Using excess-15 notation, find the decimal equivalent of this binary number 0011101100000000.
Q: Given the following circuit, determine: (a)The secondary peak voltage.
A:
Q: Find Pa,s Ô Find the P,Q ,S for the ollowing g Pr, Qr , ST 71 2+3j 230V 3+1j gv +-j j 43/44
A: In this question, We need to determine the apparent power active power and reactive power. We know…
Q: Design a fixed bias-transistor circuit using Va Vec = 10 V for a Q-point of le 5 mA and Va_4 V.…
A:
Q: In a base 2 numeration system what will be the largest number you can get?
A: In a base 2 numeration system what will be the largest number you can get?
Q: Si is n-doped with No-1x1017 cm3 of Phosphorus. Assume T=300K and bandgap 1.12eV. Compute the…
A: We need to find electron and hole concentration of given semiconductor
Q: Refer to the given circuit. R2 = 5 0 R1 = 6 0 R3 = 4 N R4 = 4 2 R5 = 8 N DURACELL VT = 10 V
A:
Q: 17. Find the expression for the overall system transfer function of the system in Figure E.17. (a)…
A:
Q: Home Work 2 9 H ll 10 H ell 3 H 12 H 4Н 6 H a ll ll
A:
Q: 1. P, = %3D E = 300 V R, = 1000 R2 = 100 N
A:
Q: Grounding methods in Power systems
A: In the following section, the grounding methods in power systems have been discussed.
Q: RC circuit has a reactance of 820 ohm and 10 V AC voltage. What is the resistance necessary to…
A: In this question RC circuit is given with reactance and voltage...We have to find out resistance for…
Q: Calculate the following values of a 4-bit ADC with Vin = 0.6v and Vr = 1.2v. %3D • Determine the…
A: The successive approximation type converter will set the MSB as 1 and compare with input and the…
Q: Problem 2.) Given: Zo = 4KO Ein = 7KO Ao = 190 Find: (a) feedback impedance (b) feedback output…
A: In this type of circuit, a portion of the o/p voltage is applied to the i/p voltage in shunt through…
Q: Using the block diagram reduction technique, determine C/R for the block diagram shown below. and…
A: In this question we will find transfer function using block diagram reduction technique and verify…
Q: The current gain for a transistor working as common- base amplifier is 0.96. If the emitter current…
A: A bipolar junction transistor is a current-controlled device in which the base current controls the…
Q: 4 In (mA) 20아 19+ Actual commercially available unit 18- 17- 16- Eq. (1) 15- 14 13- 12- Defined…
A:
Q: What are sets of service-entrance conductors?
A: Since three questions are present and nothing is mentioned, as per the guidelines, in the following…
Q: Mastery Problem #3 (RL Circuits): Given the circuit below, solve for the inductor current, iL(t),…
A:
Q: 9. For the connected graph below 10 12 Us select tree T- {2,3, 4, 6, 7, 10 } and find matrices (a)…
A:
Q: f(t) = cos 2t + sin 2t + cosh 2t + sinh 2t 2s (s+2) А. (s2 +4)(s2-4) 2s2 (s-2) С. (s2+4)(s2-4)…
A:
Q: 2. Using Nodal Analysis solve V1 and V2 www 20 50 12 V 24 V Figure: 1.1 3. Using thevenin theorem,…
A: In this answer we will find the required parameters in both the questions using the basic laws of…
Q: Find R for maximum power transfer and the amount of maximum power that can be transferred to the…
A:
Q: [62.3A, 0.82, 44.7A] age of 120 V between the slip rings on s reactance of 10 per phase at…
A: The solution is given below
Q: 4. Using the Circuit below, determine the following 1. The Power taken by the 3 ohm resistor 2. The…
A: This question belongs to circuit theory . It is based on the concept of current division method and…
Q: The combined stop-rear lights circuit design is to conform to the following speci- fications: 1.…
A: LED: It is a semiconductor device and blows light when current flows in it.
Q: determine the repelling force between q1 and q2
A:
Q: A synchronous generator.connected to 1.0 per unit voltage infinite bus has 0.8 per unit reactance.…
A:
Q: For a control volume in transient operation, the Change of energy inside the control volume during…
A: Control volume : Control volume is a special type of space which is only used for doing any analysis…
Q: Use Kirchhoff's laws to solve the branch currents in the network
A: In this question, Use Kirchhoff's laws to solve the branch currents in the network? Here we are…
Q: 4- Design a digital comparator which compare two each with 2-bit using truth table method ?
