To move the oil drum, the resultant of the three forces shown must have a magnitude of 500 N. Determine the magnitude and direction of the smallest force F that would cause the drum to move. 250 N F 25° OIL 300 N

To move the oil drum, the resultant of the three forces shown must have a magnitude of 500 N. Determine the magnitude and direction of the smallest force F that would cause the drum to move. 250 N F 25° OIL 300 N

Name: To move the oil drum, the resultant of the three forces shown must ha
Uploaded: 2024-03-20T06:56:46.000Z
Channel: Bartleby
Description: To move the oil drum, the resultant of the three forces shown must have a magnitude of 500N. Determine the magnitude and direction of the smallest force F that would cause the drumto move.250 NF25°OIL300 N

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 1STP

See similar textbooks

Similar questions

The figure shows a claw hammer as it pulls a nail out of a horizontal board. Single point of contact 5.04 cm 28◦ F 31 cm If a force of magnitude 189 N is exerted horizontally as shown, find the force exerted by the hammer claws on the nail. (Assume that the force the hammer exerts on the nail is parallel to the nail). Answer in units of N. please help
When rebuilding his car's engine, a physics major must continuously exert 4.02 ✕ 102 N of force to insert a dry steel piston as it slides into a steel cylinder. What is the normal force (in N) between the piston and cylinder? (Enter the magnitude.)
Find the resultant of the following forces by polygon method : F1=12 N, South; F2= 24N 30 degree north of west; F3= 15 N, 75 degree of west; and F4=32 N, 50 degree south of east
A 23.4 kg lead mass rests on the bottom of a pool. What is the normal force acting on the lead? (?lead = 11.3 × 103 kg m–3)
A 3.0 kg box is pulled by applying a force with magnitude 8.0 N at an angle of 60⁰ above the horizontal as shown below, what are the x and y components of the force, F.
The wind force (F) on a flat vertical surface varies jointly as the area of the surface (A) and the square of the wind velocity (V). Suppose that the constant of variation is 40, find the force (in lbs) of the windstorm on 10 ft by 12 ft rectangular sign board that has a velocity of 60mi/hr
Draw the FBD of this problem.An object weighing 95 N is suspended by two wires, the left wire makes an angleof 37 0 with the vertical while the right wire is projected 26 0 with the horizontal.Find the tension in each wire.
Two tension ropes are connected to a wall and subject to forces as shown by the diagram below. Determine if the system is in equilibrium. If not, find the magnitude of the unbalanced force. a. The system is in equilibrium b. Not in equilibrium, magnitude of resultant force = 75N c. Not in equilibrium, magnitude of resultant force=10N d. Not in equilibrium, magnitude of resultant force = 25N
the total aerodynamic force F acting on the airplane has a magnitude of 6250 lb. Resolve this force into vertical and horizontal components
Two forces act on an object. F1 = 100 N at 30 degrees North of East. F2 = 50 N 20 degrees West of North. Find a third force that will hold the object in equilibrium use the component method of vector addition.
A man weighs 210 lbf at a location where g= 32.10 ft/s2. Determine his weight on the Mars, where g= 5.47 ft/s2.
Find the resultant of the following forces using the polygon method and mathematical method.A = 30N at 45°B = 25N at 125°C = 15N at 220°