The system is released from rest with no slack in the cable and with the spring stretched 280 mm. Determine the distance s traveled by the 13-kg cart before it comes to rest (a) if m approaches zero and (b) if m = 2.9 kg. Assume no mechanical interference.

The system is released from rest with no slack in the cable and with the spring stretched 280 mm. Determine the distance s traveled by the 13-kg cart before it comes to rest (a) if m approaches zero and (b) if m = 2.9 kg. Assume no mechanical interference.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

To apply Newton’s second law and the theorem of conservation of energy to solve kinetic problems. A bungee jumper wants to jump off the edge of a bridge that spans a river below. The jumper has a mass m, and the surface of the bridge is a height h above the water. The bungee cord, which has lengthL when unstretched, will first straighten and then stretch as the jumper falls.Assume the following: The bungee cord behaves as an ideal spring once it begins to stretch and has spring constant k. The jumper does not actually jump but simply steps off the edge of the bridge and falls straight downward. The jumper's height is negligible compared to the length of the bungee cord. Thus, the jumper can be treated as a point particle. Use g for the magnitude of the acceleration due to gravity. How far below the bridge, d, will the jumper eventually be hanging, once the jumper stops oscillating and comes finally to rest? Assume that the jumper does not touch the water. Express your answer in…
The 10 kg block is subject to the action of a force that has the constant direction towards the spring, with a magnitude F= 250 (1 + x) N, where x is measured in meters. If the coefficient of kinetic friction between the block and the horizontal surface is 0.20, and ks= 50 N/m Use the springs por your calculations Determine: a) The work done by all the forces acting on the block during a movement from A to B. b) If the block starts from rest at point A, determine its velocity at point B using the equation of motion (Newton's 2nd Law). c) Verify the speed obtained in b) through the equation of work and Kinetic Energy. d) Explain the differences between the two methods used to find the velocity, from the point of view of the volume of calculations. Recomendations: 1. No force (except weight) is constant throughout travel 2. Acceleration is not constant at any point along the way. 3. When applying Newton's second law, it is advisable to do it in two sections. 4. Review the…
(The complete question is in the picture) Consider a 2.0 [kg] box that is attached to two identical springs that are in their relaxed state when the block is centered on the frictionless horizontal floor. The box is pressed to the left and then was released from rest as shown in the figure. If work done by the left spring is Wby spring = 25 [J], what is the speed of the boxas it passes the center x = 0? A. 8.2 [m/s]B. 7.1 [m/s]C. 3.5 [m/s]D. zero
The spring constants are k1 = 140N / m, k2 = 240N / m and the unstretched lengths of the springs are 0.3 m. If the 6 kg ring is released from rest from point A, calculate its velocity when it reaches point B. According to the given datum line, the total potential energy (Ve) at point A is A = 1116.86 J and the total elastic potential energy (Ve) at point B is B = 370.8 J. Neglect the dimensions of the bracelet. (L1 = 0.90 m, L2 = 1.80 m, h1 = 1.20 m and h2 = 2.40 m)
A tugboat T having a mass of 19 Mg is tied to a barge B having a mass of 75 Mg. If the rope is "elastic" such that it has a stiffness of k=600kN/m, determine the maximum stretch in the rope during the initial towing. Originally both the tugboat and barge are moving in the same direction with speeds (vT)1= 15 km/h and (vB)1= 10 km/h, respectively. Neglect the resistance of the water.
The blocks A and B shown in the figure are originally at rest, and all contact surfaces are smooth(frictionless). If a towing force given in the otherfigure, acting horizontally, is applied to block A for 3 s, determine the final velocities of the blocks at time t=3 s.Note: The blocks masses are mA= 5 kg and mB=3 kg.
the 3-kg collar shown has a coefficient of kinetic friction uk=0.22 with the shaft. the spring is unstretched when s=0 and the collar is given an initial velocity of v0=19.5 m/s. the unstretched length of the spring is d=1.5m and the spring constant is k=597 N/m. What is the speed of the collar afer it has moved 1.5m?
A body weighing 445 N is drawn along a rough surface. The force applied in the direction of motion is 135 N while the frictional force is 90 N. if there is an air resistance whose magnitude (in N) is equal to twice the velocity (m/s) at any instant, assume the body to start from rest.Determine the displacement at any time, t.
URGENT Collar A slides over the smooth vertical bar shown in the figure. The masses Wa = 10lbs and WB = 5lbs. When h = 0.12192m, the spring is unextended. When the system is in equilibrium, h = 0m. Determine the constant k of the spring. Note: The normal of the collar is 100 times its mass (that of the collar), remember that g = 32.16 ft/s2.
The mass m = 5.0 kg resting on a frictionless horizontal table is connected to a horizontal spring with stiffness constant k = 170 N/m. The mass is pulled a distance to the right so that the spring is stretched a distance x0 = 1.3 mm initially, and then the mass is released from rest. e)? g)?
The 18 000-kg F-35B uses thrust vectoring to allow it to take off vertically. In one maneuver, the pilot reaches the top of her static hover at 200 m. The combined thrust and lift force on the airplane applied at the end of the static hover can be expressed as F = (44t + 2500t2)i + (250t2 + t + 176 580)j, where F and t are expressed in newtons and seconds, respectively. Determine how long it will take the airplane to reach a cruising speed of 1000 km/hr (cruising speed is defined to be in the x-direction only).
A 250-N(≈25-kg) cabinet is placed on a smooth surface. If a force of a 300 N is applied for 1 s, determine the net impulse on the cabinet during this time interval