Answered: To find the current flowing in a…

Science

Physics

To find the current flowing in a circuit one can use what law?

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter21: Circuits And Dc Instruments

Section: Chapter Questions

Problem 40PE: Find the currents flowing in the circuit in Figure 21.47.

See similar textbooks

Related questions

Q: During 10 seconds of use, 260 C of charge flow through a microwave oven. Compute the size of the…

Q: The thickness of the metal tube used for wire planning ?

A: yes

Q: Whenever current flows through anything with an electrical resistance what happens?

A: When the electrons flow through the conductor, the ions of the conductor collide with the electrons,…

Q: Using ohms law Which is the same for a 10 Ω and a 20 Ω resistor in parallel in a parallel circuit:…

A: Given : R1 = 10 Ω R2 = 20 Ω

Q: Calculate the current drawn by a 1500-W hair dryer connected to a 115-V circuit. (Include unit)

A: Given information:Power drawn (P) = 1500 WattPotential difference (V) = 115 VCurrent (I) =?

Q: What is the effect on the current in a wire if both the voltage across it and its resistance are…

A: Required:- Effect on the current through a wire, when voltage and resistance of the wire are…

Q: A student needs to make a voltmeter that measures 200 V full scale. The only galvanometer available…

A: Write the given data. V=200 VI=10 mA=10×10-3 AR1=1 kΩ

Q: How electricity flow in a circuit?

Q: A current of 18.0. A flow through an electric heated operating on 120 V. What is the heaters…

Q: Current=5 Ampere Voltage=10 Volt Itage%3D find resistance

A: Data provided: Current (I) = 5 Ampere Voltage (V) = 10 Volt Required: Resistance (R)

Q: A light bulb has a resistance of 200 S. It is connected to a power source of 100 V. Find the current…

A: Given: Resistance R = 200 Ohms and the voltage supply is V = 100 V According to the ohms law the…

Q: Describe the process of analyzing a Simple Circuit?

A: Introduction: A simple circuit will contain a battery connected with resistances. The circuit can be…

Q: The diameter of 0 gauge copper wire is 8.252 mm. Find the resistance (in Ω) of a 7.06 km length of…

Q: You are given a galvanometer with a resistance of 22.3 Ω and a full scale deflection current of 6.02…

A: Solution is done below.

Q: An electric bulb draws a current of .8 A and works on 250 V on the average 8 hours a day. a. Find…

A: Given : Voltage (V) = 250 V Current (I) = 0.8 A

Q: power supplied by the current source

Q: In your own words, state the relationship between voltage and current in a circuit.

A: According to Ohm's law, we have, Current is directly proportional to voltage.i.e, when voltage…

Q: Determine the current in each of the branches of the circuit shown in the figure.

A: Let the current flowing through both the loops in anticlockwise direction be i1 and i2 in left and…

Q: power was used

Q: Which of the following will cause the current through an electrical circuit to decrease? Choose all…

A: Current is rate of flow of charge.

Q: During 48 seconds of use, 270 C of charge flow through a microwave oven. Compute the size of…

Q: During 49 seconds of use, 270 C of charge flow through a microwave oven. Compute the size of the…

Q: What is required for current to flow in a circuit? (Don’t overthink this question)

A: solution is given by

Q: current will flow through a circuit

Q: Explain how a bolt of lightning can produce a current in the circuit of an electrical appliance…

A: A bolt of lightning can produce a current in the circuit of an electrical appliance even when the…

Q: Calculate the resistan ce of the bu of the circuit that has 0- a through it and current a voltage a…

A: Given Current I = 0.5 A Voltage v = 110 V

Q: Direct currents do work because of it's mechanical energy. O True O False

A: In a DC motor, When the current carrying conductor please turn on magnetic field experience of…

Q: During 42 seconds of use, 230 C of charge flow through a microwave oven. Compute the size of the…

Q: For current to flow in a circuit, there needs to be a continuous path with no gaps.

A: Electric current always flow when the circuit is closed, that means path is continuous without any…

Q: 1.4 Find the voltage drop across a light bulb if 0.05A current flowing through it for 4 seconds…

Q: en of the circuits below consists of identical batteries and resistors. All of the switches are…

A: When identical resistors are connected in series, the equivalent resistance is Req = nR, where n =…

Q: Find the voltage drop across a light bulb if 0.05A current flowing through it for 4 seconds causes…

Q: Using thevenin's theorem find the current in the load resistance if the load is a) 2 ohms b) 1 ohm

Q: A Toaster uses 120_volts and allows 10 amps of current of flow . how much power does it consume ?

Q: An amplifying circuit is an example of a converging circuit. True or false

Q: : For the circuit shown in below, find the current IL through 6 N istor using Thevenin's theorem.

A: Note:- “Since you have asked multiple questions, we will solve the first question for you. If you…

Q: Determine the current through each of the ammeters

A: Power dissipation in a circuit P = VI here, V= potential difference I= current…

Q: A 0.1 mV emf and a 2 cm cube of pure gold are connected. Calculate the current measured by an…

A: Given- Emf V=0.1 mV=0.1×10-3V Length L=2 cm=0.02 m Area A=0.02×0.02=0.0004 m2 Taking for pure gold…

Q: using mesh current method , find the currents in the circuit

Question

To find the current flowing in a circuit one can use what law?

Expert Solution

Step 1

If a circuit contains the resistance of R and the voltage potential applied to it is V, the current flowing in a circuit can be determined by using Ohm’s law.

Step by step

Solved in 2 steps

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Find the currents flowing in the circuit in Figure 21.47.
Shown below are the results of an experiment where four devices were connected across a variable voltage source. The voltage is increased and the current is measured. Which device, if any, is an ohmic device?
In Figure 18.8, the current is measured with the ammeter on the right side of the circuit diagram. When the switch is closed, does the reading on the ammeter (a) increase, (b) decrease, or (c) remain the same? Figure 18.8 (Quick Quizzes 18.5 and 18.6)
. A car’s headlight consumes 40 W when on low beam and 50 W when on high beam. (a) Find the current that flows in each case (b) Find the resistance in each case.
. Find the current that flows in a 40-W bulb used in a common household circuit Compare this with the answer to the first part of Problem 19.
In Figure 18.8, the current is measured with the ammeter on the right side of the circuit diagram. When the switch is closed, does the reading on the ammeter (a) increase, (b) decrease, or (c) remain the same? Figure 18.8 (Quick Quizzes 18.5 and 18.6)
The switch S of the circuit shown below is closed t =0. Determine (a) the initial current through the battery and stead-state current the battery.
In Figure 18.5, the current is measured with the ammeter at the bottom of the circuit. When the switch is opened, does the reading on the ammeter (a) increase, (b) decrease, or (c) not change? Figure 18.5 (Quick Quizzes 18.3 and 18.4)
Consider the circuit shown below, (a) I1,I2,I3,I4,andI5 (b) Find the power supplied by thevoltage sources, (c) Find the power dissipated by the resistors.
Two resistors, A and B, are connected in a series circuit with a battery. The resistance of A is twice that of B. Which resistor dissipates more power? (a) Resistor A does. (b) Resistor B does. (c) More information is needed.
Sometimes resistances in a circuit are described as being connected head to tail and all heads and all tails connected together. What is being described?
The diameter of 0-gauge copper wire is 8.252 mm. Find the resistance of a 1.00-km length of such wire used for power transmission.