GRESA FORMAT AND FBD THANK YOU The wires of our appliances areinsulated with a material mixed withrubber, which has a very high resistivity.If a certain wire has a length of 2.5m,the outer diameter is 5mm and its innerdiameter is 0.5mm, what isresistance?itsNotethat theinnerSelf-Paced lometer is presont to loove a holowPracticeProblem 7.2place where the conducting wire(usually copper) is present.A resistor with color bands blue-red-green-yellow-gold has alength of 5cm. If the material ismade out of carbon, how muchmaterial (in terms of volume) ispresent in this resistor? If you aregoing to change the carbon toglass, how much smaller would itbe? (Note, take the lower limit ofthe final resistance and theSelf-PacedPracticeProblem 7.3resistivity constant of carbonand glass) High-end headphones (such as thelikes of Audeze and HiFiMan) havea such high impedance comparedto earbuds. If a neodymium driverof a headphones have a diameterof 40mm and a thickness (notethat this is a flat cylinder) of 2mm,how much higher is its resistancecompared to an earbuds with adiameter of 10mm and thickness ofSelf-PacedPracticeProblem 7.4Imm. (p = 110 x 10-70m)

Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

The wires of our appliances are insulated with a material mixed with rubber, which has a very high resistivity. If a certain wire has a length of 2.5m, the outer diameter is 5mm and its inner diameter is 0.5mm, what is resistance? its Note that the inner Self-Paced Practice Problem 7.2 diameter is present to leave a hollow place where the conducting wire (usually copper) is present.

The wires of our appliances are insulated with a material mixed with rubber, which has a very high resistivity. If a certain wire has a length of 2.5m, the outer diameter is 5mm and its inner diameter is 0.5mm, what is resistance? its Note that the inner Self-Paced Practice Problem 7.2 diameter is present to leave a hollow place where the conducting wire (usually copper) is present.

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 9.4CYU: Check Your Understanding The current density is proportional to the current and inversely...

See similar textbooks

Similar questions

A piece of material with a square cross-section measuring 1 mm on each side has a length of 1 m. What is the resistance of this material if it were made of aluminium? Fused quartz? Finally, calculate the current through each piece of material if a potential difference of 1 volt is applied over its length.
How many different resistance valuescan be created by combining three unequal resistors? (Don’t count possibilities in which not allthe resistors are used, i.e., ones in which there iszero current in one or more of them.)
If a wire is stretched to double its original length without lossof mass, how will the resistivity of the wire be influenced?
Two wires have the same resistance and radius. If the wires are made of silver and iron with resistivities respectively of 1.59 ✕ 10−8 Ω · m and 10.0 ✕ 10−8 Ω · m, determine the ratio of their lengths. LAg LFe =
Assuming a constant temperature coefficient of resistivity, what is the maximum percent decrease in the resistance of a constantan wire starting at 20.0ºC ?
The amount of charge that passes through a system is given by Q(t), measured in coulombs. Current isthe rate at which the charge flows through the system, and it’s given by I(t), measured inamperes (also known as coulombs per second). If the current is modeled by I(t) = 9t^2+2t+3for t ≥ 0, how much charge passes through the surface after 8 seconds?
KINDLY ANSWR IMMEDIATELY, THANKYOU FOR HELPING OUT The internal resistance of 6.4 V storage battery is 4.8 milliohm. What is the theoretical maximum current on short circuit?( In practice the leads and connections have some resistance and this theoretical value would not be attained.) CHOICES: A. 3.1 kA B. 1.3 kA C. 3.1 A D. 1.3 A
A cylindrical resistor is to be constructed so that it offers the same resistance whether the current is in radial or axial direction. What should be the length, in millimeters, if the inner and outer diameters were specified to be 19.88 centimeters and 9.10 centimeters, respectively
What is the resistance of a copper bus bar 9.15 meter long and 7.62 cm by 1.27 cm in cross section? Use 1.78 μΩ-cm specific resistance for copper.
A certain flashlight is connected to a 6.0-Vemf battery and has an internal resistance of 0.100. What power does the 0.500 M load dissipate? If the internal resistance grows to 0.400 2, what is the new current, terminal voltage, and power dissipated by a 0.500 M load resistance?
A 500-W heating coil designed to operate from 110 V is made of Nichrome wire 0.500 mm in diameter. (a) Assuming the resistivity of the Nichrome remains constant at its 20.0°C value, find the length of wire used. (b) What If? Now consider the variation of resistivity with temperature. What power is delivered to the coil of part (a) when it is warmed to 1 200°C?
Two wires have the same resistance and radius. If the wires are made of iron and gold with resistivities respectively of 10.0 ✕ 10−8 Ω · m and 2.44 ✕ 10−8 Ω · m, determine the ratio of their lengths. LFe LAu = ?