Think of a system of 3 identical particles that can each occupy 4 possible states. Make a table of the distribution of filling state of the particles If the particles meet the statistics a. Maxwell-Boltzmann, b. Bose-Einstein, c. Fermi-Dirac.
Q: 4. In what way can a pulsating direct current be improved? A. Increase number of rotating coils on…
A: 4. correct option D. All of the above
Q: 25 15 V 3V C₁ 0.1 μF C₂ C₂ 0.47 μF 0.22 μF
A: Given data, Circuit diagram is given as,
Q: Calculate the magnitude and direction of the resultant of the following four vectors using the…
A:
Q: Joe, standing near a straight road, records the sound of the horn of a car traveling at a constant…
A:
Q: For increasing the angular velocity of a object by 10%, the kinetic energy has to be increased by…
A: We need to compute-Increase in kinetic energy=?The data given as-ω1=Initial angular velocityω2=Final…
Q: PLSS ANSWER WITHIN 10MINS Visible light of wavelength 591 nm falls on a single slit and…
A: We are given the order of minima. We are also given wavelength of light. We are given the angle. The…
Q: Page 102 Practice Problem 4.2: Suppose the counter attendant pushes a 0.35kg bottle with the same…
A: Given: The mass of the bottle: m=0.35 kg Initial velocity: vi =2.80 m/s Final velocity: vf =0…
Q: An upright rectangular loop of height a and width b has a lightbulb attached to it, with some…
A: We are given magnetic field. We are given dimensions of rectangular loop. The loop is rotated in…
Q: Show that it is possible to position a convex rock of surface area S in sunlight in such a way that…
A: For simplicity we assume the shape of convex lens is sphere. Then is surface area is S= 4πr2.....(1)
Q: A bag containing 0°C ice is much more effective in absorbing energy than one containing the same…
A: Given: Mass(m)=0.800kg Change in Temperature(ΔT)= 30 deg.C- 0 deg.C Specific heat capacity of…
Q: Find the percent increase in the magnetic field B when the space within a current carrying toroid is…
A: We need to compute-Percent increase=?The data given as-Susceptibility (λ)=2.1×10-5…
Q: A copper ball with a radius of 1.7 cm is heated until its diameter has increased by 0.16 mm.…
A: The copper ball's final temperature must be determined when its diameter rises by 0.16 mm. We are…
Q: A 850 g aluminum pan is removed from the stove and plunged into a sink filled with 11.0 L of water…
A:
Q: 3. The quarter ring shown has a mass m and was cut from a thin, uniform plate. Knowing that r₁ =r2,…
A:
Q: Ex. 6 of galvanometer of resistance 1000 ohm and its shunt is 25 ohm. Calculate the value of shunt.
A:
Q: A given star orbits the center of its galaxy at an average speed of v_star, at a distance of r_star…
A: Given, Velocity of star,vS=200km/s=200×103m/sRadius of star,RS=9 kpc=9×3.086×1019mVelocity of…
Q: all strikes an
A: Given: m=5.4±0.1gvi=305.5 m/sh=3.5 cm
Q: A sound note emitted from certain source has a velocity of 300 m/s in air and 1050 m's in water. If…
A:
Q: W of power into a portion of the brain 11.24 A (b) What is the total energy per unit mass received…
A: We are given power emitted by cell phone. We know that SAR is the power absorbed per unit mass. It…
Q: Putting a lid on a boiling pot greatly reduces the heat transfer necessary to keep it boiling.…
A: Heating of water involves transferring heat energy from a source into the water through a vessel.…
Q: Quantum mechanics is used to describe the vibrational motion of molecules, but analysis using…
A: Given,The vibrational frequency of the molecule, f = 7.0×1013 HzThe mass of hydrogen atom, m =…
Q: Shock Wave Pressure On February 15, 2013, a 12,000,000-kg asteroid exploded in the atmosphere above…
A: We must determine the force the pressure difference applied to the window.
