The velocity profile in a fully developed laminar flow of water at 40°F in a 250-ft-long horizontal circular pipe, in ft/s, is given by u(r) = 0.8(1 - 625r2), where r is the radial distance from the centerline of the pipe in ft. Determine (a) the volume flow rate of water through the pipe, (b) the pressure drop across the pipe, and (c) the useful pumping power required to overcome this pressure drop.

Q: In fully developed laminar flow in a circular pipe, the velocity at R/2 (midway between the wall…

A: Given : The velocity at r from the center line, V r =13 m/s here, r=R/2

Q: Consider fully developed flow in a circular pipe with negligible entrance length effects. Assuming…

A:

Q: Water at 10°C (? = 999.7 kg/m3 and ? = 1.307 × 10−3 kg/m·s) is flowing steadily in a…

A: The temperature of water is T = 10°C = (10°C + 273) K = 283 K The density of water ρ = 999.7 kg/m3…

Q: Consider the fully developed flow of glycerin at 40°C through a 70-m-long, 4-cm-diameter,…

A: Given data as per question Length of pipe = 70 m Diameter = 4 cm Velocity of fluid = 6 m/s Density…

Q: HW Pressure Drop in a Pipe Water at 60°C is flowing by pump in a 0.0015-m-diameter 0.5-m-long pipe…

A: Given: T= 60o C Pipe diameter, d=0.0015 m length of the pipe, L=0.5 m average velocity, v=0.5 m/s…

Q: The velocity profile in fully developed laminar flow in a circular pipe, in m/s, is given by u(r) =…

A: Given data  velocity profile of the flow in pipe as  To determine  Radius of the pipe Average…

Q: Heated air at 1 atm and 30∘∘C is to be transported in a 150-m-long circular plastic duct at a rate…

A:

Q: Someone claims that the shear stress at the center of a circular pipe during fully developed laminar…

A: This claim is true as the shear stress at the center of a circular pipe during fully developed…

Q: What is the operating principle of variable-area flowmeters (rotameters)? How do they compare to…

A: It consists of a vertical pipe, which is tapered downward. The  fluid flow passes from the bottom to…

Q: Consider the flow of oil with p = 870 kg/m² and u = 1.03 kg/m-s in a 3-cm-diameter, 1.5-m-long…

A: Given data:  density, ρ=870 kg/m3 dynamic viscosity, μ=1.03 kg/m-s diameter, d = 3 m = 0.03 m…

Q: water at 4-degree centigrade ( ρ=998 kg/m3 and μ=1.52 *10-3pa.s) is flowing steadily through a 3mm…

A: Given data:

Q: Ol at 20°C (p = 888.1 kg/m² and u = 0.8374 kg/m - s) is flowing steadily in a 1.25 cm-diameter,…

A:

Q: Air at 1 atm and 20°C is to be transported in a 60-m-long circular steel duct at a rate of 5100…

A: The properties of air at 20 degrees Celsius are: The flow of the air is The diameter of the pipe…

Q: w in

A: given: Why does the friction factor increase as the velocity decreases in a laminar flow in a pipe?

Q: Gasoline (? = 680 kg/m3 and ? = 4.29 × 10−7 m2/s) is transported at a rate of 240 L/s for a distance…

A:

Q: In the fully developed region of flow in a circular pipe, does the velocity profile change in the…

A: Let the fluid flowing through a tube. As the fluid flows through the tube boundary layer occurs. The…

Q: Liquid ammonia at -20°C is flowing through a 20-m-long section of a 5-mm-diameter copper tube at a…

A: Write the given information. Write the properties of ammonia at -20°C. Write the expression of the…

Q: Water at 10°C (ρ = 999.7 kg/m3 and μ = 1.307 × 10−3 kg/m·s) is flowing steadily in a 0.14 cm…

A: Given data as per question ρ = 999.7 kg/m3  μ = 1.307 × 10−3 kg/m·s Average velocity of 1.0 m/s…

Q: The water at 20°C in a 10-m-diameter, 2-m-high aboveground swimming pool is to be emptied by…

A: Given Data: The temperature of water is T = 20°C. The diameter of pool is D = 10 m. The height of…

Q: In fully developed laminar flow in a circular pipe, the velocity at R/2 (midway between the wall…

A: Given data as per the question the velocity at R/2 = 11 m/s

Q: The components of an electronic system are located in a 1.8-m-long horizontal duct whose cross…

A: Given:- k=0.02717W/m.k Ts=65Tf=30 To find:- Total power rating of the electronic devices that can be…

Q: Oil at 20°C is flowing steadily through a 6-cmdiameter 33-m-long pipe. The pressures at the pipe…

A: The problem can be analysed using Bernaulli's principle and the maximum discharge is used to predict…

Q: Water at 10°C is flowing steadily in a 0.12 cm diameter, 15 m long horizontal pipe at an average…

A:

Q: 9. Two tanks filled with water (10 °C) at the same level are connected to each other with a…

A:

Q: Water at 158°C (r = 999.1 kg/m3 and μ = 1.138 x 10-3 kg/ms) is flowing steadily in a 30-m-long and…

A:

Q: What are the factors that affect the value of Friction factor in Laminar flow and Turbulent flow?

