The total complex power in a network is the sum of the complex powers of the individual components. Total real power and reactive power are also, respectively, the sums of the ndividual real powers and the reactive powers, but the total apparent power is not calculated by the process

Q: The figure below shows a Wheatstone bridge, a circuit used to precisely measure an unknown…

A: Given, A Wheatstone's bridge Rvar=27.0 Ω

Q: Discuss the advantage of electric vehicles

A: For the above given question we need to list advantages of the electric vehicles.

Q: Calculate the de voltages and currents in the circuit of Fig. 12.37. +9V 3.9 k@ Οι 3.3 ΚΩ 39 ΚΩ

A:

Q: Find the F.T. of the fall wing Signals (functions) * (t) = 1 + cos ( 6πt + I

A: An essential technique for image processing, the Fourier Transform breaks down an image into its…

Q: What are the zeros of the following transfer function: 2,000,000(s + 5) H(w) (s + 10) (s + 100)²…

A: Given, Transfer function: Hω=2,000,000s+5s+10s+1002

Q: An iron core is most often used in an AC transformer to 1.provide a better coupling between the…

A: Given An iron core is most often used in an AC transformer to......

Q: The magnetic circuit of the Figure is built with a material, whose magnetization curve is given by:…

A: Note : Given unit of H  = A.V/m is confusing. we assume it as AT/m Given N1=N2 =360 Required flux in…

Q: 19. What is the minimum distance required for single error detection according to Hamming's analysis…

A: The solution is provided in the following section.

Q: A first order system has a delay time of 2.6 sec, find the system time constant. 3.75

A: Given, A first order system has Delay time, td=2.6 s

Q: The forward voltage of the diode is modeled as a constant voltage source.Diode is modeled as a…

A: The circuit diagram is shown below, Where,R1=R2=1kandThe power source is,P=11mW

Q: Find the F.T. of the fall wing Signals (functions) * (t) = 1 + cos (6πt + T ) ans =F(W) = 25$(w) +T²…

A: Given data : The given function is,    Ft=1+cos6πt+π8

Q: Consider the signal v(t) = cos(wot) + 2 cos(2wot) + 4 cos(8wot) + 2 sin(wot) + 2 sin (2wot) + 6…

A:

Q: What is the voltage gain of this amplifier? ( R₁ 5 ΚΩ , Vino + 100 ΚΩ R₁ -Oveut

A: Given circuit:

Q: 1.-(60) For the given circuit find: a) Vo (s). 6) Find the values of R's and és frequency response…

A: There can be different solutions for the component values based on what we assume every combination…

Q: A series RLC circuit is described by d²i(t) +R( di(t) +i(t) = 15 dt² dt Find the response when L =…

A:

Q: The field winding of a dynamo may be taken to have a constant inductance of 120 H and an effective…

A: When the supply is interrupted, the current through the inductor is 5 A. As the indicator does not…

Q: The voltage across the terminals of the 5μF capacitor is 30 cos (4000t + 25°) V. Calculate (a) the…

A: The amount of charging a capacitor can do on its capacitance. Capacitive reactance is a measurement…

Q: Consider the RC circuit shown in figure. Find the following: (a) The governing differential equation…

A: Given circuit,

Q: a) V1: c) V3: c) IT: V1 b) V2: d) RT:

A:

Q: (b) For circuit in Figure Q4(b), given that Z₁1 = 40 №, Z₁2 = Z21 = 60 N, Z22 = 80 , Vs 100 V, R₂ =…

A:

Q: 10 Ω 2002 is 20 lb va 12 3 Va E ≤502 13 10 V

A:

Q: The carrier c(t) = 100 cos(2πft) is frequency modulated (FM) by the message signal m(t) = 5 cos(…

A: (1) From message signal mt=ACcos2π104t, the maximum frequency is fm=104 Hz. Determine the modulation…

Q: 2. A balanced delta connected connected to a three-phase, conductors having impedances Zc following,…

A:

Q: In a 8 bit microprocessor, estimate the number of distinct opcodes present.

A: The solution is provided in the following section.

