To check the stability of a system, and aftercalculating the Routh table:O a. We check the signs of the firstcolumn elementsO b. We check the signs of thecharacteristic equation coefficientsO c. We check the signs of any columnelementsO d. We check the signs of the first rowelementsO e. We check the signs of any rowelements

Answered: To check the stability of a system, and…

Engineering

Electrical Engineering

To check the stability of a system, and after calculating the Routh table:

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.61P

See similar textbooks

Related questions

Q: Two conducting charged spheres X and Y having unequal charges are connected by the wire. Which of…

A: As per our company guidelines we are supposed to answer only first question kindly repost the other…

Q: Q2// Find the equivalent resistance across terminals MN in part B. B/ ww 3.25 Q 2.5 2

Q: 8. 4) F(s) = Ans. f(t) = sinh(2t)- 2t s-4s? s+1 6) F(6)= ) Ans. f(t)=1+t- cos(t)- sin(t) %3D 2 s(s?…

Q: Gain Phase deg dB Ph 10w, 2= integrator

Q: The signal is created using a NRZ-I line coding scheme. Find the data bits or symbol. USE: No…

A: The signal is created using an NRZ-I line coding scheme. We need to find the data bits or symbols.…

Q: Laplace transform of t cos at

A: Laplace transform of t cos at

Q: Write the Kirchhoff's voltage equations for the circuit shown in he Figure below and hence find…

Q: Gauss's law states that A. the inward flux density of D through a closed Gaussian surface S is equal…

A: Brief description : Here in the above given question they are discussing about electrostatics means…

Q: output waveform of a rectifier is called a/an

A: We need to tell about output of rectifier

Q: A square waveform is applied to the input of the integrator circuit. Determine the rate of change…

Q: A 3-phase, 6 Pole, 50 Hz, 400 V induction motor takes a line current of 40 A at 0.8p.f. and runs at…

Q: 1. How many resistors and switches would be required to implement a 6-bit resistor-string DAC?.

A: As per the guidelines of bartleyby I need to answer only first question.So kindly repost other…

Q: Find the equivalent resistance across terminals XY in part A, and MN in part B. 102 6: yo 12 0 M B…

Q: According to the figure below, what will happen when an external force is applied to the +q charge?…

Q: If resistor R2, is opened (or removed) in the circuit of Fig. 5, what is its effect on the…

A: Given circuit using voltage divider biasing Now what will happen if we remove R2

Q: a) A logic circuit shown in Figure Q.3 has a 4-bit input A and B, three 4-bit wide 2:1 muxes, a…

Q: QUESTION 5 Determine the total resistance RT of the circuit shown in Figure 5. Determine the current…

A: In this question, We need to determine the current in the each resistance and equivalent…

Q: A source with bandwidth 4000 Hz is sampled at the Nyquist rate. Assuming that the resulting sequence…

A: We need to find out information rate .

Q: (b) Complete the following Table Q.lb. Table Q.1b Q-format Value Decimal Value Q 3.4 DA16 Q7 0100…

Q: 11.19 An abc-sequence set of voltages feeds a balanced three-phase wye-wye system. The line and load…

A: The solution is given below

Q: (b) Given a discrete signal, x[n] = { A, 2,3, 2, A} i) What is the value of A if autocorrelation of…

Q: Using the Gaussian surface shown below, find the total charge enclosed by the Gaussian surface due…

A: In this question we need to choose a correct option.

Q: What is the average voltage of the rectifier’s output voltage Vo?

A: In this question we need to find a average output voltage of the given rectifier

Q: 11. Gain unit of a voltage amplifier : a. Ohm b. Mho c. Siemens d. Unit less

Q: A three phase system has line to line voltage Vab= 1500 Vrms with 30 degree angle with a why load.…

Q: Using Fig. P12.40, at what frequency does the quadratic pole break (the 3dB frequency of the…

Q: vector (1,1,0) cm, charge Q2 of 1 nC at (1,0,1) cm and charge Q3 of 2 nC at (0,1,1) ст.

Q: c) The following stiff voltage-divider circuit in Figure Q2 (c) consists of BJT with DC gain 140.…

A: We need to find Q point coordinate for given bjt circuit

Q: State Ohm's Law and explain Explain the difference between

A: In this question we will write about ohms law, ac and dc power....