A: There are some factors on which friction factor depends :

Q: A 6cm diameter horizontal water pipe expands to a 10cm diameter pipe. The average velocity and…

A:

Q: Water at 60F (ρ = 62.36 lbm/ft3 and μ = 7.536 x10 -4 lbm/ft·s)  is flowing steadily in a…

A:

Q: Q1: Consider the flow of oil with p = 894 kg/m' and u = 2.33 kg/m.s in a 40-cm- %3D diameter…

A:

Q: The water at 20°C in a 10-m-diameter, 2-m-high aboveground swimming pool is to be emptied by…

A: Write the properties of water at 20°C. Write the value of the roughness of the pipe.

Q: The air in a 5-m × 5-m × 3-m hospital room is to be completely replaced by conditioned air every 15…

A: Given: The time of the air replacement is t=15 min. The average air velocity in the duct is v=5 m/s.…

Q: The velocity profile in fully developed laminar flow in a circular pipe of inner radius R = 4 cm, in…

A: given data as per the question Radius of pipe = 4 cm Velocity profile in fully developed laminar…

Q: Glycerin at 40°C with ? = 1252 kg/m3 and ? = 0.27 kg/m·s is flowing through a 6-cm-diameter…

A: Given data: The density of glycerine, ρ = 1252 kg/m3. The dynamic viscosity, μ = 0.27 kg/mˑs. The…

Q: A highly viscous liquid discharges from a large container through a small-diameter tube in laminar…

A: Write the expression of Reynold’s number. For laminar flow, write the expression of the friction…

Q: Someone claims that in fully developed turbulent flow in a pipe, the shear stress is a maximum at…

A: Yes agree with this claim

Q: Heated air at 1 atm and 35°C is to be transported in a 150-m-long circular plastic duct at a rate of…

A: given data P = 1atm T = 35 C L = 150 m Q = 0.35 m3/sec Head loss = 20 m

Q: Heated air at 1 atm and 100F is to be transportedin a 400-ft-long circular plastic duct at a rate of…

A: Given: The length of the circular duct, L = 400 ft The volumetric flow rate through duct, Q = 12…

Q: Consider fully developed flow in a circular pipe with negligible entrance effects. If the length of…

A:

Q: Consider an air solar collector that is 1 m wide and 5 m long and has a constant spacing of 3 cm…

A: Given:w=1 ml=5 mb=3 cm =0.03 mTi=30°CQ=0.15 m3/sTavg g=20°CTavg c=60°C

Q: Water at 10°C (ρ = 999.7 kg/m3 and μ = 1.307 × 10−3 kg/m·s) is flowing steadily in a 0.015 m…

A:

Q: Which has a greater minor loss coefficient during pipe flow: gradual expansion or gradual…

A: Which has a greater minor loss coefficient during pipe flow: gradual expansion or gradual…

Q: In a laminar flow through a circular tube of radius of R, the velocity and temperature profiles at a…

A: The expression for bulk fluid temperature is given by : Where R= radius of circular tube,…

Q: What fluid property is responsible for the development of the velocity boundary layer? For what…

A: The viscosity is the property which is responsible for the development of the velocity boundary…

Q: Why are liquids usually transported in circular pipes?

A: Mostly, we can see that the fluids are transported through circular pipes. This is because of the…

Q: Determine the expected Fanning friction factor for water at 28 degrees Celsius flowing through a…

A:

Q: Air at 1atm, 35 degree celcius (ρ = 1.145 kg/m3 and μ = 1.895 x 10-5 kg/m.s) and average velocity of…

A:

Q: Heated air at 1 atm and 35°C (ρ= 1.145 kg/m3 and μ= 1.895 X10-5 kg/m · s )is to be transported in a…

A:

Q: Water at 10°C (ρ = 999.7 kg/m3 and μ = 1.307 × 10−3 kg/m·s) is flowing steadily in a 5 -cm-…

A: (a) In this problem, the velocity of the flow is not given but the flow is steady, therefore, it is…