Three reservoirs are connected by individual pipes to junction O as shown on the figure below. Find the elevation of reservoir C in order that the discharge in pipe AO from reservoir A is 0.15 cubic meter per second. Use Darcy-Weisbach formula with f = 0.02. Draw the final hydraulic gradient line (HGL).

Q: Q2 12 m Concrete dam Water 1.5 m water 5 m Impervious clay Figure P4.18 A sketch of a flownet under…

A: As per guidelines we need to answer only first question so please repost rest question separately

Q: h = 1.4                      H = 1.1 m                K = 4.87 x 10-2 cm/sec            θ = 14°…

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: Calculate the hydraulic head, h along with the pore-water pressure, u at points 2, 4 and 6, after…

A:

Q: A A 2 The three-reservoir system is shown below: 3 The elevation of Reservoir at A is 140m and at C…

A:

Q: 1. For a fully-developed pipe flow, how does the pressure vary with the length of the pipe? a)…

A: For a fully-developed pipe flow, how does the pressure vary with the length of the pipe? a) Linearly

Q: A dam is used to store water, and a circular gate which is hinged at its bottom edge is used to…

A: given: h1=1mh2=6m  location of c.g from water surface (h¯)=1+62=4m

Q: You are working for a big engineering company. The company has a project on building a channel, and…

A: B = 20 m Q = Area x V

Q: A channel having a cross-section shown below has a flow rate of 0.049 m^3/s. Compute the hydraulic…

A: Hello dear, The answer is found to be  Hydraulic radius R=1.845 m For explanation please see the…

Q: The flownet at a site of a reservoir is shown in Figure P4.17. (a) How many flow channels are…

A: for a flow net the equipotential lines and flow lines are perpendicular to each other and in the…

Q: Refer to the illustration below. A C B D Solve for the following: 1. Headloss in meters at Pipe A 2.…

A:

Q: 6.88m. Darcy-Weisbach friction factor for all pipes, f=0.0238.    Pipe 1: Length=3500m…

A:

Q: Fluid flows in a 2.5-mm-ID horizontal tube. Find the pressure drop per meter. =0.06 Pa ·s, RD=0.725,…

A: Find velocityRe=ρvDμ205=1000×0.725v2.5×10-3m0.06v=6.7862ms-1

Q: For a given dam in the figure below, (A) Compute the flow rate q under the dam (B) Compute the water…

A:

Q: The following figure shows and inclined aquifer at 100 to the horizontal. The difference in water…

A: k=0.7mm/sec h=5m Theta= 10o Discharge is given by q=kia where,  k= hydraulic conductivity i=…

Q: 4pts In the dam figure with assumed 1 meter strip: water depth D=9m, dam height H=12m, and dam base…

A:

Q: determine the flow that comes out into the atmosphere in F, tabulate and plot the hydraulic gradient…

A: YA=11 m diameter of pipe 1,d1=30cm diameter of pipe 2,d2=18 cm Length of pipe 1, l1=80 m Length of…

Q: Suppose that a stable hydraulic jump forms between the two sluice gates shown in Figure 5.15. If the…

A:

Q: The concrete dam shown below is resting on a permeable soil layer with coefficient of permeability…

A:

Q: 2. Predict the volumetric flow rate of the siphon (cm³/s), assuming that L = 100 cm, Az = 80cm, and…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: 1. Differentiate atmospheric pressure, gauge pressure and absolute pressure. 2. State the stability…

A: Note- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: A sketch of a transformed flow net in x-direction under a dam is shown in Figure, the soil has K=…

A:

Q: There are three pipes and each has different friction or roughness factors below: Saint Pancras…

A:

Q: A sluice gate flows into a horizontal channel as shown in the figure. Determine the flow through the…

A:

Q: No..... Q4 A sketch of a transformed flow net in x-direction under a dam is shown in Figure, the…

A: Solution Given data Nf=3Nd=10kx=4×10-8ft/secky=1×10-8ft/seck=4×10-81×10-8=2×10-8 ft/secHead,…

Q: find the discharge of the groundwater.

