The table below contains the information about two embankment sections. The distance between them being 30m. The formation width increases uniformly from 6m at the first section to 9m at the second. Calculate the volume between .these sections by trapezoidal formula L -2.07 7.14 -2.16 8.82 CL -2.34 0 -3.45 0 R -3.15 9.30 -3.81 12.12 1149.80.m3 O 1194.282 m3 O 1194.820 m3 O 1149.282 m3 O

The table below contains the information about two embankment sections. The distance between them being 30m. The formation width increases uniformly from 6m at the first section to 9m at the second. Calculate the volume between .these sections by trapezoidal formula L -2.07 7.14 -2.16 8.82 CL -2.34 0 -3.45 0 R -3.15 9.30 -3.81 12.12 1149.80.m3 O 1194.282 m3 O 1194.820 m3 O 1149.282 m3 O

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A triangular channel carries a flow of 2.4 cumecs laid on a slope of 0.001 with n=0.012. If the notch angles is 60degrees, what is the value of the normal depth(m)? a. 1.53b. 1.68c.1.79d. 1.21
How deep will water flow in a 90° V-shaped flume, n = 0.013, laid on a grade of 0.00040 if it is to carry 2.55 m /s? a. 0.921 b. 0.534 c. 1.57 d. 2.05
width of rectangular channel = 3.6 meters discharge = 2.7 m^3/s Assume n = 0.012 What is the critical slope of this wooden flume?
Water is flowing at a rate of 4.5m3/s in a trapezoidal channel whose bottom width is 2.4m and side slopes are 1 vertical to 2 horizontal. Compute for the channel depth if n = 0.012 and So = 0.0001
What is the Froude number in a triangular channel with a sidewall slope of m = 1.5 ,water depth of y = 0.66 m, and discharge of Q = 0.2 m3/s? a) 0.23 b) 0.21 c) 0.19 d) 0.17
A rectangular canal, 6.45m wide and 1.45m deep lined with smooth stone (n=0.013) has a hydraulic slope of 0.001. What savings in earth excavation (m3) were introduced using the most efficient rectangular section but adhering to the same discharge and slope? Channel is laid 5m long. CHOICES: 0.758 5.718 7.815 1.785
Determine the dimensions of the most economical trapezoidal earth-lined channel (Manning’s N = 0.020) to carry 14 m3/s at a slope of 1 in 210. A trapezoidal channel has side slopes of 1 horizontal to 2 vertical and the slope of the bed is 1 in 1500. The area of the section is 40 m2. If Chezy’s constant C = 60, determine: (i) The dimensions of the section if it is most economical. a. b = 1.154 m; y = 0.577 m b. b=2.828 m , y= 1.414 m c. b = 5.93 m; y = 4.8 m d.b = 0.9 m; y = 1.085 m
A trapezoidal irrigation canal with side slope of 1.5 H to V is proposed to be lined with bricks to reduce seepage losses. It is required too carry a discharge of 20m ^ 2 / s of water. Find the wetted perimeter for minimum amount of lining and required bed slope. The value of Manning's Nis given as 0.015 and it is stipulated that average velocity cannot exceed 1 m/s.
Determine the dimensions of the most economical trapezoidal earth-lined channel (Manning’s N = 0.020) to carry 14 m3/s at a slope of 1 in 210. A trapezoidal channel has side slopes of 1 horizontal to 2 vertical and the slope of the bed is 1 in 1500. The area of the section is 40 m2. If Chezy’s constant C = 60, determine: (i) The dimensions of the section if it is most economical. a. b = 0.9 m; y = 1.085 m b. b = 1.154 m; y = 0.577 m c. b=2.828 m , y= 1.414 m d. b = 5.93 m; y = 4.8 m
The table below is the page of a level field book. 1) Calculate the difference in level between point A and G. 2) If it is required to build a horizontal embankment along the line AG, so that the elevation of the embankment is higher than the original ground surface with 150cm at point A. Calculate the depth of fill at point D. let RL of A=30m (all the readings in meter)
5. Determine the slope of a channel if it has a bottom width of 20 ft, side slope of 2:1, water depth of 3.36 ft, discharge of 400cfs and n= 0.025.
A circular vitrified sewer pipe is laid on a slope of 0.0002 and it is to carry 2.4 m^3/s. When the pipe flows at 90% of its diameter, what size of pipe should be used if n=0.015? Choices: a. 2.16m b. 0.91 m c. 1.10 m d. 2.52 m