Using Carson's rule. What is the bandwidth (kHz) of an FM signal with 5 kHz maximum frequency deviation and 2.5 kHz maximum modulating frequency?

Q: With the basic circuit diagram, explain the restricted earth fault relay for a transformer.

A: Procedure Three line CTs are connected in each phase of the transformer One terminal of CT is…

Q: I.822 loo . 305 330 find the voltage and current at each resistance and found Rtotal

A:

Q: 2.4.1 DC Bias operation Vcc Load Ic Rc RB IB Power transistor V; Fig. 2.5 Class A series fed…

A:

Q: DETERMINE THE RESISTANCE OF 600 FT LENGTH OF #10 AWG COPPER WIRE

A: Given, Length of copper wire, l=600 ft=600×304.8 mm=182880 mm For 10 AWG, diameter d=2.59 mm

Q: In a nonmagnetic medium E = 4 sin (27 × 10'r – 0.8x) a. V/m Find (a) ɛ, n (b) The time-average power…

A:

Q: If an ideal filter is defined by an impulse response given as h(t) = 8 sinc (8t-40) Plot its…

A: Given, h(t) = 8 sinc (8t-40)

Q: For the self-bias FET circuit in Figure 2: a) Draw the circuit's AC circuit equivalent; b) VasQ c)…

A:

Q: b.) Determine Zi , Zo , and Av for the amplifier shown below if k = 0.3 x 10^(-3). 20V 2.2 k2 10 MQ…

A:

Q: b.) Determine Zi , Zo , and Av for the amplifier shown below if k = 0.3 x 10^(-3). 20V 2.2 k2 10 MQ…

A: VGSQ=6.7 V And gm=2kVGSQ-VTh Putting values, gm=2×6.7-3gm=2.22 mS

Q: Which of the following is not an advantages of the SCR *

A: Advantages of SCR: 1)  It gives noiseless operation at high effeciency. 2) It has no moving parts.…

Q: A No. 10 AWG copper conductor

A:

Q: Design a two-bit synchronous counter that counts the sequence 0.1,2 using T * flip flop

A:

Q: 10 Ω Si 12 V

A: Current: It is the time rate of the change of the charges and its unit is ampere.

Q: Given the finite-duration sequence below, x[n]={-4,1,2,0,3} where -4 is when n=0, if it has a…

A:

Q: Fill in the blank : For the circuit shown below, solve for gm

A: The required parameters can be obtained by using DC analysis of FET amplifier.

Q: x (+ ) = 2) 8(t-K) , where k Let i's an integer Then the Part とC4) x(+) is even

A:

Q: Work and answer

A: Given circuit, VRX=12 V

Q: or the following input transducers, write/ sketch: Description Basic construction/ structure…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: For a silicon diode, calculate the current at room temperature if the forward voltage VF = 0.3 V and…

A: In this question,  For a silicon diode, Calculate the current at room temperature if the forward…

Q: 1/1 The fixed bias provides good Q- Point stability. It is the most using .bias circuit False True

A: The fixed bias provides good Q-point stability.  It is the most using bias circuit.  True  False…

Q: , let v = 4cos (5t - 30°) Volt and i = 0.8 cos(5t) Amp. Find v, and 20 mF 2 H le 10 2 20 2 ww

A:

Q: +) Determine the maximum bitvate for an fst Signal with a mark frequency of 102 KHZ,aspace frequency…

A: In this question we have to find out maximum bit rate for an FSK signal with given data...

Q: Give examples circuits under combinational circuit.

A: Combinational circuit : A combinational circuit performs the operation in form of boolean expression…

Q: 2. Assuming an ideal diode, sketch vi, Vd, and ia for the half-wave rectifier of Fig. 168. The input…

A: The diode will conduct only during the forward bias and it will not conduct during reverse bias.

Q: Q-factor and bandwidth

A: Resistance in parallel- 1/Req=1/R1+1/R2+1/R3+...........   Resistance in series-…

Q: Design a generator that, when rotated in a uniform magnetic field of strength 0.10 T, will produce…

A: Given data, Magnetic field strength B = 0.10 T EMF induced v=v0sinωt, v0=311 V Angular frequency…

Q: 1. Draw AM modulator Block Diagram 2. Draw all the signals 3. Write the equation for Modulating…

A:

Q: What is an approach thats being investigated to mitigate the absorption losses in photovoltaics

A: Introduction -  Photovoltaics is the transformation of photons to energy utilising photovoltaic…

Q: 16.4 Derive the expressions for a, ak, and bg for the pe- riodic voltage shown in Fig. P16.4 if Vm =…

A:

Q: A circuit below is designed by an engineer. The input is given as the current source. The output is…

A:

Q: For a signal x(n)= {5,25,125,625,3125,15625,78128,390625} . Evaluate the Fast Fourier Transform…

A: Given: Consider a signal x(n): xn=5,25,125,625,3125,15625,78128,390625 To find: Evaluate the Fast…

Q: 1 пС A uniform sheet of charge p. lies at x= 0 and a second sheet 2 m 1 of charge Ps nC 2 m lies at…

A: Given,at x=0,The uniform sheet of  charage is,ρs=16πnC/m2at x=10,The uniform sheet of  charage…

Q: 16.1 For each of the periodic functions in Fig. P16.1, specify a) w, in radians per second; b) fo in…

A:

Q: op-amp has a differential voltage gain of 2000 and a CMRR of 20000. A single-ended input signal of…

A: In this question we will find output voltage for operational amplifier...

Q: A Y-Y three-phase circuit is shown below. Solve for the following: Line current of phase b = Blank…

A:

Q: 12 V 2kS2 10 kN

A:

Q: The readings of the two instrument connected to a balanced three-phase load are 128 W and 56 W. When…

A: In this question, We need to determine the The power in the circuit before the resistors were added?…

Q: The SCR is turned off when the * Anode current is below holding current

A:

Q: Determine the maximum b it vate for an fsk SignaL with a mark frequency of 48KHZ. aspace frequency…

A:

Q: What is the resistance of 600 ft length of #10 AWG copper wire

A:

Q: A 3-phase synchronous generator has excitation voltage Eo=2.44KV, synchronous resistance Rs = 1792,…

A: Synchronous Generator: A synchronous generator is a synchronous machine that uses electromagnetic…

Q: Design the fixed-bias network of Figure B to have a gain of 4. I Ioss- 12 mA =D12 mA Vp=-3 V Sor 30…

A:

Q: 10.9 Find V, in the circuit in Fig. PI0.9. 20 10,6 v an an 1n v, 10 Figure P10.9

A: The given circuit diagram is shown below:

Q: [01] Consider a baseband signal whose voltage varies over the range -16V to 4V. This signal is…

A:

Q: How to determine the current and the impedance as a function of the frequency?

A: As the circuit is not mentioned, so assume a series RLC circuit. Supply frequency is f. Inductive…

Q: -value of m

A:

Q: 6.8.2 A capacitor with 1.5 mF capacitance has the terminal voltage t0 thatV = If the vo = 50 and the…

A:

Q: 4. Three resistors, of 40 N, 60 N, and 120 N are connected in parallel and this parallel group is…

A: Solution- If 40, 60 and 120 ohm resistors are connected in parallel, 1Req=1R1+1R2+1R3 =140+160+1120…

Q: 14-26 A certain plane wave in sea water has an rms value for the electric field intensity vector of…

A: The solution is given below

Q: 9. (-12, 36°, 9) 10. (22, 25°, 8)

A:

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.