uentre el grafo de flujo de señal a partir del diagrama de bloques siguiente R -G₁ $3$3 H3 - H₂ G3 H₂

Q: A balanced delta-connected load with impedance per phase of 30230° 2 is connected to an abc-sequence…

A: It is given that: Z∆=30∠30° ΩeAC=-1202cos120πt-π6 V

Q: 3.52 Use mesh anals to find i1, 12, and is in the circuit of Fig. 3.9 ML 12 292 8 Ω 3 A 12 V (+1)…

A: In this question,  We need to calculate the current i1  , i2  and i3  as shown the circuit using the…

Q: .: DC distributor fed from two ends with VA = 210 V and V₁ = 200V. The total resistance of the…

A:

Q: A DC generator G1 currently supplies power to a certain load (Fig. 1). However, it is scheduled for…

A: Here the concepts related tot the parallel operation of the DC generators is discussed.

Q: Derive the formula for the energy stored in a capacitor.

A: Note : According to guidelines of the company if the questions are of different then we supposed…

Q: When designing and manufacturing chips with billions of transistors on one die, what challenges can…

A: Given and to find: When designing and manufacturing chips with billions of transistors on one die,…

Q: A transistor has a Bpc of 250 and a base current, IB, of 20 u A. The collector current, 50 mA O 5 mA…

A: In this question we will find collector current of transistor with given data...

Q: The no load current drawn by a single phase transformer is found to be i 0 = 2 cos ωt A when…

A: Given data: i0=2 cos ωtV= 440 cos ωt

Q: 1. A 208Y/120-volt feeder in a commercial building supplies lighting and receptacle loads as well as…

A: Here in this Q. the calculations of load of the motor in VA is to be done.

Q: onous reactar transformers are operating in parallel, they will share the load as ous motor is…

A: In this question we will write about synchronous machine related answers.....

Q: Q3/A/ A3-phase, 5.5kW, 440V, 501 Iz, cylindrical rotor S.M has synchronous reactance of (0+j2)…

A: Given data : Output power  Pout=5.5 kW=5500W Synchronous reactance,Xs=j2Ω/ph Full-load…

Q: Use Thevenin to determine the current and voltage at the 10 ohm resistor.

A: The thevenin's equivalent circuit can be calculated by removing the load resistor and find the vth…

Q: A capacitor with a capacitance of 3.6360426666667E-10 pF is a parallel-plate capacitor. Each plate…

A:

Q: The microwaves in a certain microwave oven have a wavelength of 12.2 cm. Part A How wide must this…

A: Given : a Wavelength : 12.2 cmLength of oven : L = 6×λ2L = 6×12.22L = 36.6 cm

Q: 4. Determine the impedance of the circuit of Figure 4.4 at frequencies of 1 kHz, 20 kHz and 1 MHz.…

A:

Q: Using the current sivider rule fin She current through each impedance R x2 = 44 XC 622 3x²32

A:

Q: For the circuit given, obtain vo 10 V 4Ω να 12 V www 6Ω www 2Ω Α) -48 V Β) 10 V C) 12 V D) 48 V

A:

Q: A4 The circuit showed in Figure A4, is powered by an AC voltage source Vs. Sketch the phasor…

A: Here we discuss about the single phase AC RL parallel circuit.

Q: numbers. Show the comparators with proper connections. 4. Design equation F(A,B,C,D)…

A: For the given Boolean equation we draw truth table and then draw a logic circuit using MUX

Q: H.W 4: For the following pairs of voltages and currents, determine whether the element involved is a…

A: We are authorized to answer only 3 subparts at a time since you have not mentioned which part you…

Q: Find output voltage Vo Si OFF 2V ON 4V + Si 0.7V 3.3V 2V-0-7v=1-3V V₁ = 4v-0-7V=3.3V 4-07V=3.3V |…

A: given here diode circuit problem and asked to find the output  V0.

Q: Q.2 Consider system described by A B N-G 30+A- Hu 3 C y = [10] [x₂] G(s) Obtain the transfer…

A: Brief description: For the above given state space analysis we need to calculate transfer function…

Q: 3.7 In the circuit of Fig. 3.49, current i, is: (a) 4 A (b) 3 A (c) 2 A ΖΩ www 20 V ἐ Μ 3 Ω + v (1)…

A: In this question we will find current i1 ....

