Three condensers of 6, 10, and 15 micro-farads are connected in series across a 200V supply. If the condensers are disconnected, how much energy can the charged condensers provide if connected across each other with like polarities together?

Three condensers of 6, 10, and 15 micro-farads are connected in series across a 200V supply. If the condensers are disconnected, how much energy can the charged condensers provide if connected across each other with like polarities together?

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 3PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Related questions

Q: Two 25-volt batteries having an internal resistance of 0.2 ohm and 0.4 ohm repesctively supply power…

A: We have taken the voltage from the circuit that is 24V How much current is drawn by each Battery

Q: 6. The filament of a 240 V metal filament lamp is to be connected from a wire having a diameter of…

Q: A string of 30 mini LED lights, each using a 60 ohm resistor, are connected in parallel to a 3V…

A: To solve above question one should know why resistance are connected in series with LEDs LEDs are…

Q: After reduction, the current - caring capacity of a condenser is referred to as the___. A. ambience…

A: Given: After reduction, the current carrying capacity of a conductor is referred to as the ___.

Q: What is the total internal resistance of an ohmmeter with a 1mA meter movement and having a 5VDC…

A: Given data: I=1 mAVB=5 V

Q: What are Diagram,Construction, Operation, Advantages and Disadvantages of SF6 Circuit Breaker.…

A: It is asked to draw the diagram and to explain the construction, operation, advantages and…

Q: A series circuit consists of a 66.2-uF capacitor and a variable resistor. For what two values of…

Q: An inductor of 1 henry and a resistance of 2 ohm are connected in series with an EMF of 100 volts,…

A: For DC conditions , inductor acts as short circuit at steady state . using ohms law calculate…

Q: A,

A: Usually wire connected between bulb and battery to flow the current and make bulb on. the wire must…

Q: The diameter of wire A is greater than the diameter of wire B, but their lengths and resistivities…

Q: An ammeter has been designed by indirect method with current ranges 1A, and 5A, if PMMC meter have…

Q: A 0.5 ohm resistance is required to be connected in parallel to a moving coil instrument whose full…

Q: ANSWER IN ESSAY FORM What is the purpose of Multisim in terms of circuit creation in relation to…

A: We need to find the purpose of Multisim in terms of circuit creation in relation to Ohms law, and…

Q: Plot the forward and reversed zener current and zener voltage based on the measured values from…

A: According to the question, we need to plot the graph based on the following data as shown below

Q: Determine the time required for 4 x 1016 electrons to pass through the imaginary surface of the…

Q: Three types of electric devices A, B, and C are connected in series across a 115-volt a-c source,…

A: GivenEA=EB=EC=E∠EB=∠EA+90°∠EC=∠EA-90°

Q: What relationship is observed with regards to the voltage across each resistor? and how can I…

Q: How does the internal resistance of the multimeter (in voltage setting) affect the…

A: Given: Effect of Internal resistance of the multi-meter on capacitor

Q: Ql: A plate (100 mm) wide and (15 mm) thick is joined with another plate by a singe transverne weld…

A: For the given data Length is calculated as shown below

Q: resistor R in series with a germanium diode and an LED lamp is connected across a 12V dc supply.…

Q: Determine what these four voltmeters (A, B, C, D) will register when connected to this circuit in…

Q: An ideal battery of terminal voltage 22 volts charges two practical batteries connected in parallel…

A: Given, Voltage (Vs) = 22 V Practical Batteries specification, V1 = 10 V, R1 = 0.2 Ω V2 = 8 V, R2 =…

Q: a) PMMC meter has (10MA) half scale current deflection and (1500) internal resistance. Use this…

A: PMMC stands for permanent magnet moving coil. It works only for Dc because PMMC measures average…

Q: Sketch a diagram showing the ohmmeter face for a reading of 1.2k ohms. Indicate the setting of the…

A: Ohmmeter:- An ohmmeter is a piece of electrical equipment used to measure electrical resistance.…

Q: Determine what these four voltmeters (A, B, C, D) will register when connected to this circuit in…

A: Electrical devices are used for measuring electrical parameters. Current, voltage and power are…

Q: what is the equivalent resistance Rab

A: This question belongs to circuit theory . It is about calculation of equivalent resistance of the…

Q: How would you construct a battery pack that could supply 6V and 7A using D or AA alkaline batteries?

A: It is asked to construct a battery pack that could supply 6 V and 7 A using D or AA alkaline…

Q: Theoretically determine the voltages across each of the resistors for the Experiment circuit using…

Q: A constant current of 4 charges of capacitor. How long will it take to accumulate a total charge of…

A: Charge =integration of current. Given constant current of 4 Amps. And final charge of 8 Coulombs .

Q: an uncharge condenser in series with a 120- volt voltmeter of 10 000 ohms resistance is suddenly…

A: In this question, Uncharged capacitor is given. So Voltage Vc (0+ ) = 0V Determine the rate of…

Q: 5. A series circuit consists of a 66.2-µF capacitor and a variable resistor. For what two values of…

A: We need to find out the resistance value for given circuit for given power

Q: How much work is done by a 12-V automobile battery in moving 5x102" electrons from the positive…

A: According to the question we have to find the value of work done.

Q: A rectangular bus bar has a cross section of ½ by 1¾ inches and is 25 ft. long. What is its…

A: Given cross section of ½ by 1¾ inches and length is 25 ft. long.e Rsistance at 20°C = ?

