Three charged capacitors of capacitance 2-uF, 3-µF and 5-uF have voltages across of 20 V, 30 V and 50 V, respectively. They are connected in parallel with terminals of like polarity together. Draw the circuit (with labels) and solve the voltage across the parallel combination.

Three charged capacitors of capacitance 2-uF, 3-µF and 5-uF have voltages across of 20 V, 30 V and 50 V, respectively. They are connected in parallel with terminals of like polarity together. Draw the circuit (with labels) and solve the voltage across the parallel combination.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 2PA: You are an electrician working in an industrial plant. You discover that the problem with a certain...

See similar textbooks

Related questions

Q: 4. Four resistances R1, R2, R3, and Rs are connected in shunt against 220 V supply. The resistance a...

Q: 2 the Tx 2 3

Q: Analyze the circuit of Figure 2 using superposition to determine the voltage across R3. Analyze the ...

Q: Example 2: calculate the RMS noise voltage arising from thermal noise in two resistors 100 & 150 res...

Q: Matching Type. Match each item to a choice: Two vectors having the same magnitude and direction. A r...

A: Given, Given that, They have given Different definitions and we have to match with exact Ones.

Q: b) The following digital signal was encoded using NRZ-Invert. What is the digital data? (Fill in the...

A: What is the digital data for the given NRZ - Inverted output ?

Q: Hello! I need to explain why ncr = ncn-r. Can also be stated as n (c,r) = c (n,n-r)

Q: For the solar cell attached, find the relative maximum power output for series resistance, Rs of 0 o...

A: The general solar cell circuit diagram is shown below, In the above circuit, the PN junction is in ...

Q: 14. The resistance of the field coils of a dynamo is 173 Q at 16 deg C. After working for 6 hours on...

A: The solution is given below

Q: A 952 range voltmeter is having an accuracy of t 0.84% of FSD. Calculate the following for the given...

A: Given: Range of voltmeter, V=952 V Accuracy, ±0.84% M1=857 VM2=912 V To calculate : (i) Range of acc...

Q: A 100 KVA transformer transformer has a maximum efficiency 97%, 1 pf and occurs at a load of 95 KVA....

Q: From the waveform shown in the figure, determine the parameters of the harmonic voltage u(t) = Umcos...

Q: Matching Type. Match each item to a choice: Two vectors having the same magnitude and direction. A r...

A: Vector- Vector as we know is a quantity that has magnitude and direction in the space.

Q: What is the the value of a resistor without considering its tolerance value percentage?

A: Resistors resist the electrical flow. Each has a value that tells it to withstand the current flow....

Q: plot the overall block diagram of the servo-hydraulical system shown below 20 16 K 3K M Drain K K Su...

A: servo hydraulic system- A servo hydraulic system is a control system that converts a small mechanica...

Q: The FIR filter М-1 H(2) = h(n)z¯", n=0 is said to have an antisymmetric impulse response when h(n) =...

A: GIVEN: frequency response H(z)=∑n=0M-1h(n)z-n FIND: (a) assuming that the filter length...

Q: A three phase, 4 - pole, 50 Hz induction motor has full load speed of 1455 rpm. What will be the fre...

A: Given, Three phase induction motor has Pole(P) = 4 Frequency (f) = 50Hz speed of motor (N) = 1455 ...

Q: For the follower circuit, let transistor Q1 have β = 50 and transistor Q2 have β = 100, and neglect ...

A: Given the circuit, as shown below: For the follower circuit, let transistor Q1 have β = 50 and tran...

Q: Problem 184: EE The total inductance of two coils, A and B when connected in series aiding is 0,5 H ...

A: Inductance:-The structure of the electrical circuit in which the electromotive energy is fed into th...

Q: Which of the following is used to reduce the compounding of a DC generator? Inverter Diverter Commut...

Q: Define stepper motor a. Explain the internal structure of stepper motor b. With Table explain the cl...

A: Stepper Motor Also called step motor/Stepping motor Brushless synchronous DC electric motor split f...

Q: 5. Given the R1 is (5002, 10002, 1500KO, 20002). i. Solve the voltage V, and current I, flow through...

Q: Given the scalar field defined by Ø(x, y, z) = 3x²z – xy% + 5 find Ø at the points: Match each item ...

A: This question belongs to basic electrical . It is based on Cartesian coordinate system . It is based...

Q: 1 (1) A plant in a unity feedback system is given by K G(s) s(s + 10)(s + 20) Find the value of K to...

Q: A DC series generator delivers a load of 20 kW at 400 V. The armature and field resistances are 0.3 ...

A: Given data: A DC series generator has, Rated power, P = 20 kW Terminal voltage, V=400 V Armature res...

Q: Find out the Laplace Transform of the following function: z(1) = e %% u(1) –551

A: In this question, We need to determine the Laplace transform of the given signal. We know Laplace ...

Q: Q1\ An ohmmeter has a moving coil of resistance 25 2 with 5mA full scale deflection current. The vol...

Q: Two alternators are operating in parallel supplying a common load of 4250 kW at 0.85 power factor la...

Q: design a circuit that would be able to shift bits but also store them for a duration of time. explai...

A: A shift register is a form of digital circuit that employs a cascade of flip-flops, with each flip-o...

Q: Give a best answer to each of the following: a. Name a PLC manufacturer that was absorbed by another...

Q: A 3 phase 10 kVA, 400 V star connected, 4 pole synchronous generator has a synchronous reactance per...

