Answered: Two long parallel current carrying…

Two long parallel current carrying wires are separated by 5 cm in air and are carrying current of 20A in the opposite direction. The force per meter length between the two wires will be (in N/m)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: It converts the electrical energy collected from the catenary via pantograph into mechanical energy.…

A: The electricity is supplied to the train by the connection between the sliding contacts of the…

Q: You have conducted an experiment, a 20 uF capacitor, a 45 W lamp, a 0.6 H inductor with 35 ohm…

A: Given: You have conducted an experiment, a 20 μF capacitor, a 45 W lamp, a 0.6 H inductor with…

Q: A current of 3.6 A transfers a charge of 375 mC. How long would this take?

A: It is given that: I=3.6A Q=375 mC

Q: 5. Determine the following: a. Total Current and currents passing through each of the resistance. b.…

A: The required parameters can be calculated by using mesh analysis and current division rule.

Q: The corrected readings of a voltmeter, an ammeter, and wattmeter when connected to measure the…

Q: 5. Solve for all possible values of the real numbers x and y in the following equation: x+iy+2+3i…

Q: Find / and Vab in the circuit given below, where the value of Vv is 30 V. Vv +1 3Ω ww 10 V + Vab b…

A: The given circuit is shown in below,

Q: Q9/C ompute the discrete-time Fourier transform of the sequence x(n). Plot DTFT magnitude and angle…

A: Given: A discrete time sequence, x[n]=n(0.9)n[u(n)-u(n-21)] To do: Compute the DTFT of x(n). Plot…

Q: Assuming that a 4-bit ADC accepts analog input ranging from 0 to 6 volts, solve the following: a)…

A: a) The number of quantization levels is given by the expression as shown below: Quantization…

Q: Problem 4. Show that the expression x(t) = te 2 is a solution of the critically damped oscillator.…

Q: Q5: Design an Armstrong indirect FM modulation to generate an FM signal with carrier frequency 97.3…

A: Given Frequency of carrier signal fc=97.3 KHz output frequency of NBFM, fc1=2KHz ∆f=5KHz Range of…

Q: An analog television signal containing frequencies up to 4.5MHz is to be coded by an ADC. The…

Q: The system that has the transfer function G(s) = Underdamped system Undamped System Critically…

A: Given data, Transfer function is given as, Gs=144s2+6s+144.

Q: 2. Use Linearity property where lo = 1 mA is assumed to find the actual value of lo. 12 ΚΩΣ ww 4 ΚΩ…

Q: 48 V + 4Ω www 2Ω ww ww 4Ω 6 Ω t=0 IL 1Η ww 5 Ω ww ww m 10 Ω 20 Ω M 1ο 20 Ω

A: Solution: Since the switch has been closed for a long time, so the inductor had reached its steady…

Q: Consider the inverting amplifier, using an ideal operational amplifier shown in the following…

A: We need to find out the resistance for given amplifier circuit

Q: Q28. * Which of the following paths is not a simple cycle? A F 8 D 7 3 B G 13 E 10 14 11 C 12 H OP=…

A: Given: Path diagram,

Q: 5. For the circuit of Figure E, find i₁, i2, i3, and i4.

Q: Q4: A: A string of 3 insulators and the ratio of Ce/C = 0.15, if the string is connected to 3-0 line…

A: Given: String of 3 Insulators CeC= 0.153 phase Line Voltage = 33 kv

Q: The supply frequency to the stator of an 8-pole induction motor is 70 Hz, and the rotor frequency is…

A: Number of poles p = 8 Frequency of stator fs = 70 Hz Frequency of rotor fr = 6 Hz

Q: MNOP For the given logic circuit, find the following: a. Logic Equation or Output b. Simplified…

Q: Two-watt meters, which are connected to measure the total power on a three-phase system supplying a…

A: Given data, First watt-meter P1=10.5 kW Second watt-meter P2=-2.5 kW

Q: A 36- pole alternator is operated at 200 rpm. What frequency is generated?

A: Given, Number of poles in alternator, P=36. Speed of operation, Ns=200 rpm.

Q: 1. Consider the circuit element shown below, where v(t) = √8 cos(3t - 45°) and i(t) 6 cos(3t). (d)…

A: voltage is given fir v(t) = 8cos3t-450 current is given i(t) = 6 cos(3t)

Q: In order to measure the power taken by a small 120-V 60-Hz single-phase induction motor, it is…

A: Given data: The voltage VS=220 V, 60 Hz The resistor current, IR=3 A The motor current,IL=4.2 A…

Q: A self-inductance of 10 mH and its resistance 50 connect to AC source of voltage 200 V, and…

Q: Q2: Fill in the blanks for the following 1- The main steps of communication system are 2- The…

Q: Let f be the function defined for - ≤ x ≤ π by f(x) = [1 if π/2 ≤ x ≤ π/2 otherwise 0 and then…

A: A Fourier series is a total that sums the sine and cosine waves to depict a periodic function. Each…

Q: Solve for the equivalent capacitance at terminals a and b from the circuit. Given C1=50mF, C2 =…

Q: Determine alpha dc if I E = 2.8 mA, I C = 2.75 mA and ICBO = 0.1 mA

Q: Exercise 2: In the circuit below, determine vx and ix 60 V 5 A 8 Ω M 4Ω 10 Ω www 202 Vx

Q: . In the transformer shown in the below figure, the inductance measured across the terminal 1 and 2…

A: In the given Transformer : When terminals 3 and 4 are open then inductance across terminals 1 and 2…

Q: An analog signal is sampled at the Nyquist rate of 8MHz and quantized into 180 levels. Find the…

A: Given that: Nyquist rate, fS=8 MHz Quantized level, L=180 Find time duration T ( in second) of 1…

Q: Draw the circuitry that would implement the given. Using all possible combinations. Make a table to…

A: It is given that: X=A+DB+C

Q: The numbers are placed in the memory locations 2501 to 2504H. The sum is to be stored in the memory…

A: Solution !!

