Using compensation theorem Calculate the new values of currents in the network when resistor R3 is increased by 30percent.p

Q: Q#2: in the following circuit if Peak input voltage=20V and diode forward resistor is = 1092. Find •…

A:

Q: 7.4L0° A 2j(6+y) Ω 20 Ω Figure 3 a b -j32 Ω (68+x) Ω

A:

Q: 3.16 A three-phase, full-wave half-controlled rectifier bridge circuit is operating at a delay angle…

A:

Q: Basic Electrical Engineering A homeowner uses 100-watt incandescent lamps as a heater in an outside…

A: Given data, Resistor rating  is 100 Watt The given value of resistance is  R=150 Ω

Q: Figure Q3(b) shows the response of the underdamped second order system where t is time in second and…

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: P3. Using Routh criteria to determine the stability of a unity feedback system has the following…

A:

Q: Knowing the equation of collector current IC for the transistor amplifier circuit, pleas calculate…

A:

Q: For the open-loop pole-zero plot in the following figure (with unity feedback): R(s) with G(s)- K…

A: Given data, Open loop transfer function is given as, Gs=ks+1s+2s+3.

Q: Question 10 Determine VBC- Μ R₁ 22 ΚΩ R₂ 10 ΚΩ Vcc +30 V Rc 1.0 ΚΩ 2N3904 Bbc = 200 RE 1.0 ΚΩ

A: We need to find out the collector to base for given circuit .

Q: 2. A system of infinitely many resistors is as shown below: www kth row o 2k-1 resistors www Each…

A: Note:   Current in series circuit remain same but voltage change based on resistance. Voltage in…

Q: A 3-phase, star- connected alternator is rated at 15000KVA, 11LV. The armature resistance is 1.5…

A:

Q: The secondary side of a transformer of 5 primary turns and 9 secondary turns is connected to a…

A:

Q: Ge(s)G(s) = (s 5(s+3)² 0.5) (s− 1) (s+2) 1-120 Gain margin condition: 1) Always stable for K > 0 2)…

A: According to Nyquist stability criterion, Z=N+P, where, N = number of encirclement of critical…

Q: Determine the value of the impedance, Z₁, that causes maximum power transfer in the circuit shown in…

A:

Q: The quantity of charge q (in coulombs) that has passed through a surface of area 2 cm² varies with…

A: So we have charge equation is q = 2t3 +4t —6 So current through surface is i=dqdt=6t2+4 So at t = 2…

Q: using the above table, find z transforms for x[n]=7u(n)-2*3" u(n)+5n*3" u(n) Find z transforms for…

A:

Q: choose the right equation 20 V Select one: a. O b. O d. V-20 15 V-20 15 V-20 15 V-20 15 15Ω + + - V…

A:

Q: 1- Determine YT and ZT 2- Sketch the admittance diagram. 3- Find E and IL.

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: P17. The signal flow graph of the control system shown in fig. P17 what are the following: 1- The…

A: Given data The signal flow graph for the control system is given in the problem. We need to find out…

Q: Table Q3(c) shows the reading obtain by a first order system with unit step input where c(t) is the…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Full explain this question very fast solution sent me

A:

Q: 4. There are two consumers with the load curves as follows. 50 40 30 20 10 0 1 2 3 4 5 Time (hour) 6…

A:

Q: 3-φ induction motor

A:

Q: Two coils having inductance of 0.2H and 2.45H are coupled and their mutual inductance is 0.14H. The…

A: Given- Inductances of coils- L1=0.2 H,L2=2.45 H, Mutual inductance M=0.14 H, To Find- The…

Q: Question 2 For the network with CE unconnected, determine Rin in ko (using appropriate…

A:

Q: J к L Determine x1(n) using deconvolution on the output y(n) and x2(n). (hint: write down the…

A: We need to find out the input sequence for given output sequence and we need to find out the z…

Q: A synthetic jet is used for flow control in an airplane wing. The mechanism that creates the jet…

A: Given data Input voltage range= +/-5V  Desired Resolution= 2.5mV = 2.5*10^-3 V