Q: . For what transfer function H(z) an

Q: quantity defined as amount of work done over time

Q: Find the charge enclosed in the volume 1 ≤ r ≤ 3 m, 0 ≤ φ ≤ π/3, 0 ≤ z ≤ 2 m Given the charge densit...

Q: 1-How to make the bridge output (Vo) equal to zero? explain?

A: Since you have asked multiple question ,we will slove the first question for you .If you want any sp...

Q: Using spray arc transfer, amperes are used with a 0.045" (1.1mm) electrode to weld stainless steel. ...

A: Spray arc are generally the droplets which are around the arc to the weld pool used to increase the ...

Q: Create a Sequence Diagram about Temperature Controlled Electric Fan with the following: *Thermistor...

A: Sequence Diagram of temperature controlled electric fan shows that how the fan works with the sensor...

Q: ri = 2a, + 4ay – 5a, r2 = ag + 2ay + 3az Find the unit vector parallel to the resultant of vectors a...

A: This question belongs to electro magnetic field theory . It is based on the concept of basic laws of...

Q: A. At which value of the dimensionless parameter = ka does the loop antenna pattern start to deviate...

A: Only one component of this section has been completed by me. A loop antenna is produced by bending a...

Q: 1. A building, supplied by a public utility, contains three balanced loads connected to the three-ph...

A: A building that contains three balanced loads connected to the three-phase lines - Load 1: Delta-co...

Q: 2. A voltage source of v(t) = 340sin(2n60t) V is applied to a nonlinear load, resulting a current i(...

Q: Wave Luminous Color Wattage (W) Voltage (V) Lamp life ( hours) Current Power Re-Strike S.no length (...

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for yo...

Q: A three phase wye connected load is connected to a 480V three phase line. The line current is 36 A. ...

Q: Design a full-wave rectifier with LC filter to provide 10 V dc at 100 mA along with maximum ripple o...

A: Given 10v DC 100mA Find ripple factor

Q: Three Two capacitors in parallel, 2-µF and 4-µF are connected in series with a 3-µF capacitor. The c...

Q: 6. Determine the value of R. 4R 2R to.1 A 2R 2R 12 V 3R 2R

Q: In a superheterodyne receiver, the incoming RF signal is at 25 dBµ, the RF amplifier has a 30 dB gai...

A: Given, Input to RF amplifier (I) = 25dBu Gain of RF amplifier (Gr) = 30 dB gain Loss of mixer (Lm) =...

Q: PROBLEMS 1. Given the functions below, find dy/dx using CHAIN RULE. 2 1 X = 5w - 2 t= 3w+4 ; y 4t +1...

Q: phase relationships

A: A) FROM GIVEN RELATIONS WE CAN SAY THAT VOLTAGE V STARTS AT WT=-30 DEGREES AND CURRENT I STARTS AT W...

Q: Determine the value of the voltage V0 using mesh analysis

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

Please answer it in 1hr.

write your solution neat and complete.

write the formula thank you.

Three charged capacitors of capacitance 2-µF, 3-µF and 5-µF have voltages across of 20 V, 30 V and
50 V, respectively. They are connected in parallel with terminals of like polarity together. Draw the
circuit (with labels) and solve the voltage across the parallel combination.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
Derive the equivalent circuit for a parallel connection of ideal capacitors. Assume that the initial voltage across the paralleled capacitors is v(t0). (Hint: Sum the currents into the string of capacitors, recognizing that the parallel connection forces the voltage across each capacitor to be the same.)
6.27 Given that four capacitors can be connected inseries and in parallel, find the minimum andmaximum values that can be obtained by suchseries/parallel combinations.....
A 50-uF capacitor is initially charged. Determine the initial charge of the 50-uF capacitor if thecharge transferred to a 100-uF capacitor, when connected in parallel, is 200-uC.
Suppose that we have a 1000-pF parallel-plate capacitor with air dielectric charged to 1000 V. The capacitor terminals are open circuited. Find the stored energy. If the plates are moved farther apart so that d is doubled, determine the new voltage on the capacitor and the new stored energy. Where did the extra energy come from?
Two capacitors of 200 and 800 nF, respectively are connected in parallel. The combination is then connected in series with another two capacitors of C and 600 nF connected in parallel. If the total capacitance of the set-up is 500 nF, determine the capacitance C.
How can four 100 kΩ resistors be connected so that the equivalent resistance of the four equals 250 kΩ? Sketch the arrangement, describe the resistor arrangement in words, and justify your picture by calculating the equivalent resistance. Repeat this part of the question with four 100 F capacitors and an equivalent capacitance of 75 F.
Suppose that we have two 100-μF capacitors. One is charged to an initial voltage of 50 V, and the other is charged to 100 V. If they are placed in series with the positive terminal of the first connected to the negative terminal of the second, determine the equivalent capacitance and its initial voltage. Now compute the total energy stored in the two capacitors. Compute the energy stored in the equivalent capacitance. Why is it less than the total energy stored in the original capacitors?
Solve for the (and refer to the image): - individual voltages - individual charges wherein Equivalent capacitance of the capacitor is 0.76 F Charge stored in the circuit is 45.50 C. And V= 60V
At t=0, a constant 5-V voltage source is applied to a 3-H inductor. Assume an initial current of zero for the inductor. Determine the current, power, and stored energy at t=2 s.
Find the total capacitance. Show complete solution and include the figures used to generate equations.
Basic Electrical Engineering: Inductance and Capacitance You find that a 25-µF capacitor connected to a 480 V AC is defective. The storeroom has no capacitors with a 480 V AC rating. However, you find two capacitors rated at 50 µF and 370 V AC. Can these capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damage to the capacitor.