Two rods and one cable are attached to the supports at O. If two of the forces are as shown, determine the magnitude F and direction of the third force so that the resultant of the three forces is vertically downward with a magnitude of 1360 lb. 840 lb Answers: 9= i i 42° T O 0 0 35° F lb O 550 lb

Q: Question 2: The clamp is used to create vertical clamping force onto wooden work pieces. If the…

A: Compressive load in member BE:Hence the force at joint B and E For the calculation of the forces at…

Q: Q.1- Choose the correct answer of the following: 1. If the metals are ductile and the cutting speed…

A: Note: “Since you have posted a question with multiple sub parts, we will provide the solution only…

Q: Part A Determine the mass moment of inertia of the thin plate about an axis perpendicular to the…

A: Given Data:.To determine :Mass moment of inertia of the thin plate about an axis perpendicular to…

Q: In a single-stage gear wheel system with an evolvent profile, the rotating (drive The number of…

A: please refer handwritten solution

Q: A skier is pulled by a rope exerting a horizontal force T=[T] KN at a distance h= [h] cm above the…

A: Given:To find:Critical load T

Q: A coplanar force system is shown (1)Find the sum of the three forces (2) Reduce the force system to…

A: Write the given data from the diagram.

Q: The machine shown is used for moving heavy items such as pallets of bricks around construction…

A: The weight of the boom is;The weight of the bricks is;

Q: Member AB is supported by a cable BC and at A by a square rod which fits loosely through the square…

A:

Q: Determine the horizontal and vertical components of reactions at the pin at A and the reaction of…

A:

Q: The local atmospheric pressure of Karabuk is 98.39 kPa. Air at this pressure and at 25°C flows with…

A: To determine the friction coefficient for the flow of air over a flat plate, we can use the concept…

Q: In a single-stage gear wheel system with an evolvent profile, the rotating (drive The number of…

A: to prevent undercutting, we need to increase the pressure angle or the helix angle.

Q: What is the transfer function of the mechanical system?

A: Given:To find:Transfer function

Q: A 0.4 kg rubber ball has a horizontal velocity of 1.554 m/s at point A and goes through a projectile…

A: According to the given dataWe need to findThe velocity of the ball when hits the ground

Q: An inverted CONICAL tank (D = 0.5 m, H = 1 m) is full of water. Find the pressure at the bottom of…

A: D = 0.5 mH = 1 mDownward acceleration, a = 2 m/s2Required:P ( pressure at the bottom of the tank )

Q: The supporting structure of a movable crate has dimensions as shown in the figure below. The radius…

A: The radius of fiber, r = 15 inThe radius of outer fiber, R = 20 inThe load acting at end, P = 2000…

Q: = 750 psi, determine the maximum load Pmax that If the allowable bearing stress for the material…

A: FBD

Q: The solid circular rod has a cross-sectional area of 400 mm². It is subjected to a uniform axial…

A:

Q: The beam is supported by a pin at C and by a short link AB. Each pin has a diameter of 18 mm. Assume…

A:

Q: The pendulum consists of a 5-lb slender rod AB and a 10-lb wooden block. A projectile weighing 0.28…

A: The angular velocity of the pendulum.Given:The mass of the projectile is .The mass of the block is…

Q: Question (1): The link AB has an angular velocity of 2 rad/s. Determine the velocity of block C at…

A:

Q: The conditions at the beginning of the compression process of an air standard Diesel cycle are 150…

A:

Q: Find the eigenfrequency and normal Coordinates for the model below. 47 1 b سید 3₁ 19₂2 олишини と 30

A: Given:To find:Frequency

Q: determine the magnitude of the yo-yo's angular velocity

A: Given DataMass of the yo-yo =200 g =0.2 KgThe force  The outer radius of the yo-yo The inner radius…

Q: A pulley is supported by a circular pin at A. The pin has a diameter of d = 0.500 in., and each side…

A:

Q: Water is flowing in the pipe shown in the figure below, with the 8.20-cm diameter at point 1…