Q: An object of 2 cm tall is placed 1cm in front of a convex mirror of focal length of 2 cm. (a) Use…
A: We are given a convex mirror. We draw image formation by convex mirror. We then use mirror formula…
Q: A camera has a converging lens with a focal length of 56 mm. If the f-number is 2.8 what is the…
A: Given; Focal length,F=56 mmf-number,f=2.8 The ratio of the focal length of the system to the…
Q: a 45 m wire is coiled so that it makes a coil containing 100 circular loops, one on top of the…
A: Given: In this question, the given values are, The length value is, L=45 m. The given value of the…
Q: A 12.0-V battery is connected to a series circuit containing a 10.0-Q resistor and a 2.00-H…
A: An RL circuit is made by connecting a resistor and an inductor in series or in parallel. The…
Q: Hydrogen has a ground state energy of Eo = -13.6 eV. A helium atom (Z = 2) with only one electron…
A:
Q: Find the pressure difference on an airplane wing if air flows over the upper surface with a speed of…
A: We must determine the 2.4 kPa pressure differential on the airplane wing. We are aware that the…
Q: 3.2-3 What area of a rectangular aperture is needed to produce a radiated power of 5 kW if its…
A: Given, Eaξ,ζ=150a^x+200a^y0 Radiated power,P=5 kW=5×103WIntrinsic impedeance of free space,η0=120π…
Q: The formation of condensation on a glass of ice water causes the ice to melt faster than it would…
A: When there is a phase change the energy enters or leaves the substance without causing any…
Q: Each of the plates of a parallel-plate capacitor has an area of 2.00 cm², and they are separated by…
A: Given,The area of a parallel plate,A = 2 cm2=2×10-4 m2The distance between the plates, d = 2.5…
Q: V1 20V R1 100kOhm C1 50Uf In the given circuit, calculate the time after connection when the…
A: We are given value of resistance and capacitance. The time constant is given as τ=RC Here R,C are…
Q: Amy, standing near a straight road, records the sound of the horn of a car traveling at a constant…
A: Given,Amy, standing near a straight raod, records the sound of the horn of a cartravelling at a…
Q: 10 1.2 nm O + 1.6 nm Proton X 1.92 x 103 T. out of the page 1.25 x 10-3 T, out of the page 2.33 x…
A:
Q: A 10-gram wire that is 6.0 m long is under tension. When a transverse wave of frequency 280 Hz…
A:
Q: The "Gravity Train" refers to the following curious yet impractical experiment, suggested by Robert…
A:
Q: Two bowls of soup with identical temperatures are placed on a table. Bowl 1 has a metal spoon in it;…
A: We must assess if the soup in bowl 1 is hotter, colder, or the same temperature as the soup in bowl…
Q: the ball does
A: Given: Vertical angle of string is 37o
Q: Q3. Object A of 0.2 kg is sliding at a speed of UA = 3 m/s along x-axis and hitting a stationary…
A:
Q: How does the resistance for copper and for silicon change with temperature? Why are the behaviors of…
A: The resistivity of all materials will depend on their temperature. The resistance offered by the…
Q: 1. What are the differences between the germanium and silicon diodes? • (5) None of the above is…
A: Diodes are simple two-terminal devices made by joining a p-type material with an n-type material.…
Q: Please do part c again. Answer is wrong
A:
Q: Tungsten filament has a cold resistance of 0.350 ohms. If the temperature increases from 20°C to its…
A: The resistivity of all materials will depend on their temperature. The resistance offered by the…
Q: Electron 3 nm Proton 4 nm 0 X An electron and a proton are each moving at 1.25 x 106 m/s in…
A:
Q: A water tank springs a leak. Find the speed of water emerging from the hole if the leak is 2.9 m…
A: The rate at which the water emerges from the hole must be determined.
Q: 3. A particle moves along the x axis under the influence of a single conservative force. The…
A:
Q: The potential difference across the capacitor G₂ in the adjoining figure is- C₁ = 20 esy ₂=30esy C3=…
A:
Q: a constant horizontal force is applied to block A, which pushes against block B with a 20.0 N force…
A: The two-block system's acceleration as well as the applied force must be determined. In both the…
Q: Problem 5.35A circular loop of wire, with radius R, lies in the xy plane (centered at the origin)…
A: We will answer the question using formula for magnetic dipole moment and formula for magnetic field…
Q: A copper ball with a radius of 1.7 cm is heated until its diameter has increased by 0.16 mm.…
A: The copper ball's final temperature must be determined when its diameter rises by 0.16 mm. We are…
Step by step
Solved in 3 steps