Q: 5. How do the 2 different voltmeter readings compare to each other and to the voltage predicted by…

A: 5, Voltmeters give an approach to securely gauge the voltage, or the distinction in electric…

Q: UNSEEN An e-beam welder uses a 20 kV potential to give an electron beam aimed at the metal to be…

A: Given values are - V=20kVI=50mA

Q: Explain why photovoltaic cells would be connected in series, parallel, or a parallel combination.

A: Need to explain why photovoltaics cells connected in series, parallel or parallel combination

Q: Kindly explain or describe the use of each components briefly. Bread board, 9V battery, 1k ohms…

A: Given: Components Bread board 9V battery 1k ohms resistor 1mH inductor switch 3V LED

Q: There are 32 solar cells in the solar system, and each one has the qualities listed below: Voc is…

A: Total number of cells =32 for each cell, Voc =0.75 V Isc =2 mA

Q: (i), What do you understand by the elėctromotive force of a cell? In an experiment to determine the…

A: i) Electromotive force of a cell is the voltage or electric potential difference across the…

Q: A rectangular bus bar has a cross section of 1/2 by 1 3/4 inches and is 25ft. long. what is the…

Q: Listen Reverse connection of a milliammeter in a dc circuit will cause O the meter to display…

A: For AC ammeters and voltmeters polarity is not given importance The AC meters work in the same…

Q: 4. In a parallel circuit, there is more than one loop or pathway so charge flow gets split up or…

A: Solution !!

Q: Are Digital and analog Voltmeters used in the Experiment True RMS Voltme

A: When you use a multimeter to measure an AC voltage or current, the reading on the meter is an "RMS"…

Q: what is kvl and kcl in circuit theory ?

A: The electrical circuit consists of various active and passive elements and The circuit calculations…

Q: How much resistance must be put in series with a 40-microfarad-capacitor connected to a 110 volt,…

Q: 1. In Solar PV modules, energy is converted to energy. 2. Choose the type of output voltage of a…

A: Photovoltaic modules consists of number of photovoltaic cells connected in series or parallel to…

Q: Three condensers of 6, 10, and 15 micro-farads are connected in series across a 200V supply. If the…

A: Given: C1=6 μFC2=10 μFC3=15 μFV=200 V

Q: A resistor R in series with a germanium diode and an LED lamp is connected across a 12V dc supply.…

A: A resistor R in series with a germanium diode and an LED lamp is connected across a 12V dc supply.…

Concept explainers

Current Division Method

The generalized current divider formula is given by the following relation below,

Question

Three condensers of 6, 10, and 15 micro-farads are connected in series
across a 200V supply. If the condensers are disconnected, how much energy
can the charged condensers provide if connected across each other with like
polarities together?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Six 100Wp crystalline PV modules, each with an open circuit voltage (Voc) of 30V, are connected in series in a string. What would be the total open circuit voltage (Voc) of the string of modules? And what would be the total Wp of the string? 180V, 600Wp 180V, 100Wp 30V, 600Wp 30V, 100Wp The distance from a combiner box to a PV array junction box is 4 m. The voltage drop of the used cable on this distance is 0.5 V. The current is 8.0 A. What is the power loss on this distance? 16 W 32 A 4 W 2 W A PV system has a rated capacity of 10 kWp. The overall efficiency of this PV system is 75% . The average daily irradiance at the site is 4 kWh/m²/day. What is the expected average daily energy output of this system? 3 kWh 30 kWh 7.5 kWh 40 kWh
How much resistance must be put in series with a 40-microfarad-capacitor connected to a 110 volt, 120-cycle source to limit the current to 3 amperes? What will be the drop across the capacitor and across the resistor? How much power is expended?
Two 25-volt batteries having an internal resistance of 0.2 ohm and 0.4 ohm repesctively supply power to a 2-ohm load. How much current is delivered by each battery? Use counterclockwise
Below is the table of PV specifications of a standard commercial silicon PV. a) Calculate the efficiency of this PV module. b) Calculate the fill factor of this PV module. c) Estimate the number of solar cells included in this PV module. d) Draw a sketch explaining how the solar cells are connected in the PV module.
Analyze the circuit of the figure shown to determine the voltages at all nodes and the currents through all branches. Where β=30, ?????? =0.2 V, ??? = 0.7 V and assume thetransistor is silicon.
what is kvl and kcl in circuit theory ?
A) Find the equivalent resistor of the circle between points a and b?B) If a constant voltage source (15V) is placed between points a and b, calculate a valueCurrent iS
In a 36KV overhead line, there are 3 units in the string of insulators. If the capacitance between each insulator to pin and earth is 55% of self-capacitance of each insulator. Find the distribution of voltage over three insulators and string efficiency.
An e-beam welder uses a 20 kV potential to give an electron beam aimed at themetal to be welded. If the beam current is 50 mA, calculate,i) the number of electrons incident per second on the weld.ii) The power incident on the weld.
After reduction, the current - caring capacity of a condenser is referred to as the___. A. ambience b. Allowable ampacity c. ampacity d. ambient rating
There are 32 solar cells in the solar system, and each one has the qualities listed below: Voc is set at 0.75 volts, while Isc is set at 2 milliamperes. Open circuit voltage and short circuit current will be if all four cells are in series and the groups are linked in parallel.
Nichrome ribbon resistor elements each has a resistance of 1 ohm. The element is made from sheet of nichrome alloy, 0.025cm thick. If the width of the ribbon is 0.3cm, what length is required per element? Assume specific resistance of nichrome allow to be 109micro ohm-cm.