The volume of an E. coli cell is approximately 1 µm^3. Calculate the number of water molecule that could fit inside this volume. Assume pho(H2O)= 1.00 g cm^-3

Q: 1. NaOMe, MeOH + MEOH 2. acidic workup MeO D

A: Interpretation -  To fill the reactant in the given reaction which is above given in the question .…

Q: An anion has an equilibrium potential of -40 mV. What direction are the chemical and electrical…

A: Given, equilibrium potential of an anion is -40mV. membrane potential of the anion is -70mV. How the…

Q: % solute 98% water 5% solute % water :: hypertonic : isotonic : hypotonic : water moves into cell :…

A: Hypertonic - solution contains more dissolved solute than normal cell. Isotonic solution - contains…

Q: It is defined as the Conductance of one gram equivalent of solute contained between electrodes…

A:

Q: Given 2.98 M concentration, do you expect it to be isotonic, hypotonic, or hypertonic with a…

A:

Q: The concentration of an unknown protein sample was determined as 6.6 mg/ml. Calculate the…

A:

Q: A surface ocean current has a flow rate of 6.9 x 107 m3 per second.  The current is 105 km wide by…

A: The surface area of the ocean current can be calculated as follows-

Q: If    30    g    of    NaCl    are    dissolved    in    water    to    a    final    volume    of…

A:

Q: In coulometric tritration, a constant _____ generates the ____ electrolytically. a) current,…

A:

Q: You have 6 mL of cells you need to treat with Hydrogen Peroxide (H2O2), such that the final…

A: A question based on volumetric analysis for which the required volume of H2O2 from the stock is to…

Q: Starting a titration, the technician requires 200mL of a 0.22% (w/v) solution of citric acid,…

A:

Q: Assume that all solution were prepared at 25℃, and the solutes were completely dissolved. Alcoholic…

A:

Q: Explain why a dialysis solution must have a low sodiumion concentration if it is designed to remove…

A:

Q: Choose the substance that is classified correctly? O AIBR3 is a basic salt in aqueous solution O…

A: Potassium nitrate ( KNO3 ) is neither a acid or base it is neutral.

Q: Write a procedure with diagrams (Lab diagrams showing lab equipments) for the preparation of the…

A:

Q: we are making a serial dilution of HCl and NaOH; what does this mean?

A: Serial dilution is a process in which the acid or base or any other solute is diluted multiple times…

Q: Describe what occurs during the dissociation of NaCl inwater. What occurs when glucose (C6H12O6 )…

A: Electrolytes dissociate into their constituent ions when they are dissolved in water. Electrolytes…

Q: Potassium permanganate, KMnO4, is both effective at treating water and has medicinal uses. A certain…

A: We have to calculate the molar concentration of Potassium permanganate .

Q: A litter of solutions contain 70% v/v of ethanol in water. The specific volume of ethanol is 1.235.…

A: Volume by volume percentage means (v/v%), volume of solute present in a given volume of solution…

Q: In the phosphate analysis of a wastewater sample, 30.00 mL of the original sample was taken and…

A:

Q: OH + HqO OH OH OH но OH HO OH OH OH OH OH

A: The reaction is the type of hydrolysis. First oxygen abstract the proton from the water then…

Q: How many grams of potassium hydroxide, KOH , are required to make a 4.77 %(w/v) aqueous solution in…

A: Given :- % w/v = 4.77 %                Volume of solution = 250 mL  To calculate :- mass of KOH (in…

Q: If the pH of a microorganism is 9.1, what is the [H+] concentration

A: By looking ph value we can tell us which compound is acid or basic or neutral.  PH =7 -Neutral ph…

Q: The protein we are using in this experiment is called bovine serum albumin. The molecular weight of…

A: Concentration of BSA solution = 2.0 mg /mLConcentration of BSA solution =2.0 × 10-3 g× 10-3 L = 2.0…

Q: You are provided wiht a stock solution of 80 mM ATP. How much of this solution do you need to add to…

A: Dilution formula :- When a solution of concentration C1 and volume V1 is diluted by adding water to…

Q: In Canada and the United Kingdom, devices that measure blood glucose levels provide a reading in…

A: Concentration is equal to the ratio of the number of moles to the volume of the solution. Its unit…

Q: Prepare 250 mL of a stock solution that is 25 mg/L Fe, using the iron reagent ferrous ammonium…

A: To prepare 250 mL stock solution of Fe(NH4)2 (SO4)2•6H2O. Strength given = 25 mg/L = 0.025 g/L

Q: Standard solution used in nonaqueous alkalimetry: a. hydrogen bromide b. sodium hydroxide c.…

A:

Q: * 60% iPad 2:23 PM + openvellum.ecollege.com Search Textbook Solutions | Chegg.com 61%iPad2:20…

A: The conditions under which the process of crenation takes place are to be described.

