To construct a nonmechanical water meter, a 0.500-T magnetic field is placed across the supply water pipe to a home and the Hall voltage is recorded. (a) Find the flow rate in liters per second through a 3.00-cm-diameter pipe if the Hall voltage is 60.0 mV. (b) What would the Hall voltage be for the same flow rate through a 10.0-cm-diameter pipe with the same field applied?

To construct a nonmechanical water meter, a 0.500-T magnetic field is placed across the supply water pipe to a home and the Hall voltage is recorded. (a) Find the flow rate in liters per second through a 3.00-cm-diameter pipe if the Hall voltage is 60.0 mV. (b) What would the Hall voltage be for the same flow rate through a 10.0-cm-diameter pipe with the same field applied?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter11: Magnetic Forces And Fields

Section: Chapter Questions

Problem 98AP: Unreasonable results To construct a non-mechanical water meter, a 0.500-T magnetic field is placed...

See similar textbooks

Similar questions

Show that the magnetic field at a distance r from the axis of two circular parallel plates, produced by placing charge Q(t) on the plates is Bind=02rdQ(t)dt
A parallel-plate capacitor with plate separation d is connected to a source of emf that places a time-dependent voltage V(t) across its circular plates of radius r0and area (a) Write an expression for the time rate of change of energy inside the capacitor in terms of V(t) and dV(t)/ dt. (b) Assuming that V(t) is increasing with time, identify the directions of the elecuic field lines inside the capacitor and of the magnetic field lines at the edge of the region between the plates, and then the direction of the Poynting vector S at this location. (c) Obtain expressions for the time dependence of E(t), for B(t) from the displacement current, and for the magnitude of the Poynting vector at the edge of the region between the plates. (d) From S , obtain an expression In terms of ‘(t) and dV(t)/dt for the rate at which electromagnetic field energy the region between the plates. (e) Compare the results of pails (a) and (d) and explain the relationship between them.
12.7 Check Your Understanding What is the ratio of the magnetic field produced from using a finite formula over the infinite approximation for an angle of (a) 85°? (b) 89°? The solenoid has 1000 mins in 50 cm with a current of 1.0 A flowing through the coils
An automobile with a radio antenna 1.0 m long travels at 100.0 km/h in a location where theEarth’s horizontal magnetic field is 5.5105T . What is the maximum possible emf induced in the antenna due to this motion?
A current is induced in a circular loop of radius 1.5 cm between two poles of a horseshoe electromagnet when the current in the electromagnet is varied. The magnetic Field in the area of the loop is perpendicular to the area and has a uniform magnitude. If the rate of change of magnetic field is 10 T/s, find the magnitude and direction of the induced current if resistance of the loop is 25 .
Check Your Understanding Repeat the previous problem with the magnetic field in the x-direction rather than in the z-direction. Check your answers with RHR-1.
A nonconducting hard rubber circular disk of radius R is painted with a uniform surface charge density tr. It is rotated about its axis with angular speed . (a) Find the magnetic field produced at a point on the axis a distance h meters from the center of the disk, (b) Find the numerical value of magnitude of the magnetic field when =1C/m2 , R = 20 cm, h = 2 cm, and magnetic field of Earth, which is about 1/2 Gauss. =400rad/sec , and compare it with the magnitude of
Unreasonable results To construct a non-mechanical water meter, a 0.500-T magnetic field is placed across the supply water pipe to a home and the Hall voltage is recorded, (a) Find the flow rate through a 3.00-cm-diameter pipe if the Hall voltage is 60.0 mV. (b) What would the Hail voltage be for the same flow rate through a 10,0-cm- diameter pipe with tire same field applied?
The magnetic field between the poles of a horseshoe electromagnet is uniform and has a cylindrical symmetry about an axis from the middle of the South Pole to the middle of the North Pole. The magnitude of the magnetic field changes as a rate of dB/dt due to the changing current through the electromagnet, Determine the electric field at a distance r from the center.
How is the percentage change in the strength of the magnetic field across the face of the toroid related to the percentage change in the radial distance from the axis of the toroid?
If electric and magnetic field strengths vary sinusoidally in time at frequency 1.00 GHz, being zero at t=0, then E=E0sin2ft. (a) When are the field strengths next equal to zero? (b) 4Jhen do they reach their most negative value? (c) How much time is needed for them to complete one cycle?
Is Ampere’s law valid for all closed paths? Why isn’t it normally useful for calculating a magnetic field?