The wattage marked on a lightbulb is not an inherent property of the bulb, but depends on the voltage to which it is connected, usually 110 or 120 V. How many amperes flow through a 60-W bulb connected in a 120-V circuit?

The wattage marked on a lightbulb is not an inherent property of the bulb, but depends on the voltage to which it is connected, usually 110 or 120 V. How many amperes flow through a 60-W bulb connected in a 120-V circuit?

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter23: Series And Parallel Circuits

Section: Chapter Questions

Problem 40A

See similar textbooks

Related questions

Q: If a microwave is determined to use 854 W of power on a 120 V circuit, how many amperes does it need…

Q: What happens to the current in a circuit if a 10Ω resistor is removed and replaced by a 20Ω…

Q: The parallel combination of a 330 ohm resistor and a 470 ohm resistor is in series with the parallel…

Q: Why does the V/I ratio of an electric circuit indicate its ability to oppose electric current rather…

Q: 10.0 Q 3.50 10.0 Q 14.0 V | 1.7 Q 3.0 Q

Q: The electric power of a lamp that carries 2-A at 120-V is

A: electric power = Current x voltage electric power of a lamp = (2A) x (120V) electric power of a…

Q: The total conductance of the circuit shown in Fig. 8 is: 10 2 22 12 ww 013 S 01.6 S 06 S 0 2.5 S…

Q: A light bulb is rated at 30 W when operated at 120 V. How much charge enters (and leaves) the light…

A: Given, P= 30 W V= 120 V t= 2.1min = 2.1*60= 126 sec

Q: If a circuit had a very high Voltage, and a very low c very high resistance very low resistance O no…

Q: Calculate the current flowing through a resistor of 10 ohm when a potential difference of 140 v is…

A: According to Ohm's law te relation between current,voltage, and resistance is, I=VR…

Q: One of these statements describes the relation between the resistance of the light bulb and the…

A: Explanation: The resistance is a measure of the opposition to the flow of the electric current, the…

Q: C = 2pF C3 = 20pF C2 = 4pF C5 = 8pF C4 =10pF C6 =12PF

Q: Why Does The Resistance Of A Conductor Increase With An Increase In Temperature?

A: The resistance of a conductor increases with an increase in temperature because the thermal velocity…

Q: Two lightbulbs are each connected to a voltage of 120 V. One has a power of 25 W, the other 100 W.…

A: Given data: Two lightbulbs are each connected to the voltage of, V= 120 V The power of the first…

Q: A light bulb marked “73 W at 120 V” is screwed into a socket at one end of a long extension cord, in…

A: The bulb, conductors and the 120-V outlet are all connected in series. Resistance in the bulb

Q: An electric heater works by passing a current of 100 A though a coiled metal wire, making it red…

A: Given i = 100 A , R = 1.1 ohms By ohm's law V = iR

Q: The total conductance of the circuit shown in Fig. 8 is: 10 S2 www 2Ω ww 192 www Fig.8

A: From the given figure, R1 = 10 ΩR2 = 2 ΩR3 = 1 Ω

Q: The resistance of an electric heater is 40 ohms when connected to 240 V. How much energy does it use…

A: The power of the electric heater is given by P=V2R…

Q: Two light bulbs both operate from 120 V. One has power of 25 W and the other 100 W. Which bulb has…

A: Write the given values of the problem- Two light bulbs both operate=120 V Power One=25 W second=100…

Q: Of what material is a resistor made if its resistance is 40.0% greater at 100°C than at 20.0°C?

A: Given, Resistance is 40.0% greater at 100°C than at 20.0°C Let T1=20 c T2=100c Resistance at 20c=Ro…

Q: Each resistor in the circuit shown in the drawing has the same resistance R, and the batteries have…

A: Given Resistance of each resistor is R=9.0 Ω Voltage is V= 9.0 V Find the total resistance and the…

Q: What is the resistance of an automobile headlight through which 2.50 A flows when 12.0 V is applied…

Q: Which element in the circuit prevents the voltage from reaching critical value in spite of a much…

A: Given, A circuit To determine which element prevents voltage from reaching critical value

Q: A light bulb marked "75 W at 120 V" is screwed into a socket at one end of a long extension cord, in…

