 mm about its centre ofmass G. The coefficients of static and kinetic friction between the rail and the spool are us =0.2 and µk = 0.15, respectively. If a vertical force of P = 400N is applied to the cable,determine the frictional force at the contact between the spool and the rail and whether thespool slips.300 mmG150 minRailP

Answered: Image /qna-images/answer/3ae07afb-6aba-4211-aae4-d85b6fb64091.jpg

The spool has a mass of 150 kg and a radius of gyration of Kc = 240 mm about its centre of mass G. The coefficients of static and kinetic friction between the rail and the spool are µs = 0.2 and µk = 0.15, respectively. If a vertical force of P = 400 N is applied to the cable, determine the frictional force at the contact between the spool and the rail and whether the spool slips. 300 mm

The spool has a mass of 150 kg and a radius of gyration of Kc = 240 mm about its centre of mass G. The coefficients of static and kinetic friction between the rail and the spool are µs = 0.2 and µk = 0.15, respectively. If a vertical force of P = 400 N is applied to the cable, determine the frictional force at the contact between the spool and the rail and whether the spool slips. 300 mm

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter7: Dry Friction

Section: Chapter Questions

Problem 7.16P: The mass of the unbalanced disk is m, and its center of gravity is located at G. If the coefficient...

See similar textbooks

Similar questions

The uniform rod has a mass of 13.09 kg and rests on the inside of the smooth ring at B and on the ground at A. If the rod is on the verge of slipping, determine the coefficient of static friction between the rod and the ground.
17-47 The four-wheeler has a weight of 335 Ib and a center of gravity at G1, whereas the rider has a weight of 150 lb and a center of gravity at Gz. If the engine can develop enough torque to cause the rear wheels to slip, determine the largest coefficient of static friction between the rear wheels and the ground so that the vehicle will accelerate without tipping over. What is this maximum acceleration? In order to increase the acceleration, should the rider crouch down or sit up straight from the position shown? Explain. The front wheels are free to roll. Neglect the mass of the wheels in the
The uniform bar has a mass m and length l. If it is released from rest when u = 0°, determine the angle u at which it first begins to slip. The coefficient of static friction at O is ms = 0.3.
Determine the distance s to which the 53-kg painter can climb without causing the 3.5-m ladder to slip at its lower end A. The top of the 17-kg ladder has a small roller, and at the ground the coefficient of static friction is 0.24. The mass center of the painter is directly above her feet.Assume L = 3.5 m, a = 1.04 m
Determine the distance s that the 90 kg draftsman can climb without causing the 4-meter ladder to slip at its lower end A. The top of the ladder weighing 15 kg has a small pulley, and on the ground the coefficient of static friction is 0.25. The painter's center is directly above her feet. Answer. S 2.55 m% 3d by 4 m by 1.5 m
The spool has a mass of 200 kg and a radius of gyration of kG = 0.2 m. If the coefficients of static and kinetic friction at A are μs = 0.3 and μk = 0.2, respectively, determine the angularacceleration of the spool if P = 400 N.
Determine the distance s to which the 90-kg painter can climb without causing the 4 m ladder to slip at its lower end A. The top of the 15-kg ladder has a small roller, and at the ground the coefficient of static friction is 0.25. The mass center of the painter is directly above her feet.
If the 75-lb girl is at position d = 4 ft, determine the following. Neglect the weight of the plank. A. The minimum coefficient of static friction μs at contact points A and B so that the plank does not slip is_________. B. The normal force at A is _________ lb given the same condition at Question A C. The normal force at B is ________ lb given the same condition at Question A
Consider the system of two blocks. Thereis no friction between block A and the tabletop. The mass of block B is5.00 kg. The pulley rotates about a frictionless axle, and the light ropedoesn’t slip on the pulley surface. The pulley has radius 0.200 m andmoment of inertia 1.30 kg . m2. If the pulley is rotating with an angularspeed of 8.00 rad/s after the block has descended 1.20 m, what is themass of block A?
The 180 lb man climbs up the ladder and stops at the position shown after he senses that the ladder is on the verge of slipping. Determine the coefficient of static friction between the friction pad at A and ground if the inclination of the ladder is at theta=60 degrees and the wall B is smooth. The center of gravity for the man is at G. Neglect the weight of the ladder.
The uniform dresser has a weight of 93 lb and rests on a tile floor for which μs = 0.26. If the man has a weight of 150 lb and pushes on it in the direction θ = 30°, determine the smallest coefficient of static friction between his shoes and the floor so that he does not slip.
The 3600-lb car with rear wheel drive is attempting to push the 4500-lb crate. The center of gravity of the car is at G, and the coefficients of static friction are 0.6 at B and 0.2 at C. Determine if the crate will slide. (The car pulling the crate is analyzed in Prob. 7.19.)