Q: . The following control system is given (fig1): FF FW C DC P D Fig.1 Where r- is reference y-…

A:

Q: Problem 3. The following information is known about an LTI system (a) The system is causal (b) When…

A:

Q: 3.16 A three-phase, full-wave half-controlled rectifier bridge circuit is operating at a delay angle…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: P16. Consider unity feedback has an open loop transfer function below. Find: 1-The static error…

A:

Q: For the system shown, determine the fault level and short circint cuervent for a 3-phase fault at…

A:

Q: In the circuit in the figure, the mosfet parameters are VTN=4 V and Kn= μ₂ Cox (W/L) = 0,4 A/V². a)…

A: Given data VTN=4 V Kn=μnCoxW/L=0.42 A/V2 If  R1+R2=100 kΩ Vo=VDD2  We need to find the value of R1…

Q: 1 Which one of the following statement is "false" regarding the Intelligent power modules (IPMS)?…

A: Note: We are authorized to answer only one question at a time. Kindly repost the other question in…

Q: TOUR.XI MV 100 out= -1v² Q2-Consider the op amp circuit given below, where R1 = 19 k2 and vs = 1 v.…

A: We need to find out the output voltage for given circuit .

Q: Considering the system from the image. Design a compensator that achieves/meets the following…

A: Given: For a unit-negative feedback system, the forward path transfer function is Gs=Kss+1s+402. We…

Q: A 3-phase induction motor is wound for 4 poles and is supplied from 50-Hz system. Calculate the…

A:

Q: The maximum current in this circuit passes through R2 because it is the smallest of the currents.…

A:

Q: Ge(s)G(s) = 5 (s + 1) (s+2) ज -120 8 +60

A: We need to find out the P, N ,Z and we need to check whether the given system is stable or not…

Q: For the systems shown in Figure Q2(b). (i) (ii) (iii) (iv) Derive the transfer function for each…

A: The circuit is given as

Q: In an induction motor, rotor speed is always     Less than the stator speed.       More than the…

A: The rotor speed of three phase induction motor is based on the value of the slip and the input…

Q: 4. Assume Q₁ = Q₂ and Q3 Q4 = Q5. Neglect the base current. (a) What are the advantages of using…

A:

Q: 1 ОЗА ЗА 2 ш 3V ЗЛ ISV Det. Ian by Norton's

A:

Q: Problem 5 For the difference equation 0=2y[n+2]-3y[n+1]-2y[n]-4x[n+2]+2x[n+1] a. Put the difference…

A:

Q: Following measurements are made for a test specimen with a 6 kV rms supply at a frequency of 3 kHz,:…

A: Supply voltage , V=6Kv Frequency, f=3KHz Air capacitance, C=30nF Electrode capacitance, C=150nF loss…

Q: PART (1) Assume capacitor is fully charged when switch is at position 'a' for about 10 minutes. The…

A: Given- Part (I) The capacitor is fully charged when the switch is at position 'a' for about 10…

Q: Given Zo= 0.199290° pu, Z₁ = 0.175290° pu, Z₂ = 0.175290° pu, compute the fault current and voltages…

A:

Q: For the open-loop pole-zero plot in the following figure (with unity feedback): R(S) G(s) with G(s)-…

A: Given, Gs=ks+1s+2s+3.

Q: Question: For a cell terminal potential difference is 2.2V when circuit is open and reduces to 1.8 V…

A: We need to find out the internal resistance for given cell .

Q: Problem4. Resistors are given a power rating. For example, resistors are available with ratings of…

A: Note: Current in series circuit remain same but voltage change based on resistance. Voltage in…

DC Series Motors

A DC motor is a type of electric motor which converts electric energy into mechanical energy. The forces that are produced by the magnetic field are what those common types of motors rely upon. Either electro-mechanical or electronic, all types of DC motors have some internal mechanism to change the current direction in part of the DC motors. As the DC motors could be powered from existing DC lighting power distribution systems, these motors were the first form of motors widely used. By changing the strength of the current in its field winding or by using a variable supply voltage, the speed of the DC motors can be controlled over a wide range.