A 3-phase synchronous generator has excitation voltage Eo=2.44KV, synchronous resistance Rs = 1792, and synchronous reactance Xs = 1442, Load per phase is 175N resistance. Calculate: (i) Line current, (ii) Line-to-Neutral voltage across the load, (iii) The power of the turbine driving the alternator (assume all the power of turbine is converted into the active power generated by the generator), (iv) Draw phasor between Eo and voltage across load.

A 3-phase synchronous generator has excitation voltage Eo=2.44KV, synchronous resistance Rs = 1792, and synchronous reactance Xs = 1442, Load per phase is 175N resistance. Calculate: (i) Line current, (ii) Line-to-Neutral voltage across the load, (iii) The power of the turbine driving the alternator (assume all the power of turbine is converted into the active power generated by the generator), (iv) Draw phasor between Eo and voltage across load.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter11: Transient Stability

Section: Chapter Questions

Problem 11.8P

See similar textbooks

Similar questions

A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
Induction motors and welding transformers require magnetizing current, which causes a. lagging power factor. b. leading power factor. c. unity power factor. d. zero power factor.
The total instantaneous power absorbed by a three-phase motor (under balanced steady-state conditions) as well as a balanced three-phase impedance load is (a) A constant (b) A function of time
A 10-kVA, 230-V, three-phase, delta-connected, the synchronous generator has a winding resistance of 0.2 ohms/phase and a synchronous reactance of 0.5 ohms/phase. Determine its voltage regulation when the power factor of the load is (a) 86.6% lagging, (b) 86.6% leading, and (c) unity.
Two identical three-phase Alternators A and B share equally a load of 10 MVA at 33 KV and 80% lagging power factor. The synchronous reactance of each generator is 4 ohms per phase and the armature resistance is negligible. Alternator A has its field excitation adjusted to carry a25 amperes at lagging power factor. What is the current delivered by Alternator B ?
A 5 MVA phase, 14.1-KV, 0.85-PF-lagging, 50Hz, 4-pole, Y-connected steam-turbine generator has a synchronous reactance of 10 per phase, and a negligible armature resistance. This generator is connected to operate in parallel with large power system infinite bus) The generator is operating with EA=8.0 KV and S = 21.8 degrees If the field current is reduced by 20 % while the power is not changed, Find the new torque angle and the magnitude of the armature current.
3-phase, 9 kVa power, 60hz, 208 Volt 8-pole synchronous generator, winding resistance is negligible, synchronous reactance is 8 ohms per phase. The generator was first connected in parallel with a 3-phase 60hz, 208volt generator. According to this; a) Calculate the induced voltage per phase for cos (Q) = 0.8 (inductive), determine the power angle, draw the phasor diagram. b) Find the stator winding current per phase, the power coefficient (cos (Q)) and the reactive power provided by the generator if the excitation current increases by 25% without changing the drive power.
A three-phase, 13.8 kV, 10 MVA, 0.8 PF-lagging, 60 Hz two-pole, Y-connected steam-turbinegenerator has a synchronous reactance of 12 Ω per phase and an armature resistance of 1.5 Ω perphase. This generator is operating in parallel with a large power system (infinite bus). (a) If the field current is constant, what is the maximum active power possible out of this generator (taking into account Ra)? How much reserve power does this generator have at full load ? (b) At the absolute maximum active power possible, how much reactive power will this generator be supplying or consuming? Sketch the corresponding phasor diagram assuming If is stillunchanged
In a Three-phase alternator, a given field current produces an armature current of 250 A on short-circuit and a generated e.m.f. of 1500 V on open-circuit. Calculate the terminal p.d. when a load of 250 A at 6.6 kV and 0.8 p.f. lagging is switched off. Calculate also the regulation of the alternator at the given load. Subject: Electrical engineering
ABB company manufactures three phase, 10 kVA, 240 V, 60Hz, 6 pole wye connected synchronousgenerator. The generator is connected to an infinite bus at rated voltage. The generator has synchronousreactance of 2.0 ohms/phase and negligible stator resistance and is delivering the rated power at 0.9power factor lagging. Determine the following:a. Stator current b. Excitation voltage (per phase and line to line) c. What is the pullout torque (maximum torque) delivered by the generator?
A 1500 KVA, star connected 2300v, 3 phase salient pole synchronous generator has reactance ph/95.1xd and phase/40.1xq All losses may be neglected. Find the excitation voltage for operation at rated KVA and power factor of 0.85 lagging.
The impedance of the stator winding of a 440 V, star-connected, three-phase inductio nmotor is (0,2 + j0,8) Ω per phase and that of the rotor is (0,06 + j0,25) Ω per phase atstandstill. The turns ratio is 2. Using the approximate equivalent circuit, calculate therotor current and the power factor when the slip is reduced to 25% by injecting16,2 V/phase into the rotor circuit without any phase compensation.