Three condensers of 6, 10, and 15 micro-farads are connected in series across a 200V supply. If the condensers are disconnected, how much energy can the charged condensers provide if connected across each other with like polarities together? Ans. 0.052 J

Three condensers of 6, 10, and 15 micro-farads are connected in series across a 200V supply. If the condensers are disconnected, how much energy can the charged condensers provide if connected across each other with like polarities together? Ans. 0.052 J

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter25: Television, Telephone, And Low-voltage Signal Systems

Section25.2: Telephone System

Problem 2R: At what height are the telephone outlets in this residence mounted? Give measurement to center....

See similar textbooks

Related questions

Q: Give one example of where Lattice Vibrations occur in Superconductivity

A: Lattice Vibration Lattice vibration can explain sound velocity, thermal properties, elastic…

Q: requires 10 watt-sec to charge a capacitor with 0.09 coulomb, determine the size of the unit in…

A: In this question we will find size of capacitor...

Q: What are Diagram,Construction, Operation, Advantages and Disadvantages of SF6 Circuit Breaker.…

A: It is asked to draw the diagram and to explain the construction, operation, advantages and…

Q: hown below. The Vin = 55 V and Rrn = 550. power supplied to the load resistor (Pma) =

Q: Typical replacement for a 100 W incandescent bulb is a 20 W LED bulb. The 20 W LED bulb provides a…

A: Given, Rating of incandescent bulb is 100 W. Rating of LED bulb is 20 W. The bulb is turned on…

Q: 13. At what amperage differences will a GFCI trip? 14. What do DC and AC stand for? 15. True or…

A: (13) GFCI detects the differential current between hot and neutral wire conductor if differential…

Q: Differentiate between Active and Passive Solar Thermal Energy Systems via suitable examples.

Q: Design an Ayrton shunt by indirect method to provide an ammeter with current ranges 1A, 5A, and 10A,…

A: Analog instruments are classified into 3 types Indicating instrument Integrating type instrument…

Q: The current through a 10-ohm lamp energized by two series-opposing ideal batteries is measured to…

Q: a single phase 230v,50hz half controlled rectifier is connected to 62.9ohms load resistor. for…

A: According to the question we have to find the power dissipated by the element.

Q: Plot the forward and reversed zener current and zener voltage based on the measured values from…

A: According to the question, we need to plot the graph based on the following data as shown below

Q: A single phase half-wave rectifier is connected to a 300V RMS 50Hz AC supply. If the rectifier is…

A: Vrms = 300V F= 50Hz RL = 500 Ohms VDC IDC PDC

Q: In a solar sell there is reverse saturation current flowing and the total current flowing is equal…

A: In a solar cell, there is a reverse saturation current flowing and the total current flowing is…

Q: a midday if the instantaneous irradiation is 800 W/m2? this power is focused in a small area of S cm…

A: Given, Radiation =R =800 W/m2 dish (concentrator) diameter d1=10 m receiver area diameter d2 =5 cm…

Q: What is the differences between real circuits and the simulated ones, please elaborate.

A: Simulation is define as the mathematical model or representation of a device which gives a very…

Q: Explain the performance of PV cell with a neat equivalent circuit diagram.

Q: Explain in detail the difference between a Micro-Electronics / Photonics Engineer and an Electronic…

Q: Draw circuit diagram of microwave oven

A: Concept: The part of the electromagnetic spectrum with large infrared waves and short radio waves,…

Q: 12. what are the techniques that uses te fabricate Solan cells ? r

A: PHOTO VOLTAIC EFFECT: When the sunlight is incident on a material surface, the available electrons…

Q: Design and describe a system to generate electricity from a fuel cell.

A: Fuel cells perform chemical reactions on reactive gases (Fuel) and produce electricity. It generates…

Q: Give the advantages and disadvantages of solar cell panels.

A: Solar cells are the part of renewable energy sources.

Q: For mt mosfet n the carcuit shoun; Kp= 10 mA/VZ Vrel =1V %3D What is the înput resistance ?