Q: lossless transmission line operating at 50 MHz has a surge impedance (40 + j0) ohms and a…

A: We need to find out value of inductance for given transmission line .

Q: Draw the logic diagram and logic equation of the followings: NAND IMPLEMENTATION: A. NOT B. AND…

A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly…

Q: Using Millman's Theorem calculate the current I shown given figure. 10 V 2592 3Ω 592 20

Q: A parallel circuit consisting of a non-inductive resistor, an impedance coil, and a capacitor of…

A: Given data, IT=6 A IC=3 A IR=4 A P.F.=0.936

Q: Sine-wave generator + 1.0 kHz 1.0 V TISS Voltage across R1, VR Total current, I www 1.0 k Voltage…

Q: 4. Use the labeled in the figure. current-division principle to find the currents i₁ = 3 A R₁ = 10…

A: The given circuit is,

Q: Find I and V. |16V 8Ω =V+ 12Ω Μ I 1) 3A

A: Apply KCL at node connecting 8, 12 ohms resistors and current source. Now apply kvl in left loop to…

Q: A 110V d.c. generator supplies a lighting load of forty 100W bulbs, a heating load of 10 kW and…

A: Generally loads are connected in parallel to maintain constant voltage across it. Based on load…

Q: 4. In ac circuit takes a load of 160 kVA at a lagging power factor of 0.75 when connected to a 460-V…

Q: A 8-pole dC generator running at 1,200 rpm, and with a flux of 25 m Wb per pole generates 440 V.…

A: Number of poles p = 8 RPM N = 1200 Flux ϕ = 25 m Wb = 0.025 mWb Voltage E = 440 V

Q: 5² +35+k 25³ +45² +55 Find the value of k that makes the final value of the system output 38 The…

A: Given, Ys=s2+3s+k2s3+4s2+5s final value=38 k = ?

Q: A parallel R-C circuit containing 25 of resistance, and a capacitor of 95.5 μF, connected to a…

A: We need to find out the current for parallel RC circuit .

Q: Generate plots for each of the following functions over time span -4s to +4s x1(t)= 5r(t+2)-5r(t)

A: Given: x1(t)= 5r(t+2) - 5r(t) To do: Generate plot for the above mentioned function over time span…

Q: Q4: A: A string of 3 insulators and the ratio of Ce/C = 0.15, if the string is connected to 3-4 line…

Q: Find and sketch c(t) = x₁(t) * x₂(t) for the pairs of functions illustrated below. A x₁(1) 461- (a)…

Concept explainers

Antenna Array

An antenna array is a group of antennas joined together and arranged in a regular pattern to form a single antenna capable of producing radiation patterns that individual antennas cannot. As the antennas are constructed as an array, sufficient spacing and phase must be given.

Question

Q.2
Two long parallel current carrying wires
are separated by 5 cm in air and are
carrying current of 20A in the opposite
direction. The force per meter length
between the two wires will be (in N/m)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Calculate to find the force between the two parallel conductors if they are 0.5 m in length and are separated by 1 cm in air and I1 = I2 = 20 A.
As in the figure, two electrons are moving on the same plane with velocities of v=3x10^6 m/s and v'=1x10^6 m/s in the direction perpendicular to each other at a certain moment. The distance between them is 0.8x10-10 m.What is the magnetic force exerted by the above load on the load below, in pN (pico Newton)?
السؤال Magnetic field Produced by the presence of electrically charged particles, and gives rise to the electric force. الاجابات True False
A long, solid, cylindrical wire of radius A has a current density given by j = j0r/A. Determine the magnetic field, within the wire, in terms of the total current "I" flowing through the wire.
السؤال Electric flux that streams away symmetrically from a point charge and is coincident with the streamlines and to visualize this flux wherever an electric field is present. الاجابات True False
A current of I=2 Amperes flows in the +z direction from the thin conductor wire extending along the z axis shown in the figure. Which of the following options is the magnetic flux passing through the area surrounded by the frame from the wire placed to the right of this wire and the common inductance values between these two wires?
A 16cm × 12cm rectangular conductive loop is placed in the xy plane. from aboveWhen viewed from the outside, a direct current of 10 A flows clockwise. flux density at the center of the loopfind it.
Two long parallel conductors of a dc transmission line separated by 2 m have charges of 5 µC/m of opposite sign. Both lines are 8 m above the ground. What is the magnitude of electric field 4 m directly below one of the wires?
A ferromagnetic material has a remanence of 1.5 T and a coercivity of 50,000 A/m.Saturation is achieved at a magnetic field intensity of 200,000 A/m, at which the fluxdensity is 2.5 T. Using these data, sketch the entire hysteresis curve in the rangeH= −200,000 to +200,000 A/m
1. An emf of 16V is induced in a coil of inductance 4H. The rate of change of current must be ___. 2. If a permanent magnet has a uniform flux of 14,000 lines between the pole faces, what must its area be to have a flux density of 7,000 gauss, in square inch?
A current flows through a long straight conductor. If the magnetic field strength at a distance of 5 cm from the conductor is 8 mT, calculate the current flowing through the conductor.
The potential function in only charged space; V (x, y, z) = - 6 V in the region x <-8 V (x, y, z) in the region of -8 <x <9 = - 3/17 x + (-6) V (x, y, z) in the region of 9<x =-9V has been observed to change. The potential function does not change with y and z. Calculate and write the sum of the x values of the planes with possible loads in this space.