Q: Power spectral density of the signal given below is s (f) 2 -2 6 -6 ∞ 0 -1 1 1 2 f

A:

Q: An enhancement type N-MOSFET with VT = 2 V that conducts a current ID = 5 mA for VGS = 4 V and VDS =…

A:

Q: 1) Design an active band-reject filter that has gain 13 and the stop frequency between 129 and 1950…

A: Given  Few specifications of a band reject filter.we need to design it. Please find the below…

Q: The manufacturer of a selected diode gives the rate of fall of the diode current di/dt = 20A/µs, and…

A: Given data, Diode specifications didt=20 A/μstrr=5 μs

Q: given a line charge distribution of (10 C/m) on z axis, find VAB where A(3, 1/2,1) and B(4, z, 6).

A:

Q: R₁ www R₂ www R₂ o a b

A:

Q: Refer to the figure; if VCE = 0.2 V, Ic(sat) is: 10 V = 4.7 kn Ra www VINS 1.2 MO O 2.085 mA O 0.05…

A: For given circuit We need to find out saturation current .

Q: Q3/A) A 1000-VA 230/115-V transformer has been tested to determine its equivalent circunt. The…

A: aOPEN CIRCUIT TEST referred to the low-voltage or secondary side:YEX=Gc-jBM=0.45 A230 V=0.0019565…

Q: How many hours does the 2batteries will work in 6w LED IF EACH OF THE BATTERY IS EQUAL TO 3.7V AND…

A:

Q: Q.1 For the following block diagram find C(s) D(s) R(1) E(s) G₁(s) Gy(s) C(s)

A:

Q: 2) Goy(+ Find i, and i₂ 10 7 6 4 8 U2 Soy 7

A:

Q: 1.The secondary line to line voltage of a star-delta connected transformer is measured to be400 V.…

A: Given line to line voltage at secondary is 400 V The turn ratio is 2:1

Q: 1, Please draw circuit diagram and explain how basic two way switch control one light.

A: NOTE- As per our policy, we can answer only one question, please post other question as separate…

Q: Two point charges of 318 statcoulomb and 414 statcoulomb are 6.8 cm apart. A point between the…

A:

Q: For the circuit given, obtain vo 10 V 4 Ω % www 12 V 6Ω 202 A) -48 V B) 10 V C) 12 V D) 48 V

A: KVL:- The algebraic sum of voltages in a closed loop equal to zero. KCL: The algebraic sum of the…

Q: Determin the input impedance to the Series network Draw the imperance ww um R=6 X²116 Xc=12 R=5 X2=3…

A: zeq of series circuit calculated as

Q: . A clothes 800 W iron is designed to be used with a 220 V outlet. How much current will flow in the…

A:

Q: According a- l v to the figure, average voltage b- 2 v c- 3v b-4v 304 V P Si R2: 1k

A:

Q: The B-flux is determined to be 52.35 mWb. If the material that surrounds this flux has a…

A:

Q: A) Let x[n]=d[n]+[n-1]. Find the D.F.T of the signal g[n]=x[2n] B) Determine the I.D.F.T of the…

A: As per the guidelines of bartleyby I need to answer first question only so kindly repost other…

Q: 2. Determine the current flowing in R1, R2, Rg, R4, Rg and Vs. (if Voltage drop across R,=20 V).…

A:

Q: The input to a 220 V DC shunt motor is 11 KW. Calculate, (I) the torque developed.  (II) The…

A: The current in the shunt winding is,  Ish=220110Ish=2 A The no-load current of the motor is known,…

Q: Deterr me the Norton equivalent at terminals a-b for thercuit in Fig. 4.115. 492 wwo a 4 A o b 10%…

A: To find Norton equivalent, short circuit current IN and equivalent resistance RN is required . With…

Q: 1. A sinusoidal signal has a frequency of 4KHz the best sampling frequency is: a- Equal to 8 KHz. b.…

A:

Q: If four equal R1, R2, R3 and R4 resistors are connected in parallel and the total current flowing…

A: Given, Four equal resistors are connected in parallel. Total current, IT=10 mA

Q: 1. Find Ix in the circuit of figure shown below using Kirchhoff's law and Maxwell Analysis.

A: The required parameters can be calculated by using the kirchhoff's voltage law and ohms law.

Q: 1. The equivalent impedance per phase of a star-connected load are as follows: Za= 100 Ohms, Zb=j5…

A: In this question,  We need to determine the total power factor of the load, power P? And line…