Use (a) Fixed Point Iteration method (b) Newton-Rhapson method and (c) Secant Method to find the solution to the following within error of 10-6. Show your manual solution for first three iterations, then prepare an Excel file for the finding the root until the error is within 10-6 showing also the graph of the function. 1. x3-2x2-5=0, when x = [1, 4]

Use (a) Fixed Point Iteration method (b) Newton-Rhapson method and (c) Secant Method to find the solution to the following within error of 10-6. Show your manual solution for first three iterations, then prepare an Excel file for the finding the root until the error is within 10-6 showing also the graph of the function. 1. x3-2x2-5=0, when x = [1, 4]

Mathematics For Machine Technology

8th Edition

ISBN:9781337798310

Author:Peterson, John.

Publisher:Peterson, John.

Chapter87: An Introduction To G- And M-codes For Cnc Programming

Section: Chapter Questions

Problem 27A: Write a CNC G-code program to machine the part in the following figure, so that the tip of the tool...

See similar textbooks

Similar questions

Find the unknown value. 27. y varies jointly with x and the cube root of 2. If when x=2 and z=27,y=12, find y if x=5 and z=8.
The number N of beavers in a given area after x years can be approximated by N=5.5100.23x,0x10. Use the model to approximate how many years it will take for the beaver population to reach 78.
Repeat the previous exercise to find the formula forthe APY of an account that compounds daily. Usethe results from this and the previous exercise todevelop a function I(n)for the APY of any accountthat compounds n times per year.
Write a CNC G-code program to machine the part in the following figure, so that the tip of the tool follows this path: rapid movement to a point above P8, with z=4 . using absolute dimensioning change to tool "4, with a clockwise spindle speed of 2500 rpm, with coolant on and a feed rate of 14 in./min using incremental dimensioning -rapid movement to 4 in. above P1 -rapid movement to lower the tool to be 0.1 in. above the top surface of the part -move the tool to be 0.5 in. below the top at a 14 in./min feed rate -follow the path around the perimeter to points P2 through PI, ending at P1, using the 14in„/min feed rate turn off the spindle and coolant use absolute dimensioning to return to the start point end the program