The wagon and the girl, shown in the following figure, has a weight of 100 N located at the center of gravity G. The front wheel is free to roll; the coefficient of friction for the rear wheel at 'A' is HA. If the applied force F = 50 N will cause the system just to move, the friction force at 'A' is: F (50 N) 30° G 1 m 1 m 0.5 m '0.5 m

The wagon and the girl, shown in the following figure, has a weight of 100 N located at the center of gravity G. The front wheel is free to roll; the coefficient of friction for the rear wheel at 'A' is HA. If the applied force F = 50 N will cause the system just to move, the friction force at 'A' is: F (50 N) 30° G 1 m 1 m 0.5 m '0.5 m

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter10: Fixed-axis Rotation

Section: Chapter Questions

Problem 26CQ: If you were to stop a spinning wheel with a constant force, where on the wheel would you apply the...

See similar textbooks

Similar questions

If you were to stop a spinning wheel with a constant force, where on the wheel would you apply the force to produce the maximum negative acceleration?
A man stands on a merry-go-round that is rotating at 2.5 rad/s. If the coefficient of static friction between the man’s shoes and the merry-go-round is μS = 0.5 , how far from the axis of rotation can he stand without sliding?
A man stands on a merry-go-round that is rotating at 2.13 rad/s. If the coefficient of static friction between the man's shoes and the merry-go-round is ?s = 0.63, how far from the axis of rotation can he stand without sliding? (Enter the maximum distance in meters.) m
A person pushing a uniformly‑loaded 51.7 kg51.7 kg wheelbarrow of length ?L with pushing force ?⃗ P→ is attempting to get it over a step. The maximum horizontal force that the person can apply is ??=681 N.Px=681 N. What is the maximum height ℎh of the step, expressed as a fraction ?n of the wheel's radius ?R, that the person can get the wheelbarrow over? The gravitational acceleration is ?=9.81 m/s2.
An athlete at the gym holds a 3.0 kg steel ball in his hand. His arm is 70 cm long and has a mass of 4.0 kg. What is the magnitude of the gravitational torque about his shoulder if he holds his arma. Straight out to his side, parallel to the floor?b. Straight, but 45° below horizontal?
Of the two frictionless inclined planes with slopes of 30 ° and 53 °, masses m1 = 4kg on the first and m2 = 2kg on the second. These two masses are attached to the two ends of a rope passing through a reel of radius R = 50cm and moment of inertia I = 2 kg m2. Find the accelerations (the linear accelerations of the masses and the angular acceleration of the pulley) and the stresses in the rope. NOTE: The reel is rotating, the tensions in the rope are not equal.
At the local playground, a 21-kg child sits on the right end ofa horizontal teeter-totter, 1.8 m from the pivot point. On the leftside of the pivot an adult pushes straight down on the teeter-totterwith a force of 151 N. In which direction (clockwise or counterclockwise) does the teeter-totter rotate if the adult applies the forceat a distance of (a) 3.0 m, (b) 2.5 m, or (c) 2.0 m from the pivot?
What is the MAXIMUM (linear) speed at which a turntable (r=32.7 cm) can spin for a 54-gram mass NOT to slide off if the coefficient of friction is μ =0.21?
A person pushing a horizontal, uniformly loaded, 27.15 kg27.15 kg wheelbarrow of length ?L is attempting to get it over a step of height ℎ=0.370?,h=0.370R, where ?R is the wheel's radius. The center of gravity of the wheelbarrow is in the center of the wheelbarrow. What is the horizontal component ??Px of the minimum force ?⃗ P→ necessary to push the wheelbarrow over the step? The gravitational acceleration is ?=9.81 m/s2.
A person pushing a horizontal, uniformly loaded, 20.35 kg wheelbarrow of length ?L is attempting to get it over a step of height,h=0.370R, where R is the wheel's radius. The center of gravity of the wheelbarrow is in the center of the wheelbarrow. What is the horizontal component Px of the minimum force P→ necessary to push the wheelbarrow over the step? The gravitational acceleration is ?=9.81 m/s2.
In a popular amusement park ride, a rotating cylinder of radius 3.00 m is set in rotation at an angular speed of 5.00 rad/s, as in Figure P7.75. The floor then drops away, leaving the riders suspended against the wall in a vertical position. What minimum coefficient of friction between a rider’s clothing and the wall is needed to keep the rider from slipping? Hint: Recall that the magnitude of the maximum force of static friction is equal to μsn, where n is the normal force—in this case, the force causing the centripetal acceleration.
The two balls are attached to the light rigid rod, which is suspended by a cord from the support above it. If the balls and rod, initially at rest, are struck with the force F = 11.5 lb, calculate the magnitudes of the corresponding acceleration of the mass center and the rate at which the angular velocity of the bar is changing.