The uniform solid block in the figure has mass 36.0 kg and edge lengths a = 0.793 m, b = 1.43 m, and c = 0.116 m. Calculate its rotational inertia about an axis through one corner and perpendicular to the large faces. Rotation axis Number i Units

The uniform solid block in the figure has mass 36.0 kg and edge lengths a = 0.793 m, b = 1.43 m, and c = 0.116 m. Calculate its rotational inertia about an axis through one corner and perpendicular to the large faces. Rotation axis Number i Units

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter10: Fixed-axis Rotation

Section: Chapter Questions

Problem 58P: A diver goes into a somersault during a dive by tucking her limbs. If her rotational kindetic energy...

See similar textbooks

Related questions

Q: #11 Electron Volt Measure In #10, recalling that the proton mass is 1.67 × 10-27 kg, what is the…

Q: 4b. -The drag force, F4, acting on a submarine depends on the characteristic length, L, velocity, V…

A: Write the dimensions of the variables. Here, μ is the dynamic viscosity and ρ is the density. Here,…

Q: A space traveler takes off from Earth and moves at speed 0.9700c toward the star Vega, which is…

A: in this question we use simple space motion equation and get answer.

Q: Mass of a car is 230 kg, calculate the weight?

A: Required Weight of the car

Q: Find the equivalent resistance to the combination shown on the right. a 7.6 Ω 502 m 2202 9Ω 302 6Ω…

Q: Europa, one of the moons of Jupiter, was discovered by Galileo in 1610. Europa has a circular orbit…

Q: A cat is standing in a front of a door and then walks 10.5 m towards a tree and then climb 3.5 m to…

A: In this question we use pythagoras theorem and get answer.

Q: A skier traveling 12.5m/s reaches the foot of a steady upward 21.7151 incline and glides 17.25655m…

A: Write the given values with the suitable variables. u=12.5 m/sθ=21.7151°d=17.25655 mv=0 m/s Here, u,…

Q: A projectile is fired at an upward angle of 45.6° from the top of a 342m cliff with a speed of…

Q: a 0.400 kg ball is shot directly upward at initial speed 76.5 m/s. What is its angular momentum…

Q: Object 1 has a greater mass than object 2. a. When a constant force is applied to object 1, it…

Q: 1) The value normally stated when referring to alternating currents and voltages is the: d) peak…

A: As per guidelines we are suppose to answer one question from multiple questions and three subpart…

Q: The speed of ultrasound in human body is 1540 m/s. A procedure is performed with a frequency of 2…

Q: Mass of a car is 230 kg, calculate the weight?

A: Given data : Mass of the car = m Acceleration due to gravity…

Q: • The mass and speed of the three vehicles, A, B, and C, are shown. Rank them from greatest to least…

Q: A sample of bone tissue with a density of (g/cm 1.8). Calculate the velocity of the ultrasound pass…

A: Given : Density = 1.8 g/cm =1.8 ×10-310-2×3 =1800 kg/m Acoustic impedance = 7.38*106 kg.m-2.s-1

Q: A disk of mass 2.00 kg and diameter 50.0 cm is rotating without slipping across a level floor at a…

Q: A sprinter accelerates to his maximum speed in 5 s. He then maintains this speed for the remainder…

Q: The minute hand of a large clock is 0.50 m long. What is the tangential speed of its tip in m/s?

Q: A novice skier with a mass of 72 kg poorly navigates the bunny slopes. The skier reaches the bottom…

A: A force that acts for a very short time is called impulse force. According to Newton's second law…

Q: The figure shows two blocks connected by a cord (of negligible mass) that passes over a frictionless…

Q: n the figure, block 2 (mass 1.40 kg) is at rest on a frictionless surface and touching the end of an…

Q: A boy named Jose walks westward for 5 km and then northward for 5 km and then 5 km southwest. How…

Q: A rectangular solid has a height of 2m, width of 3.5m, and 6m long. How much pressure does it apply…

Q: How fast must a proton move in magnetic field of 2.5 × 10-3 T, such that the magnetic force is equal…

Q: Q/ If F1 = 250 N and F2 = 375 N are two forces, the angle between F1 and the positive y-axis is…

A: given F1 =250 N 300 from positive y axis hence vector form of F1 is F1 →=250sin30 i +250cos 30…

Q: What is the amount of thermal energy to raise the temperature (300g) of aluminum from (15°C) to…

A: Given Mass of aluminum is m=0.300 kg Change in temperature is…

Q: a rigid assembly of a thin hoop (of mass m = 0.25 kg and radius R = 0.19 m) and a thin radial rod…

Q: What is the coefficient of friction of an object with a mass of 80kg and a friction force of 200N.…

Q: A 21 g arrow traveling at 59 m/s hits a target and sinks 11 cm before coming to rest. If the archer…

Q: 4. Conceptual question (Explain your answer): Two objects are at rest on a frictionless surface.…

A: According to work energy theorem, the work done in moving a object is equal to change in its kinetic…

Q: 1- A pilot wishes to reach an airport 350 km from his present position at a heading of N60-E. If the…

Q: A 10-cm-long thin glass rod uniformly charged to 13.0 nC and a 10-cm-long thin plastic rod uniformly…

