الامتحان النهائي< >الوقت المتبقی 0 01:27:0Not yet answeredMarked out of 2.00سؤال 17The figure onthe side isElectric potential accross the capacitor11showinghow thevoltage onthe capacitorin an RC-O 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150 160circuittime (sec)changeswith timeThe time needed for the capacitor to lose half itsmaximum charge:Select onea. 80 secb. 30 secc. 20 secd. 40 secأخل اختياري1II

A graph is given describing the electric potential of a capacitor. The graph shows the charge in…

Answered: The time needed for the capacitor to…

Science

Physics

The time needed for the capacitor to lose half its maximum charge

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter27: Capacitors And Batteries

Section: Chapter Questions

Problem 6PQ: According to UE=12C(V)2 (Eq. 27.3), a greater capacitance means more energy is stored by the...

See similar textbooks

Similar questions

When a Leyden jar is charged by a hand generator (Fig. 27.1, page 828), the work done by the person turning the crank is stored as electric potential energy in the jar. When a capacitor is charged by a battery, where does the electric potential energy come from?
According to its design specification, the timer circuit delaying the closing of an elevator door is to have a capacitance of 32.0 F between two points A and B. When one circuit is being constructed, the inexpensive but durable capacitor installed between these two points is found to have capacitance 34.8 F. To meet the specification, one additional capacitor can be placed between the two points. (a) Should it be in series or in parallel with the 34.8-F capacitor? (b) What should be its capacitance? (c) What If? The next circuit comes down the assembly line with capacitance 29.8 F between A and B. To meet the specification, what additional capacitor should be installed in series or in parallel in that circuit?
When discharging a capacitor, as discussed in conjunction with Figure 21.39, how long does it take for the voltage on the capacitor to reach zero? Is this a problem?
What total capacitances can you make by connecting a 5.00 F and an 8.00 F capacitor together?
A 1-megabit computer memory chip contains many 60.0 1015-F capacitors. Each capacitor has a plate area of 21.0 1012 m2. Determine the plate separation of such a capacitor. (Assume a parallel-plate configuration.) The diameter of an atom is on the order of 1010 m = 1 . Express the plate separation in angstroms.
The immediate cause of many deaths is ventricular fibrillation, an uncoordinated quivering of the heart, as opposed to proper beating. An electric shock to the chest can cause momentary paralysis of the heart muscle, after which the heart will sometimes start organized beating again. A defibrillator is a device that applies a strong electric shock to the chest over a time of a few milliseconds. The device contains a capacitor of a few microfarads, charged to several thousand volts. Electrodes called paddles, about 8 cm across and coated with conducting paste, are held against the chest on both sides of the heart. Their handles are insulated to prevent injury to the operator, who calls Clear! and pushes a button on one paddle to discharge the capacitor through the patient's chest Assume an energy of 3.00 102 W s is to be delivered from a 30.0-F capacitor. To what potential difference must it be charged?
Show that for a given dielectric material, the maximum energy a parallel-plate capacitor can store is directly proportional to the volume of dielectric.
A 1-megabit computer memory chip contains many 60.0 1015-F capacitors. Each capacitor has a plate area of 21.0 1012 m2. Determine the plate separation of such a capacitor. (Assume a parallel-plate configuration.) The diameter of an atom is on the order of 1010 m = 1 . Express the plate separation in angstroms.
Show that for a given dielectric material the maximum energy a parallel plate capacitor can store is directly proportional to the volume of dielectric (Volume = A. d). Note that the applied voltage is limited by the dielectric strength.
Check Your Understanding Repeat the calculations of Example 8.10 for the case in which the battery remains connected while the dielectric is placed in the capacitor.
Suppose that the capacitance of a variable capacitor can be manually changed from 100 pF to 800 pF by turning a dial, connected to one set of plates by a shaft from 0° to 180°. With the dial set at 180° (corresponding to C — 800 pF), the capacitor is connected to a 500-V source. After charging, the capacitor is disconnected from the source, and the dial is turned to 0°. If friction is negligible, how much work is required to turn the dial from 180° to 0°?
A variable air capacitor used in a radio tuning circuit is made of N semicircular plates, each of radius R and positioned a distance d from its neighbors, to which it is electrically connected. As shown in Figure P20.38, a second identical set of plates is enmeshed with the first set. Each plate in the second set is halfway between two plates of the first set. The second set can rotate as a unit. Determine the capacitance as a function of the angle of rotation , where = 0 corresponds to the maximum capacitance. Figure P20.38