Q: With reference to energy conversion process, write the difference between Solar Power Tower system…

Q: Three condensers of 6, 10, and 15 micro-farads are connected in series across a 200V supply. If the…

A: Given, C1=6 μFC2=10 μFC3=15 μFV=200 V

Q: Using IC that is approximately equal to IE. Determine the value of R1in ohms, when VCC=20V,…

A: The solution is given below

Q: Q 6. Discuss the importance of Maximum Power Point or Ideal operation point of a PV Cell and how is…

A: PV cell is also known as Photovoltaic cell or solar cell is an electrical device that converts solar…

Q: How to measure voltage across a resistor? A In series with the element B) In parallel with the…

Q: discuss the refrigerator

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…

Q: Design an Ayrton shunt by indirect method to provide an ammeter with current ranges 1A, 5A, and 10A,…

Q: A string of suspension insulators consists of three units. The capacitance between each link pin and…

A: As we have given V3=35 kVk=16=0.16

Q: More five examples regarding this KCL method(with circuit figures and complete solution)

Q: Explain PV module and array of solar photovoltaic

A: Solar cell: Solar cells or photovoltaic (PV) cells are non-mechanical devices that use sunshine to…

Q: What is the process from raw materials, to crude oil energy to used to charge your cell phone

A: To explain the process

Q: What is the difference between active and passive loads

Q: A single phase half-wave rectifier is connected to a 300V RMS 50Hz AC supply. If the rectifier is…

Q: In a 36KV overhead line, there are 3 units in the string of insulators. If the capacitance between…

A: Here, Value of K = 55% = 0.55 Line voltage = 33 kV

Q: We calculate for the total charge that enters a terminal with the given q=5tsin4πt mc. The current…

Q: Give two examples of environmental concerns associated with solar power generation

A: given that two examples must be given stating the environmental concerns associated with solar power…

Q: Give advantages and limitations of solar PV systems

A: Solar PV System A photovoltaic (PV) system is made up of one or more solar panels, an inverter, and…

Q: Illustrates the operation of a basic photovoltaic cell based on the image given. Give the reasons…

Q: In a 33kV overhead line, there are three units in a string of insulators. If the capacitance between…

Q: 6. A string of four suspension insulators is connec unit is equal to 5 times pin to earth…

Q: calculate the net efficiency during the process of: Home rooftop PhotoVoltaic (PV) panels powering…

A: Rooftop photovoltaic panel is generally used on residential buildings. Capacity of rooftop PV…

Q: xplain hybrid operation of solar PV system

A: Hybrid operation of solar PV system: The hybrid solar systems employ specialized hybrid inverters…

Q: 6) A resistance lo ad of 4 ohms is connected to a 220-volt 60-cyclo line which leads back to the…

Question

Three condensers of 6, 10, and 15 micro-farads are connected in series
across a 200V supply. If the condensers are disconnected, how much energy
can the charged condensers provide if connected across each other with like
polarities together?
Ans. 0.052 J

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Using the rules for parallel circuits and Ohmslaw, solve for the missing values. ETE1E2E3E4ITl1I2l33.2AI4RT3.582R116R210R3R420PTP1P2P3P4
For residential water heaters, the Consumer Product Safety Commission suggests a maximum temperature setting of ___________ F (_____________ C). Some states have laws stating a maximum temperature setting of ____________ F (________________ C).
An ac resistance is higher than a dc resistance. True False
please give detail explain.. Ans : Rth = 28 ohm Vth = 92 V
Create an explantion explaining the working operation of the circuit below.
In a 36KV overhead line, there are 3 units in the string of insulators. If the capacitance between each insulator to pin and earth is 55% of self-capacitance of each insulator. Find the distribution of voltage over three insulators and string efficiency.
What is the difference between active and passive loads
GIVE DETAIL EXPLAIN PLEASE! with cicruit drawing.. Ans : Rth = 28 ohm Vth = 92 V.
How open circuit test can be performed? Which type of losses can be found using this test? Subjcet Electrical machine
Determine AV for the figure.
Design a 24v zener regulated power supply circuit that will power a 500 ohms load with 1A of current.
Perform a theoretical analysis on the circuit to determine the following using nominal values: a. It, Pt, V drop across each resistor, and I through each resistor, and Power dissipated each resistor. b. Determine Vab, Vac, Vad, bc, Vdb.