Calculate the value of Zab in the network j6 Ω -j9 Ω α. -j9 Ω bo j6 Ω j6 Ω 20 Ω 20 Ω -j9 Ω 10 Ω

Q: 3/ By measuring the rf voltage amplitude along a line with voltmeter, it is found that the voltage…

A: Given data, The value of VSWR = 7

Q: What is the output F of the following circuit? * +2.5 V OVO MP1 MNI +2.5 V Mp2 F MN2

A:

Q: Determine IDQ, VGSQ, and VDS for the network of Fig below.When VDD=40V, RD=3K, RS=1K, R1=24M,…

A: A JFET is a junction field effect transistor. It is a semiconductor device with three terminals…

Q: An auxiliary phase winding is used in a single-phase fractional horsepower motor to A. decrease flux…

A: In this question we will write about auxiliary phase winding.....

Q: Explain briefly the following: (a) How the transmitting signal is generated in the FM-CW radar?…

A: A RADAR is abbreviation of RAdio Detection And Ranging. A radar signal is based on the…

Q: Q6/ For the below system, determine the state space expression and explain it in a block diagram.…

A: Given  A transfer function, we need to determine the state space equation and block diagram. Please…

Q: 1. Calculate the gain of a negative-feedback amplifier having A = -2000 and p = -1/10. 2. Calculate…

A:

Q: The expression of output in the following CMOS circuit is

A:

Q: Let A = -2ax + 5ay + az, B = ax + 3az, and C = 4ax -6ay + 10az. Find A ∙ (B x C)

A:

Q: Refer to the Figure below, calculate Z₁. Assume VGSQ = -2.2V. (VDD = 12V, RD=3.3kohms, Rs=1.1kohms,…

A:

Q: Given the vector current density J = 8p³ z 3 : ap - 8p sin 2 ay m A/m ² find the current density at…

A: We need to find out the current density and current .

Q: Refer to the Figure below. VDD RD HIV V₁0H Zo Z₁ Rs Compute for mV (with load) VO= if VDD-20V.…

A: Brief description : For the given common source MOSFET we need to calculate the value of output…

Q: 3. For the given network, determine (a) Ig (b) Ic (d) V (d) VCE

A:

Q: The two-wattmeter method gives P1=1200W and P2=-400W for 3-Ph motor running on 240V line. Assume…

A: In this question we need to find a power factor of the motor and it's phase impedance.

Q: Refer to the Figure below, calculate Z₁. Assume VGSQ = -2.2V. = VDD-12V, RD-3.5kohms, Rs-1.0kohms,…

A: Brief description: For the given common gate amplifier circuit we need to derive its input…

Q: Refer to the Figure below. VDD D Hov S Rs Cs Compute for Av= (without load) if VDD=20V, RG-159Mohms,…

A: Brief description : For the given MOSFET we need to calculate the value of voltage gain without…

Q: 2. A 3-phase, 11kV, star-connected alternator has armature resistance of 12/phase and a synchronous…

A:

Q: Q 5 . An DC engine connected in compound-cumulative mode has the following values: Nominal…

A: The given circuit diagram is shown below:    The magnetic curve is shown below:

Q: It is the ratio of the potential difference between the two ends of the conductor to the current…

A: Ratio of potential difference between the two ends of the conductor to the current through the…

Q: Determine IDQ, VGSQ, and VDS for the network of Fig below.When VDD=40V, RD=3K, RS=1K, R1-24M,…

A: The required parameters can be calculated by using the DC analysis of the MOSFET amplifier.

Q: What is the significance of connecting the Zener diodes back-to-back?