Q: The input to delta modulator is m(t) = 0.01t. The delta modulator operates at a sampling frequency…

A: Given: Input of delta modulator, mt=0.01t Delta modulator operates at sampling frequency, fs=20 Hz

Q: = 3. A balanced delta-connected load, with Z₁ 9.0 L 30° , and a balance wye-connected load with Zy =…

A: In this question,  We need to determine the line currents, powers.  We know  Three phase Complex…

Q: 19. What is the minimum distance required for single error detection according to Hamming's analysis…

A: The solution is provided in the following section.

Q: 8. A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical…

A: Given, A 3-phase induction motor has Slip, s=2%=0.02 Input power, Pin=1000 W

Q: Find the remaining current in amperes using Kirchoff's rule.

A: According to KCL, the algebraic sum of current at a node is zero. It can be stated as " at a node,…

Q: In a 8 bit microprocessor, estimate the number of distinct opcodes present.

A: The detailed calculation along with the explanation is provided in the following section.

Q: b. The circuit shown in figure 8 is the project work that students in Circuit Analysis class last…

A:

Q: What is the percentage voltage drop for a 208V, three-phase feeder serving a load of 200A at a…

A: Given data, Voltage V = 208 V Load current i = 200 A Distance l=290 feet = 88.4 m For 4/0 copper…

Q: Derive the transfer function H(s) = Vo(s)/Vi(s) for the circuit shown. (Hint: consider finding V+/Vi…

A: The given circuit is,

Q: Show how a full adder can be implemented using a decoder.

A: Given: Decoder Required: How a full adder can be implemented using a decoder.

Q: Determine Thevenin equivalent voltage of the following circuit + E. 20 V R₁ • 6Ω 6Ω www R₂- 6Ω R3

A: Given data,

Q: Match the load to the line using a shunt stub: a) Short-circuited b) Open-circuited ZL= 2000 ohms…

A: Step 1 We need to match the load to the line using a shunt stub: a) Short-circuited. b)…

Q: 15 Find i for the circuit shown in Fig. 10-19. HH 0.001 μF 10 cos 106 +21 500 Ω Fig. 10-19 See Prob.…

A: According to superposition theorem, In a linear bilateral network the response through any branch is…

Q: Find the F.T. of the fall wing Signals (functions) f(t) = 3 Sgh (st) - - 1+jt aus: F(W) = {w-ze чпеш…

A:

Q: A transmission line is to be inserted between a 5 Ω line and a 50 Ω load so that there is maximum…

A: The Given transmission line is to be inserted between 5 ohm line and 50 ohm There is maximum power…

Q: 2. Find the marked voltage v. 29V ΠΩ ΖΩ ww V = 20Ω 120ΩΣν 40Ω

A: Given circuit:

Q: A load consisting of a 1.35 kO resistor in parallel with a 405 mH inductor is connected across the…

A: In this question,  We need to determine the average active power, reactive power ,apparent power and…

Q: In a 6-pole DC machine, 90 mechanical degrees corresponds to how many electrical degrees? (a) 270…

A: Given a DC machine has, Total number of poles, P = 6 Mechanical degree, θm=90°

Q: A series RLC circuit is connected to a 400-hZ line with an applied voltage of 35.678 V. The resistor…

A: An RLC circuit consists of a resistor R, an inductor L, and a capacitor C connected either in series…

Q: Two reactors are connected in series across a 10 V, 10 kHz source. They are spaced so that there is…

A:

Q: Q1 Interpolate the sequence x[n] = {3, 6, 7) using the filter h[n] = {0.5, h[0] = 1,0.5} by a factor…

A: Solved using convolution method

Q: For the two-port network below, calculate the value V₂, given 1₁ = 0.052 A and 12 = 0.005 A. 1₂ I₁…

A: Given, A two port network, I1=0.052 AI2=0.005 A

Q: i + 5y2z j + (2xz + 5z2) k at point (-3,-2,-1)?

A:

Q: Find the F.T. of the fall wing Signals (functions) f(t) = 3 Sgh (st) - - ans: F(W) = 6 Sw 1 1+jt…

A: Fourier Transform is used to analyze the frequency response of non periodic signal but nowadays it…

Q: A rectangular camera sensor for an autonomous vehicle has 4000 pixels along the width 2250 pixels…

A:

Q: TO

A:

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.