Q: Calculate the volume of 4.0 M KOH necessary to dissolve 1.0 g of Al metal according to Al(s) + 2…

A: Given, 4.0 M KOH 1.0 g of Al metal Molar mass of Al metal is 26.981539 g/mol Mole of 1.0 g of Al…

Q: Suggest a reason why amino acids are usually more soluble at pH extremes than they are at neural pH.

A: The substances than contain amino group,carboxylic acid group,hydrogen atom and one alkyl group on…

Q: Enumerate and differentiate briefly the different forms of calcium in the blood. EXPLAIN 3-5…

A: Answer - According to the question - In blood calcium exists in 3 different forms : (1) 50% as…

Q: Assume that potatoes contain very low concentrations of salt.  In which direction did the sodium…

A: Diffusion is the process in which the ions travel from high concentration to low concentration.

Q: Which one of the following aqueous solutions shows the poorest electrical conductivity? A. 1 M NaCl…

A: Strong electrolytes: The strong electrolytes dissociate completely in the aqueous solution. Strong…

Q: 10-Analytical Molarity, Autoprotolysis, Amphiprotic solvent, Conjugate acid, Buffer solution,…

A: Definitions Analytical Molarity- It is the total no of moles of solute present in 1L of a solution.…

Q: What is the measurement in terms of appropriate si for a red blood cell that measured 0.0000071 m

A:

Q: The concentration of CaF2 in an aqueous solution is measured to be 0.056 M. Calculate the…

A:

Q: Given the abserbances following 0.074 1H 2) 0.215 3) 0.344 4) 0.473 5) 0.277 How to find %T for…

A: Given : Different absorbance values. To Find : % transmittance i.e % T.

Q: 14.10)  What is the molar absorptivity of a solute that absorbs 86% of a certain wavelength of light…

A: Apply Beer-Lambert's law to calculate the molar absorptivity

Q: Choose the substance that is classified correctly? O NH,CI is a neutral salt in aqueous solution O…

A:

Q: A student prepares a saturated solution by dissolving 5.5 x 10-5 mol of Mg(OH)2 in 500.mL of…

A: Given is A 500 mL solution containing 5.5×10–5 mol of Mg(OH)2 . We need to calculate its solubility…

Q: convert glucose concentration in g/100ml from 0.144mM

A: The given information is: Concentration of Glucose = 0.144mM Converting mM to M: 1 mM = 0.001 M…

Q: Write the reaction of PCl5 with heavy water.

A: Phosphorous pentachloride has chemical formula PCl5 and it is a pale greenish-yellow solid color…

Q: percent (w/v) concentration

A:

Q: How much protein do you need to add to the 800 µL buffer in the first microcentrifuge tube to make a…

A: Given : Dilution = 1:5 The volume of buffer solution = 800µL  1:5 dilution means 1 part protein and…

Q: An iron - salicylate solution has a concentration of 5.92 x 10-4 M.  It was prepared by taking 2.00…

A:

Q: In the phosphate analysis of a wastewater sample, 30.00 mL of the original sample was taken and…

A:

Q: A Sodium concentration in Horse Urine of more than 20 mEq of Sodium per 1 Liter of Horse Urine is…

A: Introduction: Sodium with atomic symbol Na belongs to group one elements. It's an alkali metal with…

Potentiometric Titrations

Potentiometric titration is one of the important titration methods and is mainly carried out to characterize acid solutions. It follows a method similar to that of the normal titration technique, but the main difference is that there is no indicator used in the potentiometric titrations. Instead of using an indicator, electrodes are employed for monitoring the whole titration process. A scientist named Robert Behrend did the potentiometric titration for the first time, and it was done using the mercurous solution and potassium chloride.