A: Given: Length of the thin rods L=10 cm, Charge on glass rod Q=13 nC, Charge on plastic rod -Q or -13…

Q: What friction force is required by a 2000kg car's tires turning around a corner with a radius of…

Q: You are working as an intern for a meteorological laboratory. You are out in the field taking…

Q: The diagram below shows four charges at the corners of a square of sides d = 2.00 m. Here, q₂ =q₂ =…

Q: c) Give the components of the unit vector, which we will label u, that points up per- pendicular to…

Q: QUESTION 21 A block of mass M is suspended at rest by two strings attached to walls, as shown in the…

A: Q.11 Kyle's true weight (wo) = 600 N apparent weight (wap) = 500 N Weight is given as :- w = m g…

Q: A 86 kg block is pulled at a constant speed of 8.9 m/s across a horizontal floor by an applied force…

Q: Find the pressure Force=33 N Area=2.5 m2

Q: 5 6. A sample of ideal gas is expanded to twice its original volume of 1.00 m3 in a quasi-static…

Q: The rate at which a body cools also depends on its exposed surface area S. If S is a constant, then…

A: Given: At t=0, initial temperature T=160°F, SBSA=2 (where SA and SB are the exposed surface area of…

Q: = (b) In the figure below, block 1 of mass m₁ slides from rest along a frictionless ramp from height…

Q: 1 A pilot flies on a heading of N40W with an airspeed of 240 km/h. Her actual ground velocity is 250…

Q: Q/ If F1 = 250 N and F2 = 375 N are two forces, the angle between F1 and the positive y-axis is…

Q: Use both ray diagramming and mirror equation. Use ruler for ray diagram An object is placed 26.0 cm…

A: Given that The distance of the object is (u) = -26cm Radius of the…

Q: 7. The dimensions of a rectangular metal bar are 6 cm x 8 cm x 9 cm. density of the bar in gram per…

A: The density is given as D = M/V = 4/(0.06x0.08x0.09) = 9260 kg/m3 Hence the first option is…

Q: 1) Are the wave patterns for various values of Ao and Ak same? If not, why? 2) Comment on the Phase…

A: Disclaimer: “Since you have asked multiple question, we will solve the first question for you. If…

Q: G: st = 38.92-17.59 FN = (90kg ) (9.8 m/s²) = 21.35 = 882w R: a =?, MK = ? A: FF ↑ Ev=Fg [40 Kay +…

A: Newton's 2nd law Newton's 2nd law define the force is equal to the product of mass with the…

Q: Use both ray diagramming and mirror equation. Use ruler for ray diagram please show complete…

A: Ray diagram:

Question

The uniform solid block in the figure has mass 36.0 kg and edge lengths a = 0.793 m, b = 1.43 m, and c = 0.116 m. Calculate its rotational
inertia about an axis through one corner and perpendicular to the large faces.
Rotation
axis
Number i
Units

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A top has moment of inertia 3.2104kgm2 and radius 4.0 cm from the center of mass to the pivot point. If it spins at 20.0 rev/s and is precessing, how many revolutions does it precess in 10.0 s?
A wheel starts from rest and in 12.65 s is rotating with an angular speed of 5.435 rad/s. a. Find the magnitude of theconstant angular acceleration of the wheel. b. Through whatangle does the wheel move in 6.325 s?
A solid cylinder of radius 10.0 cm rolls down an incline with slipping. The angle of the incline is 30 . The coefficient of kinetic friction on the surface is 0.400. What is the angular acceleration of the solid cylinder? What is the linear acceleration?
What three factors affect the torque created by a force relative to a specific pivot point?
A rigid body is rotating counterclockwise about a fixed axis. Each of the following pairs of quantities represents an initial angular position and a final angular position of the rigid body. Which of the sets can occur only if the rigid body rotates through more than 180? (a) 3 rad, 6 rad; (b) 1 rad, 1 rad; (c) 1 rad, 5 rad.
Suppose you start an antique car by exerting a force of 300 N on its crank for 0.250 s. What is the angular momentum given to the engine if the handle of the crank is 0.300 m from the pivot and the force is exerted to create maximum torque the entire time?
A constant torque is applied to a rigid body whose moment of inertia is 4.0kgm2 around the axis of rotation. If the wheel starts from rest and attains an angular velocity of 20.0 rad/s in 10.0 s, what is the applied torque?
A diver goes into a somersault during a dive by tucking her limbs. If her rotational kindetic energy is 100 J and her moment of inertia in the tuck is 9.0kgm2 , what is her rotational rate during the somersault?
If a rigid body has a constant angular acceleration, what is the functional form of the angular position?
A pendulum consists of a rod of length 2 m and mass 3 kg with a solid sphere of mass 1 kg and radius 0.3 m attached at one end. The axis of rotation is as shown below. What is the angular velocity of the pendulum at its lowest point if it is released from rest at an angle of 30 ?
A boy rides his bicycle 2.00 km. The wheels have radius 30.0 cm. What is the total angle the tires rotate through during his trip?
The precession angular velocity of a gyroscope is 1.0 rad/s. If the mass of the rotating disk is 0.4 kg and its radius is 30 cm, as well as the distance from the center of mass to the pivot, what is the rotation rate in rev/s of the disk?