A: The resistance across bulb is, The net current through the circuit is,

Q: What is the total voltage of four 1.5 V batteries when they are connected in a) series & b)…

Q: If a electrician measures the current of a circuit to be 100 Amps and the circuit is only designed…

A: According to Ohm's law, the current flowing in a circuit is directly proportional to the voltage…

Q: A potentiometer wire of length 1m is connected to a driver cell of emf 3 V as shown in the figure.…

Q: Four 2.2 V cells are connected in series to a 8.0 N light bulb. If the resulting current is 0.75 A,…

Q: What happens to resistance of a conductor as the conductor is made thicker?

Q: A light bulb is rated at 30 W when operated at 120 V. How much charge enters (and leaves) the light…

Q: The equivalent resistance of three resistors R1=R,=R3=2 Q connected in series is 6Ω A) 8 Ω 1/6 O

A: Given: The connection of the resistors is in series. The value of the resistance is R1=R2=R3=2 Ω

Q: Electric heater is used to heat 0.63 liters/minute of 3. water (c, = 4.18 kJ/kg.K, density =1000…

A: 0.63lit=0.00063m3Mass of 0.00063m3=0.00063m3×1000kg/m3=0.63kg Heat reqired to raise the temperature…

Q: A person plugged in a 1250 W hair dryer and a 2500 W electric heater in the same 120 V outlet…

Q: An extension cord made of two wires of diameter 0.129 cm (no. 16 copper wire) and of length…

A: Write the expression for the power dissipated. Here I is the current, and R is the resistance. The…

Q: A 35 volt battery is connected purely in series in parallel or in series to three resistors. Two…

A: Given battery voltage V = 35 V two resistor of 3 ohm and 17 ohm and third is unknown Equivalent…

Q: why is it important to refer to "equivalent" resistance rather than "total" resistance?

A: First, we will define Resistance: Resistance is a measure of the opposition to current flow in an…

Q: An electric washing machine draws 2.1 A when connected to a 121 V power line. In Arkansas, the…

A: The power consumed by the washing machine can be found as, Here, V and I, represent the voltage of…

Q: 12 V 2.0 2

Q: A load in an electrical circuit has a voltage of 120V and a resistance of 100.0 ohms. How many…

A: Ohm's law is given by, V=IR Here, V is voltage, I is current and R is resistance. Given : V=120…

Q: You have two identical light bulbs one connected to a 110 V source and one connect it to a 220 V…

Q: A 60v dry with an internal resistance of 0,16 is used in a circuit when the circuit is closed the…

A: Given data: Emf, E=60 V Internal resistance, r=0.16 ohm Terminal voltage, V=5.8 V Our question is…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

(a) What advantage does 120-V operation offer over 240 V? (b) What disadvantages does it have?
Show that if two resistors R1and R2are combined and one is much greater than the other (R 1 >>R 2 ): (a) Their series resistance is very nearly equal to the greater resistance R 1. (b) Their parallel resistance is very nearly equal to smaller resistance R2.
A short circuit in a 120-V appliance cord has a0.500- resistance. Calculate the temperature rise of the2.00 g of surrounding materials, assuming their specific heat capacity is 0.200cal/gC and that it takes 0.0500 sfor a circuit breaker to interrupt the current. Is this likely to be damaging?
An office worker uses an immersion heater to warm 250 g of water in a light, covered, insulated cup from 20.C to 100. C in 4.00 minutes. The heater is a Nichrome resistance wire connected to a 120-V power supply. Assume the wire is at 100. C throughout the 4.00-min time interval. (a) Calculate the average power required to warm the water to 100. C in 4.00 min. (b) Calculate the required resistance in the heating element at 100. C. (c) Calculate the resistance of the heating element at 20. C. (d) Derive a relationship between the diameter of the wire, the resistivity at 20. C, 0, the resistance at 20. C, R0, and the length L. (e) If L = 3.00 m, what is the diameter of the wire?
The average television is said to be on 6 hours per day. Estimate the yearly cost of electricity to operate 100 million TVs, assuming their power consumption averages 150 W and the cost of electricity averages 12.0 cents/kW h .