Thevenin’s Theorem RL what VTH RTH

Q: is the graphic representation of AC voltage or current values over time. When a wire is moved…

A: 1) ----- is the graphic representation of AC voltage or current values over time 2) When a wire is…

Q: 4. For the cct. Shown below calculate (for charging phase and discharging phase) a) (T) b) Write the…

A: As per the our company guideline we are supposed to be answer only first three subparts kindly…

Q: yv. J₁=4A Ⓡ Find 16 and 14 and i3 Ⓒ If y 1₂=2A 3 Iy 32 Is = 1A (13

A: In this question we need to find the value of current i6 , i4 & i3

Q: *7. Determine the level of V, for each network of Fig. 2.157. 12 V Si ➜ Ge (a) 2 ks2 Vo 10 ΚΩ

A:

Q: find the current, i(t) using laplace transform 30. R 100, L = 0.5 H, v = if t > 2 R = 2001 V if 0 <…

A: The circuit diagram, The resistance,R=20 Ω The inductor, L=0.5 H The input voltage, V=200 t

Q: A set of normally closed timed open contacts will open after the time period delay.  True  False

A: In the given questions, we need to discuss about the Normally Closed Timed open Contact (NCTO).

Q: Question 22 A PNP transistor with VBE =-0.7 Volts, VEC-3Volts. The transistor will be in cutoff…

A: We need to check region of operation of given BJT for given voltage .

Q: list the precautions you would observe before and during the carrying out of maintenance in switch…

A: In the given questions we need to discuss about the list of precautions need to take during the…

Q: YOUT "It Determine Vout for the following circuit if VIN-12VRMs. the applied frequency of the…

A: Circuit diagram is given as, Input voltage Vin=12 V. Frequency f=122 Hz. Resistance R=780 Ω.…

Q: b) Find current using nodal analysis. 252 www 18 V 402 3A

A: In this question we need to find the current I1 using nodal analysis

Q: Assume all timers are set for 3 seconds. When the start button is pressed, motor #1 does not start,…

A: Given circuit shows sequence starting and stopping for three phase motor. 1M,2M, 3M are three…

Q: If an LED emits light of wavelength 500 nm, the energy gap between the valence band and conduction…

A: Given : Wavelength, λ=500 nmh=4×10-15 eVc=3×108 m/s

Q: Design a synchronous counter with the irregular binary count sequence shown in the state diagram in…

A:

Q: ine the current I for each of the configurations of Fig. 2.155 using the approximate ent model for…

A:

Q: In the circuit shown in Figure 3 used for full-wave rectification, which of the diodes is connected…

A:

Q: 11. Determine current i1 and 12 as shown in Fig. (a). 20

A: It is given that:

Q: A B 5 V ے 046 Circuit 2 5 V Part b: Analyze the Circuit 2 above to find f in terms of boolean inputs…

A: We need to find out logical expression for given diagram .

Q: 1+ R1 M R2 ✪.

A:

Q: What type of bracing would you add to a loudspeaker

A: The purpose of adding bracing to a loudspeaker enclosure is to reduce the amount of resonance and…

Q: 1. A circular disk of radius a is uniformly charged with p,C/m². If the disk lies on the z=0 plane…

A:

Q: What is the procedure in a Series Circuit laboratory experiment with three resistors on a breadboard

A:

Q: Does a bass reflex cabinet have a transmission line?

A: We need to tell about does a bass reflex cabinet have a transmission line.

Q: Write the expression for vo (t) for t≥ 0. Assume t is in seconds. vo(t) = 2.5e V Ovo(t) = 2e -37500…

A: For the given circuit we need to calculate the voltage expression, total energy delivered across the…

Q: Ⓒ find the magnitude and phase of the following b) (4-3j) (2+j) c) 5j (4~3;) (3+4) 7+j a) j-4 3 +2j

A:

Q: Consider this resistor network: 8.2kQ 5% 0.25W ww 6.8k0 1% 0.5W www ww www 1KQ 5% 1W 1000 5% 0.125W…

A:

Q: (1) Using the Laplace transform and showing the details, find the current in the circuit in Fig.…

A:

Q: The beat length in a single-mode optical fiber is 9 cm when light from an injection laser with a…

A: Beat Length LB =9 cm, Peak Wavelength λ=0.9 μm, Spectral Linewidth δλ=1 nm.

