1. Is a wattmeter required to measure the real power delivered to a resistive load? __________ Explain.

Q: 1-Question.Is it important to understand the effect of over voltage and under voltage in the power…

A: As per Bartleby guidelines we are allowed to solve only one question,please ask the rest again. The…

Q: Any example traced in your reading material, connections between the current and the potential…

A: Correct option is c.

Q: Refer to the National Electrical Code or the working drawings when necessary. Where applicable,…

A: The given  3 transformer bank is a delta-delta connection in which the primary side is a 3-phase-3…

Q: Can I use the 66-block in telephone wire distribution to its outlets? How is it distributed?

A: According to the question, we need to explain the 66-block in telephone wire distribution.

Q: Explain the use of cable glanding

A: Cable glands are commonly defined as mechanical cable entry devices The use of cable glanding?

Q: List typical values of working voltages for Generation, Transmission and Distribution seen in the…

A: Given  We need to list out typical values for generation, transmission and distribution voltages in…

Q: Additional information of Wind Power System?

A: Wind energy is also a form of solar energy. Wind energy describes the procedure by which air is used…

Q: What spaces are not included in floor area when calculating the load in volt amperes per square…

A: For calculating the load, first evaluated the total floor area. And according to the NEC , the total…

Q: True or False   If a metal rack is properly grounded the equipment that is mounted on the rack and…

A: The above-mentioned statement is TRUE which states that the equipment which is mounted on the rack…

Q: A residential service entrance load calculation is required to correctly size which of the…

A:

Q: Draw the block diagram and clearly explain the operation of gas power station.

A: To explain gas power station

Q: (a) With an appropriate block diagram, briefly describe the function of the main system available in…

A: Power is the basic need for the economic development of any country in the world. Availability of…

Q: Explain the power transmission and distribution system through diagram

A: An electric power system is a network of electrical components used to supply, transmit and use…

Q: A suspension string have 3 units. Voltage across topmost and lower most unit of string are 6.71…

A: Total string voltage = Sum of voltages across the each Unit. Given there are 3 units  and voltage…

Q: We want to install the 2000-meter wire in the college building, which one testing is the most…

A: Here, we required to install the 2000-meter wire in the college building.

Q: Write short note on the below mentioned questions, Each question carries one mark. Students has to…

A: AS PER OUR GUIDELINES ONLY THREE QUESTIONS ARE ANSWERABLE   a) High Voltages are Preferred for…

Q: b) With a neat diagram, explain the working of the Geothermal Power Plant

A: Geothermal power station uses the earth's hydrothermal energy to heat and generate electricity. So…

Q: What is the unit load per square foot for dwelling units.

A:

Q: A stand-alone pedestrian crossing sign is located in Miami, FL. The sign is lit 24/7 with tiny LED…

A: According to the question,   Determine if the designers provided the right type of equipment for…

Q: ity or enery that are used by

A: The power system consists of electric generation, distribution and customer satisfaction. In a…

Q: Question 5- Power Network, Frequency & Connected Load a) In the UK and many other countries, there…

A: The legal requirement to maintain the voltage and frequency with permitted tolerances is due to the…

Q: You are an electrician working in an industrial plant. The company is constructing a maintenance…

A:

Q: Electric Powers System for Nonelectrical Professional can you describe effective preventive…

A: Electrical Preventive Maintenance (EPM) is the act of leading routine assessments, tests, and the…

Q: (A) For the two types of faults that are common in power systems, discuss their causes and the…

A:

Q: If asked to determine the power rating (MVA rating) of an overhead line, do they mean the power…

A: The power rating of a transmission line is defined at the designing phase of the line. Power carried…

Q: Discuss the three main categories of hydroelectric projects.

A: The three main categories of hydroelectric projects are as follows:  Impoundment facility…

Q: what is the type of the Iraq electricity tariff

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: What happens in a multi-wire branch circuit when the grounded (neutral) opens or becomes…

A: The explanation is as follows.

Q: A 20 HP motor load takes 80 amperes over a feeder line with 0.05-ohm resistance per conductor. If…

A: In this question we need to find a efficiency of the given system.

Q: Describe grounding system in a lighting circuit and lighting switching system and control.

A:

Q: electric power system

A: NOTE- “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: Why is the circuit overdamped? Explain.

A:

Q: A Hydroelectric Plant has a turbine and generator with an efficiency of 84%. If the dam has a head…

A: Given:

Q: Explain how electricty power is generated and tramnsimitted to customer unit. Show The single line…

A: The electrical power is generated and transmitted to the consumer : The electrical power is…

Q: Identify the parts of the wind power system shown.

A: To identify the parts of a wind power systems

Q: How does the distance between a power plant and a substation affect the power losses in transmission…

A: In this question we will write about how distance between effect power plant and substation effect…

Q: In the distribution transformer; In the transformer used for the distribution of electricity to the…

A: distribution transformer step down the voltage incoming to distribution transformer =3.3 kV outgoing…

Q: Is a wattmeter required to measure the real power delivered to a resistive load?

A: No, if the load is resistive load then only voltage across the load is measured. For example…

Q: 1. What is the difference between Miswire and short in the cabling?

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: At what volts is the alternator end voltage short-circuited? At nominal voltage What will happen if…

A: At what volts is the alternator end voltage short-circuited? At nominal voltage What will happen if…

Q: What does it mean by connection of wattmeter confused?

A: In this question we will write about connection of wattmeter meaning in given figure...

Q: A one watt 470-ohm resistor is connected to 24 volts. Is the resistor operating within its power…

A: A one watt 470-ohm resistor is connected to 24 volts. Is the resistor operating within its power…

Q: Fuse and circuit breakers are the common household circuit.   TRUE OR FALSE

A: Answer: TRUE  Because Nowadays  in every where we use these fuses and circuit breaker to protect our…

Q: Which of the following is not an approved grounding method? A) Metallic underground water piping B)…

A: Electrical grounding is a backup pathway that provides an alternating route for the current to flow…

Q: What code set standard for electrical installation work

A: The NEC provide code set standard for electrical installation work. NEC- National Electrical Code

Q: Explain and draw a diagram of 3 wattmeter method?

A:

Q: The recommended limit of voltage drop on a lighting circuit for a single-phase supply as per IEE…

A: 1) 230 V  The value of supply voltage is 230 v as per IEE wiring regulations

Q: 6.a. The amount of short-circuit current that flows depends upon the amperes available at the source…

A: The short circuit current is depends on impedance of short circuit and voltage across it. From that…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.