A:

Q: 3-5. Calculate the moment about point A in Figure P3-5. 800 lb A 4 5' 3 FIGURE P3-5 200 lb 4 | 7' 3'…

A: Moment about a point is the product of force and the perpendicular distance between the line of…

Q: In a solid sphere, a heat flow is produced by a source that generates energy at a rate of S W/m3 .…

A:

Q: The enthalpy of the air entering the cooling tower is 57 KJ/Kg dry air. The water enters the cooling…

A:

Q: 3. The given triangular AB gate is hinged at A. Determine the weight of the gate that is required to…

A:

Q: power (N)=9.9kw Input speed (n1)=2350rpm Distance between centers (a)=168mm Total distance…

A:

Q: Part 3 1. Setup the meter stick as shown below: M₁ 3 30cm 400g 75cm 200g M₂ 2. Attach the string…

A: In this, the free-body diagram includes-(1) Setting up the meter stick.(2) Attaching the string…

Q: 50 cm. I 2000 (고) 30 CM usok Calculate the coordinates of the center of gravity of the homogeneous…

A: According to the given dataThere are two segment We need to findThe centroid of the cross-section

Q: Q3:Air flows over the flat plate at velocity 0.3 m/s and ambint temperature 15 C.The plate is…

A:

Q: 4. For the plenary gear, OB is spinning at 5 rad/s and A is fixed. Determine (A) the angular…

A:

Q: A constant volume container holds 10 kg of air at a temperature of 20°C and a pressure of 150 kPa.…

A:

Q: 1. A tank is filled with air at a gauge pressure of 6 bar and 55 °C, determine the specific weight…

A: Specific weight is the product of density and the acceleration due to gravity.

Q: Air enters a refrigeration coil at 32°C db and 24°C wb at a rate of 40 m3/min. The apparatus dew…

A:

Q: A rocket runs out of fuel in the position shown and continues in unpowered flight above the…

A: According to the given dataWe need to findMaximum height h gained by the rocket and time to reach a…

Q: if the surface and the adjoinig air temperatures of a surface are same as 20 degree C and the…

A: T = 20 Ch=20 W/m²KRH= 40%

Q: Draw SFD BMD V(x) M(x)

A: To draw:The shear force and Bending moment diagram.

Q: Question 3 of 12 View Policies D Answer: Pmax= Current Attempt in Progress A pin-connected truss is…

A:

Q: Water flows into the tank (Figure 1) at V = 8.5 m/s. Figure 1.5 m 1.5 m 40 mm AT 40 mm BI S 80 mm 1…

A: The given data is shown below.It is required to determine the velocity of the water at point A and…

Q: A ship has a radius of gyration of k=8m, a transverse metacentric height GM of 2m and a displacement…

A: The radius of gyration, kxx = 8 mThe metacentric height, GM = 2 mThe displacement force, F = 156960…

Q: A 28-kg girl is bouncing on a trampoline. During a certain interval after leaving the surface of the…

A:

Q: Consider the mechanism of Bar AB, Bar BC, and roller A. Roller A is constrained to move along the…

A: Consider the mechanism of Bar AB, Bar BC, and roller A. Roller A is constrained to move along the…

Q: Hot water at 160 ⁰C is passing through a pipe, and it is lagged with a plastic covering. The…

A: Hot water,  Ti  = 160 ⁰Ck= 0.2 Wm-1K-1h = 16 Wm-2K-1T ∞ = 25 ⁰C

Q: Find the moments M₂, M, and the mass m, of the triangular lamina defined by the vertices (0,0),…

A:

Q: 3. As in the figure, a ship can move both with the wind and with a diesel engine. your ship The mast…

A:

Q: A pulley is supported by a circular pin at A. The pin has a diameter of d = 0.250 in., and each side…

A:

Q: For the following Identify the true and false sentences: The sum of all forces acting on the ground…

A: (a) The sum of all forces acting on the ground plane is called the shaking force (Fs).False"…