These re process in a water treatment plant except: a. Collection of water from watershed b. Coagulation c. filtration d. sedimentation 2.) Which of the following is the fastest way by which you can get safe drinking water? a. Boiling b. Collecting rainwater c. forest d. watershed and dam 3.) Which of the following does NOT help collect and or store water? a. Aquifer b. Concrete roads and parking lots c. forest d. watershed and dam

These re process in a water treatment plant except: a. Collection of water from watershed b. Coagulation c. filtration d. sedimentation 2.) Which of the following is the fastest way by which you can get safe drinking water? a. Boiling b. Collecting rainwater c. forest d. watershed and dam 3.) Which of the following does NOT help collect and or store water? a. Aquifer b. Concrete roads and parking lots c. forest d. watershed and dam

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Dear I need solution for this problem also The system of two basins shown in the picture, full flow stream 3785x1000 l/day in which the concentration of non-conservative pollutant is 20mg/l. The rate of decomposition of a non-conservative pollutant is 0.3/day. The volume of the first pool is 18925x1000 l and the second one is 11355x1000 l. Assuming complete mixing in each basin, determine the concentration of the non-conservative pollutant that leaves the individual basins. Please se attachemnt . Thank You very much
Problem: 1. Design a facultative pond to treat (13500)gpm of sewage having (13500/20)mg/L of BOD. The average summer and winter temperature is 43oC and 13oC, respectively. Convert the same pond into aerated lagoon, if the concentration of influent BOD reaches to (13500)mg/L. 2. Determine the diameter of a trickling filter for a wastewater flowing at the rate of (13500)m3/day. The influent BOD (So) concentration for the wastewater is (13500 * 10)mg/L, whereas desirable effluent BOD should be as per NEQS.
QUESTION: An aerated lagoon wastewater treatment is to be designed for a municipal wastewater. The design population is 5000 persons, and the aerated lagoon is to provide secondary treatment. Pertinent data are: flow = 380 L/cap-d, influent BOD5 = 255 mg/L; effluent BOD5 = 20 mg/L, K = 2.18 d-1 oxygen required 1.6 kg O2/kg BOD5 applied to the lagoons, and the primary clarifier removes 33 % of the influent BOD5. Calculate the total lagoon volume (m3)
As an operator of a wastewater treatment facility, you have learned that your plant runs well at an SRT (based on MLVSS (X) in the aeration basin) of 12 days. If today’s MLVSS (X) concentration is 2,700 mg/L and the RAS (Xr) concentration is 5,500 mg/L, how many L of sludge should you waste from the secondary clarifier today? Other design conditions: Average influent flow = 12,000 m3/d Influent soluble BOD = 150 mg/L Required effluent TSS = 30 mg/L Aeration tank Volume = 1,000 m3
Assume that DLSUD lake is 100m2 and its average height is 5ft. Wastewater that flows into the lake are the following: Food square kitchen waste 7 m3/sec; Total Dissolved Solids (TDS) is 25,000 mg/L which operates 8hrs per day CIH 5m3 /hr kitchen waste; TDS is 20mg/L which operates 4hrs per day PCH 20m3 /day diluted laboratory waste ; TDS = 40mg/L (1)Determine the volumetric flow rate of the lake water can still accommodate prior to rainfall.
For an activated sludge basin with a flow rate of 500 L/s if the influent BOD5 = 100 mg/L, the MLVSS = 3000 mg/L and the volume of the aeration basin = 766100 gallons Find the F/M ratio If the WAS X= 10000 mg/L, find the WAS flowrate (m3/d)
The average hourly water consumption per person is 2.5 Liters anf there are 264 people in the area. Determine the following. a. the minimum rate of flow in L/s in the spring b. Total Daily water demand in L/day c. Determine if its daily yield is sufficient to the water demand of the community if the rate of flow of the spring is 0.182L/s d. the height of the cylinder in cm thatt the minimum discharge can fill within 300 secs. diameter of the cylinder is 10 cm
A completely mixed treatment lagoon of 2500 m3 is designed to accommodate aninput flow of 35 L/s of a nonconservative pollutant with a concentration of 157 mg/L and a rateconstant of 0.68 d-1.a) Derive the appropriate reactor equation and determine the pollutant concentration atthe exit of the lagoon. If the provincial limit for release into waterways is 90 mg/L, doesthe effluent meet the limit?b) If the limit is not met, what would you suggest changing and/or implementing? Providetwo options.
Assume that taal lake is 100m2 and its average height is 5ft. Wastewater thatflows into the lake are the following: a. Food square kitchen waste 5m3/hr; Total Dissolved Solids (TDS) is 50g/L whichoperates 8hrs per dayb. CIH 5m3/hr kitchen waste; TDS is 20mg/L which operates 4hrs per dayc. PCH 20m3/day diluted laboratory waste ; TDS = 40mg/L (1)Determine the volume of wastewater which taal lake can still be contained withoutrainfall.(2)During operational hours a heavy rain fall, the rain gauge reading is 1.5m. Will the taalLake overflow? What is the volume of water that will over flow?(3). Compute the TDS concentration of the overflow.
A wastewater treatment plant treats a wastewater at a flowrate of 10 million liters per day. The wastewater has zero dissolved oxygen when it leaves the plant. The NPDES requirements include a minimum dissolved oxygen concentration of 2 mg/L in the discharge to protect the river. As an engineer, you must design a reaeration system to provide a minimum dissolved oxygen concentration of 3 mg/L (using a 1.5 safety factor). Use the reaeration data for the reactor with the largest volume to design a system. Assume each reactor that you used in lab represents the capacity of one aerator. How many aerators will be required to reaerate the water?
Design a rapid mono-media sand filter for a plant that has a design flow rate of 120 MGD. Filter Boxes Required:a) How many filter boxes are required for “on-line” filters?b) How many additional filter boxes are required to accommodate “off-line”filters?c) What is the total number of filter boxes needed by your plant?
A manufacturing facility that manufactures printed circuit boards puts washwater that was used to wash solvents from the circuit boards into a septic tankwhich discharges into ground water. The wash water contains 7.34 mg/L of dissolved trichloroethylene (TCE). The daily rate of discharge is 13.6 m'/day. Theunderlying aquifer has an average linear groundwater velocity of 0.34 m/day.The discharge has been going on long enough so that steady state conditionshave been reached. Assuming no degradation of the TCE, what is the concentation at a monitoring well located 22 meters downgradient of the septic tankdischarge (* = 22 m, y = 0 m)? Assume a value for b.