Two heating units x and y are connected across a 100 V supply. Unit y takes twice as much power as unit x. Total power supplied by the source is 2280 watts. Determine the total power drawn by the heating units if they are connected in series across the same source.

Q: The data for a wind turbine is given below: Wind speed = 14 meters/sec, Length of blade = 10 meters.…

A:

Q: A heater coil rated at 1000 W, 220 V is connected to 110 V line. Power consumed is?

A:

Q: 10. A 110-Volt AC line feeds two circuits in parallel. The currents are (2.2 - j6.5)A and (1.8 –…

A: Since you have asked for question 10 . So we are providing solution for question 10 . This question…

Q: A single-phase 120 v consisting of R = 10 absorbed by the load.

A: Given:Vs=120∠0° Vf=60 HzR=10ΩL=25 mHC=200 μFXL=ωL=2πfLXL=2×3.14×60×25×10-3XL=9.42…

Q: Four identical dry cells with an emf of 1.4 volts and internal resistance of 0.06 ohm each, are…

A:

Q: 8is 8io 2i0 3 50

A:

Q: ed in parallel to a 125 volt DC source. Load X has a resistance of 5 ohms while load Y takes 5 kW of…

A: A circuit with X, Y, and Z components are in parallel is given.

Q: Based on the Figure 4.1, calculate the voltage across the resistor, the real power and reactive…

A:

Q: For the circuit shown in Figure, find the following a. The magnitude of current in the circuit, 7.…

A:

Q: 2. If P is the power of a star connected system then what will be power of an equivalent delta…

A: The power in the system is always constant. It doesn't depends on star or delta connection. Power of…

Q: hree resistors each having a resistance of 11 ohms are connected in delta across a three-phase 440 V…

A: Based on the given data consider the following circuit for which w calculate line current & 3ph…

Q: determine total power consumed by resistor 3?

A:

Q: The figure below shows a semi-log plot of the power consumed in the load as a function of the load…

A: In a semi-log plot, each vertical line intersecting at the horizontal axis represents 1/10th of the…

Q: I |(1) (2) (3) 10 2 52 V = 100 -<45° ( ww

A: By the complex power analysis

Q: The power factor (pf) in the circuit is .60. How many Watts is the circuit drawing? (Round your…

A: Line to line voltage= 208V Current I= 24.5A Power factor = 0.6 Find the active power P?  Number of…

Q: Three loads X, Y and Z are all connected in parallel to a 125 volt DC source. Load X has a…

A:

Q: From the circuit diagram of power measurement using two wattmeter for delta connected load in…

A: Two wattmeter connection is used for measuring the three phase power of circuit This two wattmeter…

Q: xL=20 ohm, xC=5 ohm and an R resistor are connected in series with the AC source. Since the current…

A:

Q: Two heating units x and y are connected across a 100 V supply unit y takes twice as much power as…

A: Given data: Vin=100 V Pin=2280 W P2=2P1

Q: 1. Two generators have the following fuel cost functions: C:75 + 10P, + 0.015P? C2: 80 + 8.5P, +…

A: Given: Two generators have the following fuel cost functions: C1=75+10P1+0.015P12…

Q: Figure 4 is a 120/240 volt 3 wire service. What would the voltage be across the 40 watt load if the…

A: From the circuit shown the neutral is disconnected from the supply then to determine the voltage…

Q: Given DC voltage and AC sinewave voltage in series, what would be the total power delivered to a…

A:

Q: In the experiment 1, the values are tabulated, find the load power factor. VL in Volts W, in watts…

A: In this question , we will find power factor using given data..

Q: Suppose 85 kW is to be transmitted over two 0.120 Ω lines. 1) Estimate how much power is saved if…

A: Given: Pout=85 kWVout=220VRlines=2×0.120ΩEfficiency=99%

Q: THE BELOW CIRCUIT IS SHOWN PLEASE FIND WHAT THE WATTMETER READING WILL BE

A: Here, in the given circuit the current coil is in series with the impedance and the voltage coil is…

Q: How many kilowatts of power are delivered to a circuit by a 240V generator that supplies 20A to the…

A:

Q: resistance of 16 ohms and reactance of 12 ohms and are star Calculate the following: a. Line voltage…

A:

Q: 1-connect the circuit shown in figure (2). 2-set the D.C power supply V1 & V2 to 10 volts…

A:

Q: (b) With the aid of circuit diagram, briefly explain how a regulated de power supply is obtained…

A: A regulated DC power supply can be made as: So, the main components of a regulated DC power supply…

Q: For the circuit shown, find the value of coupling ?total consumed power is (450 W) 122 J92 80/00…

A: Circuit diagram is given as, Total equivalent circuit of the circuit is,

Q: 204 2e for the Circuit shown betoet find the fotal Power delivered to the Circuit? and find The…

A: We will try to find the power delivered to the circuit and also the current passing through the 12…

Q: For the circuit shown in Figure, find the following: a. The magnitude of current in the circuit, I.…

A: To find current and power dissipated in each resistor  And value of unknown resistance R

Q: Consider the following circuit. How much power flows through circuit of element D?

A:

Q: A load with a power factor of 0.9 draws 10 A current from the 220 V network. The power drawn will be…

A:

Q: When a 12-Ohm bulb is connected in series with a battery then find the vlaue of the current flowing…

A:

Q: Given - 50 kvA, 0.7pf lagging, purely resistive load If this will be corrected to 0.8pf lagging,…

A: we  need to determine true power.

Q: 1. Is a wattmeter required to measure the real power delivered to a resistive load? __________…

A: 1- A wattmeter measures watts, real power. When the system is considered as balanced With a…

Q: If the available head of the hydrostation is 280m and available water flow is 1275 cu.meter per…

A: ANSWER : OPTION : C

Q: 4-ohm resistor is W.

A:

Q: : 500 kVA is given an open circuit test from which the iron loss is found to be 3.5k W. A short…

A: Iron loss is given As iron loss is independent of load therefore total iron loss in 24 hour is,…

Q: Two resistors 18 ohms and 24 ohms are to be connected in parallel across the certain voltage source…

A: In this question,  We need to choose the correct options What is voltage across the series…

Q: hms b. 2 ohms c. 4 ohms d. 1 ohm   3. A 40-ohm resistor and a 60-ohm resistor are in parallel. In…

A: As per the guidelines of Bartleyby I need to answer  two questions only.But I answered 3 questions.

Q: ACTIVITY 1: FLOW DIAGRAMING Fill in the boxes below to show the correct flow of the process of…

A: Electrical energy is required in every sphere of life and is the basic necessity today. it can be…

Q: Find the power dissipated by 10 ohms resistor using Kirchhoff's Law

A:

Q: Part B)Suppose 82 kW is to be transmitted over two 0.110 Ω lines. Estimate how much power is saved…

A: It is given that: P=82 kWRline=2×0.110 ohmV=100 to 1000 V

Q: Is a wattmeter required to measure the real power delivered to a resistive load? __________ Explain.

A:

Q: For the circuit shown in Figure, find the following: a. The magnitude of current in the circuit, I.…

A: The solution can be achieved as follows.

Q: C. DC source voltage: 24 2. Using Ohm's Law and your resistance and voltage measurements, calculate…

A: Only one question can be answered according to bartleby policy.

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.