Q: Find the Inverse Laplace Transform of the following functions 8 4) F(s)= Ans. f(t)=sinh(2t) – 2t %3D…

Q: 41 According to the figure below, which Gauss's Law procedures stated below were violated? Gaussian…

A: In this question we need to choose a correct option

Q: 12V Given the circuit with B = 110, find: RC 22ко RB 630kQ a. Ic =. b. S(lco)= c. S(VBE)=. mA C2 C1…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: implement the following notation using any simulator. construct the truth table, boolean function,…

A: The truth table can be obtained by using the minterms given in the question and the Boolean…

Q: Type of Transistor: ? Circuit J+ Input (vs): Terminal ? Output (vo): Terminal ? Type of Amplifier…

A: Brief description : In the above given question they have mentioned a amplifier circuit. Here our…

Q: jBQ all + V, | 2/0° A -jAN () 3/45° A ?For the circuit shown above, what is the magnitude of the…

Q: Problem 50: Use nodal analysis to find the voltage across and current through all resistors. 24 V 10…

Q: 3. Find the Total Resistance Ras in the circuit. 2 kll 2 kll 10 kl A O 6 k RAB – 6 kit 6 kn 4 kn 1…

A: given electrical network.we have to calculate equivalent resistance across A,B.

Q: ?Q1. List the advantages and disadvantages of aperture antenna

Q: For the series diode configuration of Fig. 213, determine VD, VR, and ID + VD ▼ IR Si Ip R 2.2 ΚΩ E…

A: The solution is given below

Q: Given a three-phase induction motor, 380 V, 2 poles, 60 Hz. At a given time the phase currents are…

A: Steps: Ia ,Ib ,Ic and angle are given Apply d q axis formula in the form of ABC Substitute the…

Q: verse blas answer with an appropriate diagram.

Q: b) Find Ig, Ic, le, VBE, VCe and VcB in circuits of Figure Q2 (a). The transistor has Bpc= 180. Rc…

A: The solution is given below

Q: 1. An electrical network with two separate ports for input and output is called: a. Input -Output…

A: given statement about network

Q: Q2 (a) Differentiate between convolution and correlation processes in the digital signal processing…

A: Convolution: It is a property to calculate the output of the system by convolving the impulse…

Q: VCC 12V RC-6.4K Find: RF =220k UA a. Ig = b. lE = C. VCE= d. Vg = e. Vc = B 100 V V %3D RE=1.2k

Q: Rv is used Vary the gain. Shaw Kat Jo s qiven by: Ri R2 Ve RI Jin RV

Q: 3. 2Ω 162 1:4 ww 240/0° V rms V -j24 2 Vo=? Complex power supplied by the source=?

Q: 11.56 In a balanced three-phase system, the source has an abc-phase sequence and is connected in…

A: In this question, We need to determine the current in the phase current in the Delta source. We…

Q: Xc a 120/0° mA R1 ŹR2 XI ?For the circuit shown above, what is the magnitude of the Thevenin voltage…

Q: 9. Frequency response can approach that of the ideal filters if we a. Increase the order of filters…

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

To check the stability of a system, and after
calculating the Routh table:
O a. We check the signs of the first
column elements
O b. We check the signs of the
characteristic equation coefficients
O c. We check the signs of any column
elements
O d. We check the signs of the first row
elements
O e. We check the signs of any row
elements

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The voltage v(t)=359.3cos(t)volts is applied to a load consisting of a 10 resistor in parallel with a capacitive reactance XC=25. Calculate (a) the instantaneous power absorbed by the resistor, (b) the instantaneous power absorbed by the capacitor. (c) the real power absorbed by the resistor, (d) the reactive power delivered by the capacitor, and (e) the load power factor.
Given the circuit shown below, if Zx = 100/0 o determine the current in each branch by: a) Nodal Methodb) Maxwell’sMethod
ı know answer but how? z=2, p=1,n=1 and system is unstable
Cİrcuit Theory I
apply the P Petrick’s method to find the minimum SOP solutions for below question. f(a,b,c,d) = ...
Briefly explain about a) Primary transmission b) Secondary transmission c) Primary distribution d) Secondary distribution
1-Which function we call for three phase short circuit occurs in synchronous generator armature terminals at no load condition a.symshort b.lgfault c.llfault d.symfault 2-The FACTS devices support to control a.susceptance b.reactive power c.real power d.apprant power
DC STEADY STATE( NEED NEAT HANDWRITTEN SOLUTION ONLY OTHERWISE DOWNVOTE).
What are two ways of reducing Z0? (last part of the question)
ANSWER QUICKJLY
What is voltage stability? How is reactive power linked with the voltage stability in the power system? Write down the effect of ‘Load Tap Changer (LTC)’ on voltage stability and analyze very briefly using P-U (nose) curve.
please solve all question 1.1) Calculate Vpk and Vpk-pk for 6 VRMS 1.2)Calculate Vpk and VRMS for 14.1414 Vpk-pk 1.3)Calculate Vpk-pk and VRMS for 20 Vpk 1.4)Calculate the time period for (a) 50Hz (b) 1kHz (c) 20kHz 1.5)Calculate the frequency for time period (a) 20mSec (b) 100uSec (c) 2 Sec