A: Given  We need to enumerate the significance of connecting zener diodes back to back. Please find…

Q: Two- Explain what is the difference and commonality between the transfer function and the state…

A: This question is related to control systems

Q: Q1/ Find the state and output equations for the electrical network shown in The below figure if the…

A: Electrical network: This is a network that contains the electrical elements as resistors, inductor,…

Q: A 440 V, shunt motor has armature resistance of 0.8 ohm and field resistance of 200 ohm. Determine…

A: Given data, Terminal voltage V = 440 V Armature resistance Ra=0.8 Ω Field resistance Rsh=200 Ω…

Q: RSFE_2C QUESTION 2 I The superposition principle can be applied to a voltage-divider circuit with…

A: The superposition theorem is used to analyze a circuit consisting of many independent sources. This…

Q: 1. Find the total quality of water available in the period of the month. 2. Determine the average…

A: It is given that: Area of Lake=500 km2Total drainage area of lake =Ax=6000 km2 with lakeInitial…

Q: A 250kVA single phase transformer has an iron loss of 2kW and the maximum efficiency at 0.8 P.F…

A:

Q: A perfect conductor cannot contain an electrostatic field within it. Under static conditions EXCEPT…

A: Electric field: It is a region of around of a charge particle in this region a charge particle feels…

Q: What is the largest value of output voltage from an 8-bit DAC that produces 1.0V for a digital input…

A:

Q: نقد * Why we need synchronization bits in ?TDM To decrease bandwidth To decrease system complexity…

A:

Q: R₁ = 50m2 M lov R₂=51² Find the current in the dioden

A:

Q: QUESTIONS 1. Is it possible to measure the phase difference of two sine waves with a single-input…

A: Solution (1) - oscilloscope - An oscilloscope is a variety of electronic examination tool that shows…

Q: A system has a forward power of 60 W, reflected power of 3 W, and transmission line loss of –3 dB.…

A:

Q: Q2. A three-phase ring main distributor ABCD, fed from point A and supplies balanced loads as…

A:

Q: Use MESH ANALYSIS to find the value of vo(t) if the value of is = 10cost(30t+20°) A.

A:

Q: 4-A 1-phase transformer has 180 and 90 turns respectively in its secondary and primary windings. The…

A:

Q: Q5/ For the below system -1 0 x₂ = 3 1 1 1 y = [1 0 0 A-Obtain the transfer function B-Evaluate if…

A: Transfer function: It gives the information of the relationship between output and input. The…

Q: 8. Three JK flipflops are connected as a synchronous counter that goes through the following…

A: In this question we need to design a given counter

Q: *How CDMA more important ?than TDMA and FDMA Decrease bandwidth Decrease the noise Decrease power…

A: CDMA stands for Code division multiple access FDMA stands for Frequency division multiple access…

Q: The resistance of round long wire of diameter 4 mm is 4.03 2/km. If a current of 40 A flows through…

A:

Q: Deduce the function of the following circuit: 5V Q3 2N6804 -ru A 1kHz 5V Q2 Q1 2N6659 B (1kHz 5.V .…

A:

Q: Find The Z Parameters for the circuit shown I₁ 3001₁ 1₂

A: Given circuit,

Q: Q1. A single phase A.C. radial distributor system has long of 600m and a total impedance of…

A:

Q: ns. 1. Iron los..........varies approximately as V². 2. Cu loss..........it also varies as but…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: The ac bridge shown in Fig. 9.84 is known as a Maxwell bridge and is used for accurate measurement…

A:

Q: Question1): Find the current and voltage for each element in the fig. (1) Sketch the v and curves.…

A:

Q: 11 V- Vin || OV 60000 1500Ω 3300 100 Ω Vout

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: The adjacent controlled rectifier has the following parameters: R = 5.20, L = ∞ and a firing delay…

A: Given information about a three phase half-wave rectifier is, Per phase r.m.s. value of input AC…

Q: Electrical Engineering For a unit feedback system having the following gain functions: G(s) Ks -…

A: Given: For a unity feedback system having the following gain functions: Gs=Ks-4.21s22s+5.7 To find:…

Q: Find the currents using Maxwell's Method

A: Brief description: By the use of mesh analysis we need to calculate the values of all the branch…

Current Division Method

The generalized current divider formula is given by the following relation below,