Q: In the circuit diagram shown, X = 100, X₁ = 7 & R = 100 2. The effective current through the source…

A: It is given that: XC=100 ΩXL=7 ΩR=100 Ω

Q: What type of transistor has an insulated gate?

A: Transistor is a device that acts as a switch and an amplifier based on the design of the biasing…

Q: 2. For the circuit below, (a) Find the transfer function from r.(t) to r(t), as a function of…

A:

Q: Electronic timers are much less expensive that Pneumatic timers.    True  False

A: Neumatic timers are used in applications such as medical facilities where electrical currents can…

Q: The two switches in the circuit seen in (Figure 1) are synchronized. The switches have been closed…

A:

Q: A 220V single phase induction motor draws 2.76 kW at 220V and 0.8 pf. A 3 KVA capacitive load is…

A: In this question we need to find the KW of the capacitive load.

Q: IC = IE= VCE = 10 µF re Re Given : 3 = 75; VEE = -15; RB = 50k; RC = 450 Solve for IB, IC, IE, VCE,…

A: β=75,VEE=-15,RB=50 kΩ,RC=450 Ohm.

Q: A resistance R is connected in series with a parallel combination of two resistances 70 and 9 Q.…

A: In this question,  We need to determine the resistance R.  Power P= V2 /R

Q: A 220V single phase induction motor draws 2.76 kW at 220V and 0.8 pf. A 3 KVA capacitive load is…

A: Voltage is given V = 220 V. Initial active power P1=1.76 KW. Initial power factor cosϕ1=0.8.…

Q: (a) 36 V + ΖΩ www 12 Ω 9Ω ww 24V V ww 4 Ω 3 Ω Calculate the mesh currents i, and is of the circuit

A:

Q: Two coils, A and B, are positioned such that 80% of the flux produced by coil A links with B. When…

A: In this question, We need to determine the mutual inductance between coils.  The value of current in…

Q: A sequential logic circuit's outputs are dependent on both the inputs and the previous output. O a.…

A: Sequential circuits are the circuits whose output depends on the present value of the input signal…

Q: (Text problem 11.7) Design an interpolator that increases the sampling rate by a factor of I = 2.…

A: To design an interpolator that increases the sampling rate by a factor of 2, we can use an…

Q: Obtain a set of simultaneous integrodifferential equations representing the network.

A: To write the simultaneous integrodifferential equations for the given circuit and the same can be…

Q: 2. a. Using the characteristics of Fig. 2.152b, determine ID and V₁ for the circuit of Fig. 2.153.…

A: Note : Hi we have authorized to answer only 3 sub parts at a time since you have not mentioned which…

Q: 2004120°V C Icc 200 L-120° b. Line currents: laA = Blank 10 bB = Blank 12 200 40° V = Blank 14 1+joz…

A: In this question We need to determine the impedance after transformation in the Delta to star, line…

Q: Two resistors in parallel R1-9K ohm and R2-3K ohm. These are connected .in series with R3-6K ohm If…

A:

Q: Task 2 Another circuit in the factory on a separate power supply has also failed. This circuit is…

A:

Q: Vi Question 1 Part 1 What is the value of D12? a) 0.0638 b) -1.77 c) -1.44 d) 1.06 4 Ohm WWW…

A: By using Laplace transform given circuit converted into s domain.

Q: For a 400 kV line the number of :discs is about 18-19 20-22 22-23

A: Line voltage = 400 KV. For the 400 KV line we generally used insulator disc of breaking capacity of…

Q: TM (2,9,6) + X(1,5) Logic Equation (Y1): Y1 = f(A, B, C) = HM(1,4) + X(3,5) 1. The truth table: A B…

A: It is given that: Y1=fA,B,C=∏M1,4+x3,5   Need to calculate the Boolean expression in both SOP and…

Q: An ideal transformer has 3 windings as 100 turns of primary winding, 160 turns on secondary winding…

A: An ideal transformer- 3 windings as 100 turns of the primary winding, 160 turns on secondary…

Q: Figure 25.16 shows a source (a battery) with emf ε = 12 V and internal resistance r = 2 . (For…

A: Circuit diagram is given as,

Current Division Method

The generalized current divider formula is given by the following relation below,