If Block A is 1.6 kg and sphere B is 1.3 kg , L= 1.7 m , and K=332 N/m,Please submit your answer for the problem below in 3 decimal places in meters.13.200block A is pushed up against a spring compressing it a dis-tance x. The block is then released from rest and slides down the 20°incline until it strikessphere B that is suspended frominextensible rope. The spring constant k =K N/m, the coefficient offriction between A and the ground is 0.2, the distance A slides fromthe unstretched length of the spring d= 1.5 m, and the coefficient ofrestitution between A and B is 0.8. Knowing the tension in the ropeis20 N when a= 30°, determine the initial compression x of the spring.k20°fB.Fig. P13.200137CCétvLG

Write down the given values using suitable variables. Here mA signifies block A mass, mB signifies…

the unstretched length of the spring d = 1.5 m, and the coefficient of restitution between A and B is 0.8. Knowing the tension in the rope is 20 N when a= 30°, determine the initial compression x of the spring. 20°f Fig. P13.200

the unstretched length of the spring d = 1.5 m, and the coefficient of restitution between A and B is 0.8. Knowing the tension in the rope is 20 N when a= 30°, determine the initial compression x of the spring. 20°f Fig. P13.200

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

please answer in 20 minutes thank you! A 0.4 kg rubber ball has a horizontal velocity of 1.554 m/s at point A and goes through a projectile motion until it hits a smooth floor at point B. It then bounces off and reaches another peak in its trajectory at point C. The ball hits the smooth floor with an impact which has a coefficient of restitution of 0.8 in a very short span of time. Which of the following best approximates the speed of the ball just after it bounces off the floor for the first time? Which of the following best approximates the value of DISTANCE h?
Badly need in 1hour, thanks! D. In a sport of curling, stone A glides across the ice track and collides with another stone B, as illustrated. Determine their speeds soon after contact if each stone is smooth and weighs 50 lb., and the coefficient of restitution between the stones is 0.75. A has an initial velocity of 9 ft/s, whereas B is at rest. Determine also the time required just after collision for B to slide off the runway 4 ft from the gutter.
A 0.45 kg collar, of negligible size, is attached to a spring having an unstretched length of 190 mm. If the collar is released from rest at A and travels along the smooth guide, what is its speed just before it strikes the stop at B? 200 mm EM - B k = 150 N/m A 400 mm
A 750 kg hammer is used to drive a 2500 kg pile into some loosely packed sand. The hammer is released from a height of 2.5 m above the top of the pile and is seen to rebound to a maximum height of 0.15 m above the point of impact. Determine:(a) the velocity of the pile immediately after impact,(b) the coefficient of restitution, and(c) the average force exerted by the hammer on the pile if the impact takes place over 0.08 s.
A 50,000 lb box car going 25 mi/h is to be hitched to a gondola carrying bulk copper ore (netweight = 100,000 lb). Determine the velocity of both the railroad cars after being hitched if thegondola is initially at rest. Determine the time it takes for both railroad cars to come to rest. μk (Gondola)= 0.30
A 5-kg model rocket is launched vertically and reaches an altitude of 100 m with a speed of 40 m/s at the end of powered flight, time t=5 s. As the rocket approaches its maximum altitude it explodes into two parts of masses mA=1.7 kg and mB=3.3kg. Part A is observed to strike the ground 50 m west of the launch point at t=6 s. Determine the position of part B at that time.
An 8-kg collar slides without friction along a vertical rod as shown. The spring attached to the collar has an undeformed length of 12 cm and a constant of 575 N/m. f the collar is released from rest in the position shown, Determine the velocity if it has moved 20 cm down.
13.189 When the rope is at an angle of a = 30°, the 1-kg sphere A has a speed vo = 0.6 m/s. The coefficient of restitution between A and the 2-kg wedge B is 0.8 and the length of rope I = 0.9 m. The spring constant has a value of 1500 N/m and 0 = 20°. Determine (a) the velocities of A and B immediately after the impact, (b) the maximum deflection of the spring, assuming A does not strike B again before this point.
Principle of Angular Impulse and Momentum To apply the principle of angular impulse and momentum to find final speed and the time to reach a given speed. As shown, ball B, having a mass of 10.0 kg, is attached to the end of a rod whose mass can be neglected. Finding the final speed of the ball If the rod is 0.550 m long and subjected to a torque M=(1.95t2+3.75) N⋅m, where t is in seconds, determine the speed of the ball when t=4.80 s. The ball has a speed of v=2.25 m/s when t=0 Finding the time needed to reach a specific speed If the shaft is 0.250 m long, the ball has a speed of v=2.85 m/s when t=0, and the rod is subjected to a torque M=(3.40t+2.15) N⋅m, where t is in seconds, determine the time it will take for the ball to reach a speed of 5.80 m/s.
A bowling ball is attached to a 4.15-meter long cable and hung from the ceiling. The cable is kept taut and the ball is raised to an initial height of 1.7 meters above the classroom floor. It is released from rest and allowed to swing as a pendulum. Determine its speed (in m/s) when it is at a height of 1.27 meters above the floor.
Rockfalls can cause major damage to roads and infrastructure. To design mitigation bridges and barriers, engineers use the coefficient of restitution to model the behavior of the rocks. Rock A falls a distance of 20 m before striking an incline with a slope of a = 40°. Knowing that the coefficient of restitution between rock A and the incline is 0.2, determine the velocity of the rock after the impact.
A block A of 60.0 lb is connected to a block B of 10.0 lb by means of a rope and an ideal pulley. The system is released from rest. Between block A and the surface, there is a coefficient of kinetic friction of 0.10. Block A has descended 5.00 ft. At this moment, determine: a. The displacement of block B.b. The magnitude of the tension in the rope.c. The speed of block B.d. The speed of block A.