E PHYS220 Spring-2021 Exam-2 x40 cmTwo identical sinusoidal waves with wavelengths of 1.5 m travel in the samedirection at a speed of 10 m/s. If the two waves originate from the same startingpoint, but with time delay At between them, and with resultant amplitudeA resultant = V3 A then At will be equal to:0.01 sec0.005 sec0.00625 sec0.025 secO 0.0125 secThe left end of a taut string of length L. is connected to a vibrator with a fixedfrequency f. The right end of the string is tied to a suspended object of varyingmass, m, through a pulley. For a mass m1 of the object, a standing wave with onewave with two loops is

Wavelength of the wave is 1.5 m Speed of the wave is 10 m/s

Two identical sinusoidal waves with wavelengths of 1.5 m travel in the same direction at a speed of 10 m/s. If the two waves originate from the same starting point, but with time delay At between them, and with resultant amplitude A resultant = V3 A then At will be equal to: %3D O 0.01 sec O 0.005 sec O 0.00625 sec O 0.025 sec O 0.0125 sec

Two identical sinusoidal waves with wavelengths of 1.5 m travel in the same direction at a speed of 10 m/s. If the two waves originate from the same starting point, but with time delay At between them, and with resultant amplitude A resultant = V3 A then At will be equal to: %3D O 0.01 sec O 0.005 sec O 0.00625 sec O 0.025 sec O 0.0125 sec

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter16: Waves

Section: Chapter Questions

Problem 111P: Two sinusoidal waves with identical wavelengths and amplitudes travel in opposite directions along a...

See similar textbooks

Similar questions

On a marimba (Fig. P18.75), the wooden bar that sounds a tone when struck vibrates in a transverse standing wave having three ant modes and two nodes. The lowest-frequency note is 87.0 Hz, produced by a bar 40.0 cm long, (a) Find the speed of transverse waves on the bar. (b) A resonant pipe suspended vertically below the center of the bar enhances the loudness of the emitted sound. If the pipe is open at the top end only, what length of the pipe is required to resonate with the bar in part (a)?
As you travel down the highway in your car, an ambulance approaches you from the rear at a high speed (Fig. OQ17.3) sounding its siren at a frequency of 500 Hz. Which statement is correct? (a) You hear a frequency less than 500 Hz. (b) You hear a frequency equal to 500 Hz. (c) You hear a frequency greater than 500 Hz. (d) You hear a frequency greater than 500 Hz. whereas the ambulance driver hears a frequency lower than 500 Hz. (e) You hear a frequency less than 500 Hz. whereas (he ambulance driver hears a frequency of 500 Hz.
Two identical loudspeakers 10.0 m apart are driven by the same oscillator with a frequency of f = 21.5 Hz (Fig. P17.6) in an area where the speed of sound is 344 m/s. (a) Show that a receiver at point A records a minimum in sound intensity from the two speakers. (b) If the receiver is moved in the plane of the speakers, show that the path it should take so that the intensity remains at a minimum is along the hyperbola 9x2 16y2 = 144 (shown in red-brown in Fig. P17.6). (c) Can the receiver remain at a minimum and move very far away from the two sources? If so, determine the limiting form of the path it must take. If not, explain how far it can go. Figure P17.6
In figure OQ18.1 (page 566), a sound wave of wave-lenght 0.8 m divides into two equal parts that recombine to interfere constructively, with the original difference between their path lengths being |r2 r1| = 0.8 m. Rank the following situations according to the intensity of sound at the receiver from the highest to the lowest. Assume the tube walls absorb no sound energy. Give equal ranks to situations in which the intensity is equal. (a) From its original position, the sliding section is moved out by 0.1 m. (b) Next it slides out an additional 0.1 m. (c) It slides out still another 0.1 m. (d) It slides out 0.1 m more.
(a) What are the loudnesses in phons of sounds having frequencies of 200, 1000, 5000, and 10,000 Hz. if they are all at the same 60.0dB sound intensity level? (b) If may are all at 110 dB? (c) If they are all at 20.0 dB?
The speed of a one-dimensional compressional wave traveling along a thin copper rod is 3.56 ktn/s. The rod is given a sharp hammer blow at one end. A listener at the far end of the rod hears the sound twice, transmitted through the metal and through air, with a time interval t between the two pulses, (a) Which sound arrives first? (b) Find the length of the rod as a function of t, (c) Find the length of the rod if t = 127 ms. (d) Imagine that the copper rod is replaced by another material through which the speed of sound is r. What is the length of the rod in terms of t and r? (e) Would the answer to part (d) go to a well-defined limit as the speed of sound in the rod goes to infinity? Explain your answer.
Two sinusoidal waves with identical wavelengths and amplitudes travel in opposite directions along a string producing a standing wave. The linear mass density of the string is =0.075 kg/m and the tension in the string is FT=5.00 N. The time interval between instances of total destructive interference is t=0.13 s. What is the wavelength of the waves?
A trough with dimensions 10.00 meters by 0.10 meters by 0.10 meters is partially filled with water. Smallamplitude surface water waves are produced from both ends of the trough by paddles oscillating in simple harmonic motion. The height of the water waves are modeled with two sinusoidal wave equations, y1(x,t)=0.3msin(4m1x3s1t) and y2(x,t)=0.3mcos(4m1x+3s1t2) . What is the wave function of the resulting wave after the waves reach one another and before they reach the end of the trough (i.e., assume that there are only two waves in the trough and ignore reflections)? Use a spreadsheet to check your results. (Hint: Use the trig identities sin(uv)=sinucosvcosusinv and sin(uv)=sinucosvcosusinv
In an earthquake, both S (transverse) and P (longitudinal) waves propagate from the focus of the earthquake. The focus is in the ground radially below the epicenter on the surface (Fig. (CQ16.9). Assume the waves move in straight lines through uniform material. The S waves travel through the Earth more slowly than the P waves (at about 5 km/s versus 8 km/s). By detecting the time of arrival of the waves at a seismograph. (a) how can one determine the distance to the focus of the earthquake? (b) How many detection stations are necessary to locate the focus unambiguously?
The area of a typical eardrum is about 5.00 X 10-5 m2. (a) (Calculate the average sound power incident on an eardrum at the threshold of pain, which corresponds to an intensity of 1.00 W/m2. (b) How much energy is transferred to the eardrum exposed to this sound lor 1.00 mill?
(a) If a submarine’s sonar can measure echo times with a precision of 0.00100 s, what is the smallest difference in distances it can detect? (Assume that the submarine is in the ocean, not in fresh water.) (b) Discuss the limits this time resolution imposes on the ability of the sonar system to detect the size and Shape of the object creating the echo.
Two strings are attached between two poles separated by a distance of 2.00 m as shown below, both under the same tension of 600.00 N. String 1 has a linear density of 1=0.0025 kg/m and string 2 has a linear mass density of 2=0.0035 kg/m. Transverse wave pulses are generated simultaneously at opposite ends of the strings. How much time passes before the pulses pass one another?