A: seepage velocity(vs) =velocity/porosity=0.0375/0.48 =0.078125m/sec

Q: A A 2 B The three-reservoir system is shown below: 3 The elevation of Reservoir at A is 140m and at…

A:

Q: Two sharp-ended pipes (A & B) of diameter da = 100 mm, and dg = 120 mm and of length LA = 400 m and…

A: (a)- Rate of flow for Pipe A, Total head loss=loss at entry+loss at exit+friction…

Q: Q16) For the flow condition shown in the figure, determine: 1) The hydraulic gradient. 2) The total…

A:

Q: 1. Three reservoirs are connected by individual pipes to junction O as shown on the figure below.…

A: Solution: Given Data: Discharge in pipe AO from reservoir A is 0.15 m3f=0.02 From Darcy Weisbatch…

Q: Determine the discharge of the river. Slope of water surface = 0.80%, Roughness coefficient (n) =…

A: manning equation :Manning's equation is an empirical equation that is a function of the channel…

Q: Calculate for the hydraulic gradient if the pressure at point A is 18547N and 15874N for point B.…

A:

Q: 10. The Hydraulic radius of an Equalength-triangular channel of length (L = 20 cm) and height (h =…

A:

Q: 2.6 Draw the flow net below the dam and determine the total heads and water pressures u at points…

A:

Q: A homogeneous anisotropic embankment dam section is detailed in Figure 2.21(a), Construct the flow…

A: Solution: The Flow Net diagram is constructed below:

Q: 1 m 2 m 2 m 1m 2 m 4 m 3 m

A:

Q: a. Calculate the flow rate out of the reservoir, if at the discharge (point C) the cros sectional…

A: Given -

Q: A sketch of a transformed flow net in x-direction under a dam is shown in Figure, the soil has k =…

A: As per bartleby guidelines, for multiple sub parts. We have to solved 1st 3 sub parts. Kindly upload…

Q: The following figure shows and inclined aquifer at 100 to the horizontal. The difference in water…

A: The discharge is the amount of water in the aquifer can transmit the water with particular amount of…

Q: 10. A rectangular channel has a depth of 5m and width of 12m. Calculate the hydraulic depth of the…

A:

Q: Consider the one-dimensional open channel flow shown in Figure P10.8. (a) Using the continuity…

A: Part-a -  For the value of kinetic energy correction factor equal to 1, the total head H of the…

Q: (c) Two reservoirs with 20 m difference in their water levels are connected by a 300 mm diameter…

A:

Q: 110 mm diameter siphon draws water from the reservoir. hị Considering that the elevation…

A: It is required to determine the velocity at point C. Vc=2gh2=2×9.81 ms2×5.1 m=10 ms The velocity at…

Q: be B and the depth be y, termine the hydraulic radius of the channel. a) By/ R+2Y

A: To find : Hydraulic radius

Q: Three reservoirs A, B and C are connected by a pipe system shown in the figure below. If the rate of…

A: Branching of pipe is done to transfer water from the reservoir at a higher elevation to the…

Q: Determine the elevation of the upstream reservoir (A) in Figure P4.1.2 if the downstream reservoir…

A:

Q: A 40 cm diameter pipe 600 m long carries 260 liters per second of water from reservoir A,…

A: Given: The diameter of pipe in reservoir A is 40 cm. The length of the pipe in reservoir A is 600 m.…

Q: You are given the flow net for the gravity dam shown in Figure below. Two piezometers (i.e.…

A: GIVEN DATA:-  FOR GIVEN GRAVITY DAM TOTAL HEAD LOSS OR SEEPAGE HEAD=60-6=54FT NUMBER OF FLOW…

Q: Water flows in a rectangular channel of width, w. In some cases, the water may suddenly increase in…

A: (a) Consider a hydraulic jump as shown in the question Consider two sections 1-1 and 2-2 before and…

Q: A trapezoidal channel with uniform flow depth 4 m. The base width is 6 m and the side slopes are…

A: Given that: Base width, B = 6m, Water depth, y=4m

Hydrogen Energy

Energy is a quantity that cannot be defined, its existence can only be felt. In simple language, if a system possesses energy, it can do a specific kind of work. There are many forms of energy sources which people can use to obtain work. Solar energy, tidal energy, hydroelectric energy, geothermal energy, wind energy are some of the renewable energy sources which are primarily used for the production of electricity.