A:
Q: What is the differences between real circuits and the simulated ones, please elaborate.
A: Simulation is define as the mathematical model or representation of a device which gives a very…
Q: 2. Explain over modulation.
A:
Q: A 200 ohms resistor is conected to a 1.5V battery a. how much current flows through resistor b.…
A: Given: 200 ohms resistor is connected to a battery whose voltage is 1.5 volts.
Q: 4. Using the Circuit below, determine the following: 1. The Power taken by the 3 ohm resistor 2. The…
A:
Q: Using the Circuit below, determine the following: 1. The Power taken by the 3 ohm resistor 2. The…
A: This problem comes under electrical network theory . It is a problem based on the concept of…
Q: draw the logical diagram.
A:
Q: Find AVERAGE true power for an RLC circuit with given parameters. Z= 3277 ohms, R = 1000 ohms…
A: The solution is given below
Q: (b) An input x(t) as in Figure Q1(a) is passed through an LTI system with impulse response given by…
A:
Q: A 3-phase, 1,200 kVA, 2,400 volts alternator is short circuited and open circuited and is operated…
A: Given 3-ϕ alternator1200kVA, 2400 VS.C. current=1200×1033×2400=288.67 AOpen circuit voltage for same…
Q: Practice Problem 4.13 42 ww-o RL 9 V 30s Figure 4.52 For Practice Prob. 4,13.
A:
Q: 4. Given the information provided in the network, determine: а. В b. VCC C. RB 20 HA
A: The following circuit diagram is given:
Q: lassify switching elements according to frequency and power rating. State the advantages and…
A: Switching elements according to frequency ratings are: a) Low switching frequency b) Medium…
Q: D D2 48 2 10 V- www D4 D3 (i)
A:
Q: Determine C/R for the block diagram given below using block diagram reduction technique, and verify…
A: Using block diagram techniques find the transfer function of the given block diagram. Now using…
Q: 22. Assuming an ideal diode, sketch vị, vď, and ią for the half-wave rectifier of Fig. 168. The…
A: Since you have posted multiple questions, we will solve the first question for you. If you require…
Q: Consider a family of logic gates that operate under the static discipline with the following voltage…
A:
Q: 3. Write each of the following numbers in the form of a + bi a) cos(3 – i) b) 2i sin h (4 – Tni)
A: a) Given cos(3-i)
Q: Draw a block diagram for a closed loop traffic signal system which control automobile traffic at…
A: Most Traffic light systems are time-based, Which means signals are allowed with a certain time to…
Q: 2. Calculate the curent flowing through the 5 ohms resistor in the circuit below using A. Thevenin's…
A:
Q: For each of the transfer functions given below, plot the expected temporal response of the system to…
A: "We will provide solution for the first transfer function of the question since each transfer…
Using excess-15 notation, find the decimal equivalent of this binary number 0011101100000000.
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 2 images
- a) Multiply the binary numbers 01001111 (multiplicand) and 00000101 (multiplier) by using the directaddition method. b) in image c)in imageAn eight bit number, 01011101, is: 1)added to 4 2) subtracted from -10 3) ANDED with 15 a) What is the outcome of these operations in binary? b) What is this number in decimal? c) What is the original number in decimal?The binary number 1010 0011 is an ?even or odd? number that has?even or odd? parity?
- 7. Given the following binary number: 1101.0111, what will be its decimal number equivalent?If an 8-bit binary number is used to represent an analog value in the range from 010 to 10010, What does the binary value 010101102 represent?please show work included 4. If a 6-bit binary number is used to represent an analog value in the range from -63 to 126, what is the accuracy of the system? In other words, if the binary number is incremented by one, how much change does it represent in the analog value?
- Add two binary floating-point numbers (1.101101x23)2 and (1.010101x22)2. What is the decimal floating-point number of the result?Discuss how the modern works with the aim of a diagram Compute the decimals values for the following binary digits 11101, 11111, 01010, 10101, 21212 NB. No plagiarismChange this number 09290524 to binary number. Show the stages of the conversion process.
- Determine decimal values of the signed binary numbers expressed in 2’s compliment a. 01010110 b. 10101010 c. 11010111 d. 010010010Draw the Moore and Mealy State Diagram (Binary Sequence Detector): 1011and/or01005-Convert the binary number 1001110010101 to its equivalent octal number 6-Convert the decimal number 652 to hexadecimal